Experimental validation of numerical simulations on a cerebral aneurysm phantom model.

The treatment of cerebral aneurysms, found in roughly 5% of the population and associated in case of rupture to a high mortality rate, is a major challenge for neurosurgery and neuroradiology due to the complexity of the intervention and to the resulting, high hazard ratio. Improvements are possible but require a better understanding of the associated, unsteady blood flow patterns in complex 3D geometries. It would be very useful to carry out such studies using suitable numerical models, if it is proven that they reproduce accurately enough the real conditions. This validation step is classically based on comparisons with measured data. Since in vivo measurements are extremely difficult and therefore of limited accuracy, complementary model-based investigations considering realistic configurations are essential. In the present study, simulations based on computational fluid dynamics (CFD) have been compared with in situ, laser-Doppler velocimetry (LDV) measurements in the phantom model of a cerebral aneurysm. The employed 1:1 model is made from transparent silicone. A liquid mixture composed of water, glycerin, xanthan gum and sodium chloride has been specifically adapted for the present investigation. It shows physical flow properties similar to real blood and leads to a refraction index perfectly matched to that of the silicone model, allowing accurate optical measurements of the flow velocity. For both experiments and simulations, complex pulsatile flow waveforms and flow rates were accounted for. This finally allows a direct, quantitative comparison between measurements and simulations. In this manner, the accuracy of the employed computational model can be checked.

Experimental characterization of flow conditions in 2- and 20-L bioreactors with wave-induced motion.

Quantifying the influence of flow conditions on cell viability is essential for a successful control of cell growth and cell damage in major biotechnological applications, such as in recombinant protein and antibody production or vaccine manufacturing. In the last decade, new bioreactor types have been developed. In particular, bioreactors with wave-induced motion show interesting properties (e.g., disposable bags suitable for cGMP manufacturing, no requirement for cleaning and sterilization of cultivation vessels, and fast setup of new production lines) and are considered in this study. As an additional advantage, it is expected that cultivations in such bioreactors result in lower shear stress compared with conventional stirred tanks. As a consequence, cell damage would be reduced as cell viability is highly sensitive to hydrodynamic conditions. To check these assumptions, an experimental setup was developed to measure the most important flow parameters (liquid surface level, liquid velocity, and liquid and wall shear stress) in two cellbag sizes (2 and 20 L) of Wave Bioreactors®. The measurements confirm in particular low shear stress values in both cellbags, indicating favorable hydrodynamic conditions for cell cultivation.