Bubble Manipulation Driven by Alternating Current Electrowetting: Oscillation Modes and Surface Detachment.

In this paper, a millimeter-sized bubble in water pending on a substrate is manipulated by applying an alternating current (AC) electric field, known as electrowetting on dielectric. In this setup, standing waves on the bubble surface are observed. The amplitude of these waves varies with frequency, and three resonance peaks (21, 76, and 134 Hz) can be identified. By incorporating the nonlinear friction force for the contact line to an existing surface mode model, a significant improvement to explain the spectrum of the oscillations is obtained, predicting three peak positions, widths, and heights with good accuracy. We also show that bubble detachment correlates with the low-frequency resonance peak. It is found experimentally that if close enough to this peak, then bubbles at sufficiently high voltages are observed to detach from the substrate. This suggests that inertial effects can effectively promote bubble detachment. To confirm this hypothesis, the bubble dynamics is simulated with COMSOL using the full Navier-Stokes equation with a two-phase field and electrostatic stresses. It was found that the bubble experimental detachment process is quite well-reproduced in the simulation, confirming the role of fluid inertia for the detachment process. Given the nice correspondence between the experimental state diagrams and the theoretical modeling, this work contributes to identify a window for precise and reliable bubble manipulation by means of AC electrowetting.

Mold-free self-assembled scalable microlens arrays with ultrasmooth surface and record-high resolution.

Microlens arrays (MLAs) based on the selective wetting have opened new avenues for developing compact and miniaturized imaging and display techniques with ultrahigh resolution beyond the traditional bulky and volumetric optics. However, the selective wetting lenses explored so far have been constrained by the lack of precisely defined pattern for highly controllable wettability contrast, thus limiting the available droplet curvature and numerical aperture, which is a major challenge towards the practical high-performance MLAs. Here we report a mold-free and self-assembly approach of mass-production of scalable MLAs, which can also have ultrasmooth surface, ultrahigh resolution, and the large tuning range of the curvatures. The selective surface modification based on tunable oxygen plasma can facilitate the precise pattern with adjusted chemical contrast, thus creating large-scale microdroplets array with controlled curvature. The numerical aperture of the MLAs can be up to 0.26 and precisely tuned by adjusting the modification intensity or the droplet dose. The fabricated MLAs have high-quality surface with subnanometer roughness and allow for record-high resolution imaging up to equivalently 10,328 ppi, as we demonstrated. This study shows a cost-effective roadmap for mass-production of high-performance MLAs, which may find applications in the rapid proliferating integral imaging industry and high-resolution display.