Determination of the Porosity Distribution during an Erosion Test Using a Coaxial Line Cell.

The detection of porosity changes within a soil matrix caused by internal erosion is beneficial for a better understanding of the mechanisms that induce and maintain the erosion process. In this paper, an electromagnetic approach using Spatial Time Domain Reflectometry (STDR) and a transmission line model is proposed for this purpose. An original experimental setup consisting of a coaxial cell which acts as an electromagnetic waveguide was developed. It is connected to a transmitter/receiver device both measuring the transmitted and corresponding reflected electromagnetic pulses at the cell entrance. A gradient optimization method based on a computational model for simulating the wave propagation in a transmission line is applied in order to reconstruct the spatial distribution of the soil dielectric permittivity along the cell based on the measured signals and an inversion algorithm. The spatial distribution of the soil porosity is deduced from the dielectric permittivity profile by physically based mixing rules. Experiments were carried out with glass bead mixtures of known dielectric permittivity profiles and subsequently known spatial porosity distributions to validate and to optimize both, the proposed computational model and the inversion algorithm. Erosion experiments were carried out and porosity profiles determined with satisfying spatial resolution were obtained. The RMSE between measured and physically determined porosities varied among less than 3% to 6%. The measurement rate is sufficient to be able to capture the transient process of erosion in the experiments presented here.

The structural evolution of undisturbed loess due to water infiltration.

Loess structure is the physical key factor that determines its stability and consists of macro-pores, loose texture, and water sensitivity. The structural change characteristics and effects of the undisturbed loess before and after water infiltration are studied using mechanical CT and simulation tests in order to study the structural change process within the undisturbed loess caused by water infiltration. The change in particle state is as follows: the peak frequency point of the equivalent diameter of the loess particles after infiltration ranged from 16.75 to 23.76 µm, and the eroded fine particles consisted primarily of fine particles. The smaller loess particles are removed by water infiltration resulting in coarsening of soil particles. The sphericity of the loess particles gradually changes from spherical pores to angular and dendritic pores. The particle inclination angle transitions to a range greater than 70°, and its proportion is approximately 61%. The change in pore structure is as follows: The loess porosity after infiltration increased by approximately 20%, and the increase in the pore area ratio of the mesopores and the macropores was higher than that of the micropores. Additionally, the small pores increased by more than 5 times the original state of the undisturbed loess. The connected pores expanded less than 60% of the initial state to more than 90% after infiltration, thus, increasing the dominant seepage channel of the undisturbed loess. These changes in particle and porosity further increase the water filtration intensity and promote the migration of fine particles (mainly silt particles), linking loess catastrophes and are the leading cause of loess settlement and slope instability. The process of water infiltration into the loess, the mechanism of loess collapsibility, and the influence of salinity on the loess structure and strength are discussed in this study.

Insights into the cause of the Oroville dam spillway failure, 2017, California.

Earth internal seepage erosion in weathered bedrock under infrequently used hydraulic structures is often overlooked, which causes some solid particles to break away from the solid skeleton, degrading the earth's strength, and even causing unanticipated hydraulic engineering failures. The flood on the Oroville dam spillway in California in 2017 was caused by disturbed water flow due to a crack in the spillway chute caused by internal erosion in poorly weathered bedrock. The abnormal water flow of the spillway in the early stage and subsequent investigation revealed that the main reason for the accident was the insufficient weathered bedrock under the spillway chute. In this study, we formulated a coupled hydro-mechanical mechanism for internal erosion in weathered bedrock during the early stages. Using this model, we conducted an internal erosion numerical simulation at early stage, and the results showed that the physical characteristics of the weathered bedrock were degraded. Our results show the coupling analysis of quantitative computation during the early stage of internal erosion in weathered bedrock, which can provide an early warning method for the occurrence of internal erosion to avoid hydraulic disasters.