RESUMO
PURPOSE: We aimed to (i) investigate differences in 1-minute sit-to-stand test (1MSTST) performance (i.e., the number of repetitions) between a standardised modality (i.e., starting from a conventional chair with 46 cm seat height) and an individualised modality (i.e., starting with a knee joint flexion angle of 90°), and to (ii) quantify the influence of tibia and femur length on 1MSTST performance. METHODS: Healthy participants were recruited for this randomised crossover study, performing each 1MSTST modality twice in a randomised order. The primary outcome was the number of repetitions in the 1MSTST. Secondary endpoints were the acute responses in peripheral oxygen saturation, heart rate, and leg fatigue and dyspnoea. Additionally, we investigated correlations of performance with knee extensor strength in both modalities. RESULTS: Thirty participants were recruited and completed the study. They achieved significantly less repetitions in the standardised 1MSTST compared to the individualised 1MSTST (B = - 12.1, 95% confidence interval [95% CI] = - 14.8/- 9.4, p < 0.001). We found a significant effect of femur length on 1MSTST performance (B = - 1.6, 95% CI = - 2.6/- 0.7, p = 0.01), tibia length showed significant interaction with the 1MSTST modality (B = 1.2, 95% CI = 0.2/2.2, p = 0.03). CONCLUSION: An individualisation of the 1MSTST starting position to 90° knee flexion angle leads to more repetitions compared to the traditional starting position. The higher repetition count is explained by controlling for differences in tibia length. We recommend individualisation of the 1MSTST, enabling more valid comparisons across populations and study samples. TRIAL REGISTRATION NUMBER: http://www. CLINICALTRIALS: gov , NCT04772417. TRIAL REGISTRATION DATE: February 26, 2021.
Assuntos
Articulação do Joelho , Extremidade Inferior , Humanos , Estudos Cross-Over , Extremidade Inferior/fisiologia , Articulação do Joelho/fisiologiaRESUMO
[Purpose] The purpose of this study was to verify whether Timed Up and Go (TUG) test measurements differed according to the seat height of the chair, presence or absence of armrests, and measurement location in young healthy adults, and to clarify the flexibility of the TUG settings. [Participants and Methods] Fifty-nine young healthy males and females participated in this study. The TUG test was performed under several conditions. Eight measurements were obtained at both the usual walking speed and the individual's fastest walking speed. [Results] There were no significant differences in TUG test measurements according to variation in seat height, different measurement locations, with and without the use of armrests, or at the usual walking speed or the fastest walking speed. [Conclusion] In young healthy adults, TUG test measurements were unaffected by differences in chair height, use of armrests, or the location of the measurement. If TUG measurements are found to differ according to these variables, it is necessary to consider the influence of the individual's ability rather than the measurement method.
RESUMO
'Sit-to-stand' exercise uses the repetitive motion of standing up and sitting down in a chair, a common activity of daily living. A new assessment using an incremental sit-to-stand exercise test employs an external sound to control the speed of standing-up and allows increases in work rate. The aims of the study were to examine the effect of different seat heights on peak oxygen uptake (peak VO2) during an incremental sit-to-stand exercise and to assess any difference between peak VO2 values during incremental sit-to-stand exercise compared with a cycle ergometer test. Thirteen healthy young women (age: 23.1 ± 2.6 years, height: 1.61 ± 0.06 m, body mass: 51.9 ± 7.4 kg·m-2) participated in four incremental sit-to-stand tests with different seat heights and cycle tests in random order. The seat heights were adjusted to 100%, 80%, 120%, and 140% of knee height distance (100%, 80%, 120%, and 140% incremental sit-to-stand exercise, respectively). The peak VO2 and completion time were measured during incremental sit-to-stand and cycle ergometer tests, and repeated-measures analysis of variance and Student's paired t-test with Holm's method were used to evaluate differences between these variables. The peak VO2 values increased by about 10-12 mL·min-1·kg-1 as the seat height on the ISTS decreased over a 60% range of lower leg lengths. The peak VO2 values on the 80%, 100%, 120%, and 140% incremental sit-to-stand tests were about 11%, 25%, 40%, and 50% lower than that on the cycle ergometer test, respectively. The peak VO2 on the incremental sit-to-stand test increased as seat height decreased. These findings are useful to determine which seat height on the incremental sit-to-stand tests test is suitable for different populations.
RESUMO
This study investigated the effects of seat-height settings of wheelchairs with alternating propulsion with both legs. Seven healthy individuals with no orthopedic disease participated. Flexion angles at initial contact (FA-IC) of each joint, range of motion during propulsion period (ROM-PP), and ground reaction force (GRF) were measured using a three dimensional motion capture system and force plates, and compared with different seat-height settings. Statistically significant relationships were found between seat-height and speed, stride length, knee FA-IC, ankle FA-IC, hip ROM-PP, vertical ground reaction force (VGRF), and anterior posterior ground reaction force (APGRF). Speed, hip ROM-PP, VGRF and APGRF increased as the seat-height was lowered. This effect diminished when the seat-height was set below -40 mm. VGRF increased as the seat-height was lowered. The results suggest that the seat-height effect can be attributed to hip ROM-PP; therefore, optimal foot propulsion cannot be achieved when the seat height is set either too high or too low. Efficient foot propulsion of the wheelchair can be achieved by setting the seat height to lower leg length according to a combination of physical characteristics, such as the user's physical functions, leg muscles, and range of motion.
Assuntos
Extremidade Inferior/fisiologia , Movimento/fisiologia , Reabilitação/instrumentação , Cadeiras de Rodas , Adulto , Desenho de Equipamento , Feminino , Marcha , Humanos , MasculinoRESUMO
General principles derived from anatomical studies of human body sizes should be applied to chair designs. Chairs can be designed for a specific user or a particular group of users. Universal chairs for public spaces should be comfortable for the largest possible group of users and should not be adjustable, such as office chairs. However, the fundamental problem is that the anthropometric data available in the literature either come from many years ago and are out of date or do not provide a complete set of all the dimensional parameters of a sitting human body position. This article proposes a way to design chair dimensions solely based on the height range of the intended chair users. For this purpose, based on literature data, the main structural dimensions of the chair were assigned to the appropriate anthropometric body measurements. Furthermore, calculated average body proportions for the adult population overcome the incompleteness, outdated and burdensome access to anthropometric data and link the main chair design dimensions to one easily accessible anthropometric parameter: human height. This is achieved by seven equations describing the dimensional relations between the chair's essential design dimensions and human height or even a height range. The result of the study is a method of determining the optimal functional dimensions of a chair for a chosen range of sizes of its future users based only on users' height range. Limitations of the presented method: the calculated body proportions are correct only for people with a standard body proportion characteristic of adults, i.e., they exclude children and adolescents up to 20 years of age, seniors, and people with a body mass index exceeding 30.
RESUMO
Sit-to-stand (STS) movements from low seat height are not easily executed by older individuals. Although young individuals increase their lower limb muscle power (LLMP) based on the product of the ground reaction force (GRF) and center of mass velocity (CoMv) during STS movement from a low seat height, it remains unclear whether seat height has an effect on LLMP during STS movement in older individuals. The present study aimed to investigate differences in the LLMP during STS movements when seat height is lowered between young and older individuals. Twelve older and twelve height-matched young individuals were instructed to perform STS movements from low (20 cm), middle (40 cm), and high (60 cm) seat heights. STS movement and GRF were obtained by a motion analysis system and force plates. In the low-seat-height condition, the forward and upward LLMPs and the upward CoMv were significantly lower in older individuals than those in young individuals, but the forward CoMv was not. The completion time of STS movement from a low seat height was significantly longer in older individuals than in young individuals. Our findings suggest that the slower upward CoMv due to the lower upward LLMP extends the completion time of STS movement from a low seat height in older individuals. Furthermore, in the low-seat-height condition, older individuals may move their center of mass (CoM) forward in a different way when compared with young individuals, and they may not use forward LLMP for moving CoM forward.
Assuntos
Movimento , Postura , Idoso , Fenômenos Biomecânicos , Humanos , Extremidade Inferior , MúsculosRESUMO
BACKGROUND: The use of school furniture with a height that is anthropometrically mismatched can lead children into taking awkward postures while sitting. In Korea, desks and chairs for primary schools have seven different height levels, and these levels are regulated by the national standard KSG-2010. These levels serve to accommodate children of all heights, but the choice problem remains because of the many alternatives. OBJECTIVE: This study evaluates the anthropometric feasibility of the currently used guidelines for the selection of height level for Korean primary school furniture. In addition, we examine children's ability to select anthropometrically recommendable desk and seat heights. METHODS: In study 1, anthropometric data from 2005 Korean children were acquired and a mismatch analysis was performed under the assumption that children were paired with the height level recommended by the guidelines. In study 2, we conducted a desk and seat height selection experiment that included 36 children. RESULTS: The results of study 1 revealed that about three quarters of children could be matched by following the guidelines. The results of study 2 showed that a quarter of children selected matchable desk and seat heights by themselves. We developed new guidelines using classification algorithms based on the employed data in study 1, and it was confirmed that the new guidelines could significantly increase the degree of match. CONCLUSION: This study confirmed that the currently used guidelines need to be revised and that children had difficulty in selecting the appropriate height of school furniture by themselves. The new guidelines suggested in this study are expected to contribute to the correct usage by Korean primary school children.
Assuntos
Antropometria , Comportamento de Escolha , Ergonomia , Guias como Assunto , Decoração de Interiores e Mobiliário , Instituições Acadêmicas , Estudantes/psicologia , Algoritmos , Criança , Estudos de Viabilidade , Feminino , Humanos , Masculino , Postura , República da CoreiaRESUMO
The aim of this study was to measure and analyse discomfort and biomechanics of cycling, i.e., muscle activation, centre of pressure of seat pressure profiles and pedal forces as a function of seat position. Twenty-one recreationally active individuals cycled for 10min at 100W on an ergometer cycle using five different seat positions. The neutral position was considered as basic seat position and was compared with upward, downward, forward and backward seat positions. The initial bout was repeated at the end of the recording session. Discomfort increased for upward and backward condition compared with neutral (P<0.05). Normalized surface electromyography from gastrocnemius decreased in the downward and forward position but increased in the upward and backward position. The minimum force became less negative for forward position compared with neutral seat position (P<0.05). The degree of variability of centre of pressure increased in the upward and backward position and the entropy of the centre of pressure of sitting posture for backward position decreased compared with neutral seat position (P<0.05). The present study revealed that consecutive changes of seat position over time lead to increase in discomfort as well as alterations of the biomechanics of cycling.
Assuntos
Ciclismo/fisiologia , Teste de Esforço/métodos , Músculo Esquelético/fisiologia , Postura/fisiologia , Pressão , Adulto , Fenômenos Biomecânicos/fisiologia , Eletromiografia/métodos , Feminino , Pé/fisiologia , Humanos , Masculino , Método Simples-Cego , Adulto JovemRESUMO
INTRODUCTION: Sit-to-walk (STW) is a common transitional motor task not usually included in rehabilitation. Typically, sit-to-stand (STS), pause, then gait initiation (GI) before walking is used, which we term sit-to-stand-and-walk (STSW). Separation between centre-of-pressure (COP) and whole-body centre-of-mass (BCOM) during GI is associated with dynamic postural stability. Rising from seats higher than knee-height (KH) is more achievable for patients, but whether this and/or lead-limb significantly affects task dynamics is unclear. This study tested whether rising from seat-heights and lead-limb affects STW and STSW task dynamics in young healthy individuals. METHODS: Ten (5F) young (29±7.7 years) participants performed STW and STSW from a standardised position. Five trials of each task were completed at 100 and 120%KH leading with dominant and non-dominant legs. Four force-plates and optical motion capture delineated key movement events and phases with effect of seat-height and lead-limb determined by 2-way ANOVA within tasks. RESULTS: At 120%KH, lower peak vertical ground-reaction-forces (vGRFs) and vertical BCOM velocities were observed during rising irrespective of lead-limb. No other parameters differed between seat-heights or lead-limbs. During GI in STSW there was more lateral, and less posterior, COP excursion than expected. CONCLUSION: Reduction in vGRFs and velocity during rising at 120%KH is consistent with reduced effort in young healthy individuals and is likely therefore to be an appropriate seat-height for patients. Lead-limb had no effect upon STSW or STW parameters suggesting that normative data independent of lead-limb can be utilised to monitor motor rehabilitation should differences be observed in patients. STSW should be considered an independent movement transition.