Thermodynamic Investigation and Mixed Ligand Complex Formation of 1,4-Bis-(3-aminopropyl)-piperazine and Biorelevant Ligands.

Thermodynamic parameters for protonation of 1,4-bis(3-aminopropyl)-piperazine (BAPP) and its metal complexation with some divalent metal ions were determined in aqueous solution at constant ionic strength (0.1 M NaNO(3)) using a potentiometric technique. The order of -ΔG(0) and -ΔH(0) was found to obey Co(2+) < Ni(2+) < Cu(2+) > Zn(2+), in accordance with the Irving-Williams order. The formation equilibria of zinc (II) complexes and the ternary complexes Zn(BAPP)L, where L = amino acid, amides, or DNA constituents), have been investigated. Ternary complexes are formed by a simultaneous mechanism. The concentration distribution of the complexes in solution was evaluated as a function of pH. Stoichiometry and stability constants for the complexes formed are reported and discussed. The stability of ternary complexes was quantitatively compared with their corresponding binary complexes in terms of the parameter Δlog K.

Developing the sensing features of copper electrodes as an environmental friendly detection tool for chemical oxygen demand.

The chemical oxygen demand (COD) of water bodies is an essential indicator of organic contaminants. The majority of current testing methods have the drawbacks of requiring multiple processes, being time-consuming, and requiring the use of harmful and hazardous reagents. In this work, a low-cost copper wire (Cu-wire) electrode was designed and fabricated to be used as a sensing electrode for the detection of chemical oxygen demand in water. The sensing features were developed by electrodeposition of copper nanoparticles (nano-Cu) that were prepared by fast-scan cyclic voltammetry (FSCV) deposition at the optimum preparation conditions. For improving the adherence and stability of the deposited nano-Cu thin layer, the Cu-wire electrode was scratched to increase the surface roughness. The surface morphology of the prepared nano-Cu/Cu-wire electrode was investigated by scanning electron microscope (SEM). Energy-dispersive X-ray spectrometer (EDX) was used for elemental analysis characterization. The non-modified and the nano-copper modified electrode were utilized and optimized for electrochemical assay of COD using glycine as a standard in 0.075 M NaOH as an electrolyte solution. The calibration curves (COD, mg L-1 vs. I, mA) were plotted from linear sweep voltammetry (LSV) and chronoamperometry (I-t) curves for a wide range of COD under the optimized conditions. It shows that the electroanalytical features of the proposed nano-Cu-based COD sensor exhibit a linear range from 2 to 595 mg L-1 and a lower limit of detection (LOD) of 2.6 mg L-1 (S/N = 3). The established electrochemical method demonstrated a high tolerance level to Cl- ions where 1.0 M Cl- exhibited a negligible influence. The sensor was employed for detecting the COD in diverse real water samples and the attained results were validated using the standard dichromate method. The obtained results could open the window toward using simple and cost effective tools in order to monitor the water quality.

Hazardous inorganic disinfection by-products in Egypt's tap drinking water: Occurrence and human health risks assessment studies.

This study is the first that monitored the presence and levels of chlorite, chlorate and bromate in tap drinking water of Egypt. Three hundred and eight samples were collected from 22 governorates across Egypt and were analyzed using a standardized ion chromatography method. Forty-seven samples were contaminated by one or more of the inorganic disinfection by-products (DBPs) and only 12 samples exceeded the admissible maximum contamination levels (MCLs). The ratio of samples detected, and exceeding the MCLs were low relative to the global literature. Chlorate was the most prevalent inorganic DBPs (40 samples; concentration <12-4082 µg/L) followed by bromate (12 samples; concentration <3-626 µg/L) then chlorite (5 samples; concentration <12-123 µg/L). Chlorite was always below the MCL and had no human health risk even for the worst-case scenario. Bromate is a real challenge as it poses a significant cancer risk even for the median concentrations. None of the inorganic DBPs was detected in the tap drinking water of Beheira, Cairo, Gharbia, Giza, Kafr El Sheikh, Luxor, Monufia, and Suez governorates. This study manifested the importance of routine monitoring, and implementing counter measures to control the levels of the hazardous inorganic DBPs in tap drinking water.

Protonation equilibria of biologically active ligands in mixed aqueous organic solvents.

The review is mainly concerned with the protonation equilibria of biologically active ligands like amino acids, peptides, DNA constituents, and amino acid esters in nonaqueous media. Equilibrium concentrations of proton-ligand formation as a function of pH were investigated. Also, thermodynamics associated with protonation equilibria were also discussed.

Synthesis, characterization, equilibrium study and biological activity of Cu(II), Ni(II) and Co(II) complexes of polydentate Schiff base ligand.

Schiff base ligand, 1,4-bis[(2-hydroxybenzaldehyde)propyl]piperazine (BHPP), and its Cu(II), Ni(II) and Co(II) metal complexes were synthesized and characterized by elemental analysis, magnetic susceptibility, molar conductance and spectral (IR and UV-vis) studies. The ground state of BHPP ligand was investigated using the BUILDER module of MOE. Metal complexes are formed in the 1:1 (M:L) ratio as found from the elemental analysis and found to have the general formula [ML]·nH(2)O, where M=Co(II), Ni(II) and Cu(II), L=BHPP. In all the studied complexes, the (BHPP) ligand behaves as a hexadentate divalent anion with coordination involving the two azomethine nitrogen's, the two nitrogen atoms of piperazine ring and the two deprotonated phenolic OH-groups. The magnetic and spectral data indicates octahedral geometry of metal(II) complexes. The ligand and their metal chelates have been screened for their antimicrobial activities using the disc diffusion method against the selected bacteria and fungi. They were found to be more active against Gram-positive than Gram-negative bacteria. Protonation constants of (BHPP) ligand and stability constants of its Cu(2+), Co(2+) and Ni(2+) complexes were determined by potentiometric titration method in 50% DMSO-water solution at ionic strength of 0.1 M sodium nitrate. It has been observed that the protonated Schiff base ligand (BHPP) have four protonation constants. The divalent metal ions Cu(2+), Ni(2+) and Co(2+) form 1:1 complexes.