RESUMO
Intertrochanteric fractures in elderly patients can increase mortality due to complications and negative functional results. The aim of this study is to retrospectively compare the follow-up and mortality rates among patients given a proximal femoral nail (PFN), the current routine treatment for these types of fractures, with those given hemiarthroplasty.The study retrospectively investigated 202 patients over the age of 60 who completed at least 3 years of follow-up after hemiarthroplasty or PFN for intertrochanteric fractures between 2007 and 2012. While 132 patients underwent cemented hemiarthroplasty, 70 had PFN.The monitoring duration for those with PFN surgery was 31.25±1.3 months while the duration of follow-up for those with hemiarthroplasty surgery was 20.0±1.2 months. At the end of 3 years of monitoring of the 202 patients, 99 were deceased. There was a statistically significant difference found in terms of patient life expectancy between those with PFN and those with hemiarthroplasty; Cox regression analysis identified that the mortality rate of those with hemiarthroplasty was 5.1 times greater.As a result, patients undergoing hemiarthroplasty should be carefully chosen and if possible, PFN should be preferred.
Assuntos
Artroplastia de Quadril/métodos , Pinos Ortopédicos , Fraturas do Fêmur/cirurgia , Fixação Intramedular de Fraturas/métodos , Hemiartroplastia/métodos , Fraturas do Quadril/cirurgia , Mortalidade , Idoso , Idoso de 80 Anos ou mais , Feminino , Seguimentos , Humanos , Masculino , Pessoa de Meia-Idade , Complicações Pós-Operatórias/epidemiologia , Estudos RetrospectivosRESUMO
INTRODUCTION: The performance of the drilling process depends on the characteristics of the drilling equipment and surgeon's skill. To our knowledge, no research has focused on multi-parameter analysis of the dynamic behaviour of drills during the drilling process. This study aimed to characterise the physical changes and effects of different drills attached to a robotic arm during drilling of artificial bones in a standardised experimental setup. MATERIAL AND METHODS: Drilling processes using three brands of drills attached to a robotic arm were compared in terms of thrust force, vibration, noise level, speed deviation, and temperature. A standardised experimental setup was constructed, and measurement data were analysed statistically. Identical artificial bones were drilled 10 times with each drill. RESULTS: Thrust force measurements, which varied through the cortex and medulla, showed expressive differences for each drill for maximum and mean values (p<0.001). Meaningful differences were obtained for mean vibration values and noise level (p<0.001). Speed variation measurements in drilling showed conspicuous differences with confident statistics (p<0.001). Induced temperature values were measured statistically for Drill 1, Drill 2, and Drill 3 as 78.38±11.49°C, 78.11±7.79°C, and 89.77±7.79°C, respectively. CONCLUSION: Thrust force and drill bit temperature were strongly correlated for each drill. Vibration values and noise level, which also had an influential relationship, were in the acceptable range for all experiments. Both thrust force and speed deviation information could be used to detect the drill bit status in the bone while drilling.