RESUMO
Seat pressure measurements in wheelchair users have been available for some time; however, repeated measurements from a commercially available pressure mat over 90 min did not differ in the pressure-loaded measurement area or the coordinates of the center of pressure, even in participants who were able to reposition themselves in the wheelchair. The question therefore arises: to what extent are there other parameters that reflect the activity of wheelchair users with the pressure mat? To investigate this, a commercial pressure mat (BodiTrak®) was used to perform the measurements of pressure of 33 adult wheelchair-dependent people with spinal cord injury after 30 and 90 min sitting on the cushion. In addition to the standard output of the pressure mat, graph-based surface analyses (calculation of the area of maximum pressure, calculation of the pressure-loaded measurement area, and pressure-area ratio) was performed retrospectively using Python 3.7. The analysis of the measurements after 30 and 90 min was performed by distinguishing the participants between those who could actively change their position (N = 24) and those who could not (N = 9). The parameters of the pressure mat and the graph-based analyses remained unchanged for active participants. In participants who were unable to actively change their position, the area of maximum pressure and the pressure-area ratio (ratio of maximum pressure area and total pressure-loaded area) increased. Significant differences between minutes 30 and 90 are only found for the pressure-area ratio. Thus, when measuring the seat pressure of wheelchair users, the pressure-area ratio should be taken into account as it reflects the daily relief activities of wheelchair users.
Assuntos
Pressão , Postura Sentada , Cadeiras de Rodas , Humanos , Masculino , Feminino , Adulto , Pessoa de Meia-Idade , Traumatismos da Medula Espinal/fisiopatologia , Traumatismos da Medula Espinal/reabilitação , Desenho de EquipamentoRESUMO
The evaluation of local divergence exponent (LDE) has been proposed as a common gait stability measure in people with multiple sclerosis (PwMS). However, differences in methods of determining LDE may lead to different results. Therefore, the purpose of the current study was to determine the effect of different sensor locations and LDE measures on the sensitivity to discriminate PwMS. To accomplish this, 86 PwMS and 30 healthy participants were instructed to complete a six-minute walk wearing inertial sensors attached to the foot, trunk and lumbar spine. Due to possible fatigue effects, the LDE short (~50% of stride) and very short (~5% of stride) were calculated for the remaining first, middle and last 30 strides. The effect of group (PwMS vs. healthy participants) and time (begin, mid, end) and the effect of Expanded Disability Status Scale (EDSS) and time were assessed with linear random intercepts models. We found that perturbations seem to be better compensated in healthy participants on a longer time scale based on trunk movements and on a shorter time scale (almost instantaneously) according to the foot kinematics. Therefore, we suggest to consider both sensor location and time scale of LDE when calculating local gait stability in PwMS.
Assuntos
Esclerose Múltipla , Fenômenos Biomecânicos , Fadiga , Marcha , Humanos , Esclerose Múltipla/diagnóstico , CaminhadaRESUMO
BACKGROUND: Pressure measurements to detect risks for pressure injuries in wheelchair users with spinal cord injury (SCI) have been available for quite some time. Unfortunately, knowledge of how postural changes during longer periods of daily life activity affecting the results is still limited. In the present study, the authors expected to note shifts in the center of pressure as well as in the pressure distribution, especially in patients who were able to change their position actively. METHODS: A seat pressure mat (BodiTrak2) was used to perform measurements of 34 SCI wheelchair users after initial transfer into the wheelchair as well as 30 and 90 minutes later. Mean pressure, maximum pressure, pressure-loaded measuring surface, and the coordinates of the center of pressure were analyzed, and findings were statistically analyzed using the t test and Intraclass Correlation Coefficient. To quantify the drift of the measurement system, recordings with a reference weight were performed. RESULTS: The analyzed parameters from the initial measurement differed significantly from the later measurements at 30 and 90 minutes, whereas the parameters were stable after 30 minutes. The measurements with the reference weight showed the same measurement course. CONCLUSIONS: The measurements after 30 and 90 minutes were consistent, contrary to expectations. The activity of the participant between measurements did not appear to be of much importance. CLINICAL RELEVANCE: Relief maneuvers appear to provide relief only while the maneuver is being performed. Thus, relief activities must be frequent enough and long enough to allow adequate blood flow to the tissues.
RESUMO
A main challenge in human walking is maintaining stability. One strategy to balance the whole body dynamically is to direct the ground reaction forces toward a point above the center of mass, called virtual pivot point (VPP). This strategy could be observed in various experimental studies for human and animal gait. A VPP was also observed when VPP input variables like center of mass or ground reaction forces were perturbed. In this study, the kinetic and kinematic consequences of a center of pressure manipulation and the influence on the VPP are investigated. Thus, eleven participants walked with manipulated center of pressure (i.e. barefoot, backwards, with a rigid sole, with stilts, and in handstand compared to shoe walking). In all conditions a VPP could be observed, only one participant showed no VPP in handstand walking. The vertical VPP position only differs between shoe walking and rigid sole walking, there are no significant differences between the conditions in the horizontal VPP position and the spread around the VPP. However, it is conceivable that for more severe gait changes, walking without VPP could be observed. To further analyze this issue, the authors provide a VPP calculation tool for testing data regarding the existence of the VPP.
Assuntos
Marcha , Caminhada , Humanos , Fenômenos Biomecânicos , Cinética , SapatosRESUMO
Bipedal walking while keeping the upper body upright is a complex task. One strategy to cope with this task is to direct the ground reaction forces toward a point above the centre of mass of the whole body, called virtual pivot point (VPP). This behaviour could be observed in various experimental studies for human and animal walking, but not for the humanoid robot LOLA. The question arose whether humans still show a VPP when walking like LOLA. For this purpose, ten participants imitated LOLA in speed, posture, and mass distribution (LOLA-like walking). It could be found that humans do not differ from LOLA in spatio-temporal parameters for the LOLA-like walking, in contrast to upright walking with preferred speed. Eight of the participants show a VPP in all conditions (R2 > 0.90 ± 0.09), while two participants had no VPP for LOLA-like walking (R2 < 0.52). In the latter case, the horizontal ground reaction forces are not balanced around zero in the single support phase, which is presumably the key variable for the absence of the VPP.
RESUMO
Background: Gait variability in people with multiple sclerosis (PwMS) reflects disease progression or may be used to evaluate treatment response. To date, marker-based camera systems are considered as gold standard to analyze gait impairment in PwMS. These systems might provide reliable data but are limited to a restricted laboratory setting and require knowledge, time, and cost to correctly interpret gait parameters. Inertial mobile sensors might be a user-friendly, environment- and examiner-independent alternative. The purpose of this study was to evaluate the validity of an inertial sensor-based gait analysis system in PwMS compared to a marker-based camera system. Methods: A sample N = 39 PwMS and N = 19 healthy participants were requested to repeatedly walk a defined distance at three different self-selected walking speeds (normal, fast, slow). To measure spatio-temporal gait parameters (i.e., walking speed, stride time, stride length, the duration of the stance and swing phase as well as max toe clearance), an inertial sensor system as well as a marker-based camera system were used simultaneously. Results: All gait parameters highly correlated between both systems (r > 0.84) with low errors. No bias was detected for stride time. Stance time was marginally overestimated (bias = -0.02 ± 0.03 s) and gait speed (bias = 0.03 ± 0.05 m/s), swing time (bias = 0.02 ± 0.02 s), stride length (0.04 ± 0.06 m), and max toe clearance (bias = 1.88 ± 2.35 cm) were slightly underestimated by the inertial sensors. Discussion: The inertial sensor-based system captured appropriately all examined gait parameters in comparison to a gold standard marker-based camera system. Stride time presented an excellent agreement. Furthermore, stride length and velocity presented also low errors. Whereas for stance and swing time, marginally worse results were observed.
RESUMO
The intersection of ground reaction forces near a point above the center of mass has been observed in computer simulation models and human walking experiments. Observed so ubiquitously, the intersection point (IP) is commonly assumed to provide postural stability for bipedal walking. In this study, we challenge this assumption by questioning if walking without an IP is possible. Deriving gaits with a neuromuscular reflex model through multi-stage optimization, we found stable walking patterns that show no signs of the IP-typical intersection of ground reaction forces. The non-IP gaits found are stable and successfully rejected step-down perturbations, which indicates that an IP is not necessary for locomotion robustness or postural stability. A collision-based analysis shows that non-IP gaits feature center of mass (CoM) dynamics with vectors of the CoM velocity and ground reaction force increasingly opposing each other, indicating an increased mechanical cost of transport. Although our computer simulation results have yet to be confirmed through experimental studies, they already indicate that the role of the IP in postural stability should be further investigated. Moreover, our observations on the CoM dynamics and gait efficiency suggest that the IP may have an alternative or additional function that should be considered.
Assuntos
Marcha , Caminhada , Humanos , Simulação por Computador , Fenômenos Biomecânicos , Locomoção , Modelos BiológicosRESUMO
Previous simulation studies investigated the role of reflexes and central pattern generators to explain the kinematic and dynamic adaptations in reaction to step-down perturbations. However, experiments also show preparatory adaptations in humans based on visual anticipation of a perturbation. In this study, we propose a high-level anticipatory strategy augmenting a low-level muscle-reflex control. This strategy directly changes the gain of the reflex control exclusively during the last contact prior to a drop in ground level. Our simulations show that especially the anticipatory reduction of soleus activity and the increase of hamstrings activity result in higher robustness. The best results were obtained when the change in stimulation of the soleus muscle occurred 300 ms after the heel strike of the contralateral leg. This enabled the model to descend perturbation heights up to - 0.21 m and the resulting kinematic and dynamic adaptations are similar to the experimental observations. This proves that the anticipatory strategy observed in experiments has the purpose of increasing robustness. Furthermore, this strategy outperforms other reactive strategies, e.g., pure feedback control or combined feedback and feed-forward control, with maximum perturbation heights of - 0.03 and - 0.07 m, respectively.