Biomechanical analysis in mandibular advancement and occlusal plane rotation with finite element analysis.

ABSTRACT

We used finite element analysis to assess stress on the cortical bone and plate fixation system, as well as mandibular resistance after sagittal split ramus osteotomy with different mandibular advancements and rotations of the occlusal plane. Three-dimensional mandibular models were obtained, and 6mm and 12mm advancements were planned associated with linear, clockwise, and counter-clockwise rotation of the angle of the occlusal plane. Each model was then fixed with one or two 2.0mm system plates and secured with four monocortical screws. A total of 12 models were built and subjected to a vertical load in the lower central incisor ranging from 50N to 500N in 50N increments. Results showed that the 12mm advancement was associated with higher stress on the bone and plate surface. Additionally, the models fixed with two plates exhibited lower plate stress than those fixed with a single plate. Counter-clockwise rotation of the angle of the mandibular plane in the 6mm advancement caused more plate stress, which did not occur in the 12mm advancement. This analysis has shown that change in the occlusal plane in large mandibular advancements does not act as an additional stress factor. These findings can help to better understand the tensions on bone and plate surfaces in patients who need large mandibular advancements that are associated with a change in the occlusal plane, and will aid better surgical planning.