Prediction of retention for sulfonamides in supercritical fluid chromatography.

Properties-retention studies were undertaken on a test library of sulfonamides using supercritical fluid chromatography with CO(2)-MeOH mobile phases (in the presence or absence of additive) and a 2-ethyl-pyridyl column. Taking a restricted range of retention ratios, k (10.98). From these relationships, the different retention characteristics of the analytes were calculated. Literature studies of quantitative structure-retention relationships (QSRR) showed that these characteristics can be correlated with simple molecular descriptors to derive equations predicting the retention behaviour of new compounds. Measured retention characteristics were found to correlate with total dipole moment, mu, molecular surface area, A, and the electronic charge on the most negatively charged atom, delta(min). The correlation of chromatographic measurements with calculated molecular descriptors may allow the prediction of the retention behaviour for an unknown compound provided its properties are known.

Ultra-fast LC-MS/MS in therapeutic drug monitoring: Quantification of clozapine and norclozapine in human plasma.

A novel approach to high-throughput, targeted liquid chromatography-tandem mass spectrometry (LC-MS/MS) analysis has been developed. A single chromatographic system can be used for the analysis of a range of 20 drugs and metabolites with a total analysis time of 36 s (one 96-well plate of prepared samples per hour). To demonstrate the applicability of this approach to quantitative analysis, a method has been validated for the therapeutic drug monitoring of clozapine and norclozapine following automated extraction from human plasma. Chromatographic retention times were 11.4 and 12.4 s for norclozapine and clozapine, respectively (for both analytes the chromatographic peak width was less than 1 s). Comparison with a conventional LC-MS/MS method (5 min analysis time) showed excellent agreement. This new approach offers analysis times more akin to flow-injection analysis, but is likely to be more widely applicable because of chromatographic resolution from residual matrix components and isobaric interferences.

Performance of charged aerosol detection with hydrophilic interaction chromatography.

The performance of the charged aerosol detector (CAD) was investigated using a diverse set of 29 solutes, including acids, bases and neutrals, over a range of mobile phase compositions, particularly with regard to its suitability for use in hydrophilic interaction chromatography (HILIC). Flow injection analysis was employed as a rapid method to study detector performance. CAD response was 'quasi-universal', strong signals were observed for compounds that have low volatility at typical operating (room) temperature. For relatively involatile solutes, response was reasonably independent of solute chemistry, giving variation of 12-18% RSD from buffered 95% ACN (HILIC) to 10% ACN (RP). Somewhat higher response was obtained for basic compared with neutral solutes. For cationic basic solutes, use of anionic reagents of increasing size in the mobile phase (formic, trifluoroacetic and heptafluorobutyric acid) produced somewhat increased detector response, suggesting that salt formation with these reagents is contributory. However, the increase was not stoichiometric, pointing to a complex mechanism. In general, CAD response increased as the concentration of acetonitrile in the mobile phase was increased from highly aqueous (10% ACN) to values typical in the HILIC range (80-95% ACN), with signal to noise ratios about four times higher than those for the RP range. The response of the CAD is non-linear. Equations describing aerosol formation cannot entirely explain the shape of the plots. Limits of detection (determined with a column for solutes of low k) under HILIC conditions were of the order of 1-3ng on column, which compares favourably with other universal detectors. CAD response to inorganic anions allows observation of the independent movement through the column of the cationic and anionic constituents of basic drugs, which appear to be accompanied by mobile phase counterions, even at quite high solute concentrations.

Investigations into the Manzamine Alkaloid Biosynthetic Hypothesis.

The biomimetic synthesis of a pentacyclic alkaloid (keramaphidin B, 1), an intermediate in the biogenetic pathway to the manzamine alkaloids, has been achieved. Compound 1 was formed by an intramolecular Diels-Alder reaction of macrocycle 2 in buffer followed by reduction with NaBH4 . This reaction provides the first direct expeimental evidence for the authors' biosynthetic hypothesis.

Comparison of peak shape in hydrophilic interaction chromatography using acidic salt buffers and simple acid solutions.

The retention and peak shape of neutral, basic and acidic solutes was studied on hydrophilic interaction chromatography (HILIC) stationary phases that showed both strong and weak ionic retention characteristics, using aqueous-acetonitrile mobile phases containing either formic acid (FA), ammonium formate (AF) or phosphoric acid (PA). The effect of organic solvent concentration on the results was also studied. Peak shape was good for neutrals under most mobile phase conditions. However, peak shapes for ionised solutes, particularly for basic compounds, were considerably worse in FA than AF. Even neutral compounds showed deterioration in performance with FA when the mobile phase water concentration was reduced. The poor performance in FA cannot be entirely attributed to the negative impact of ionic retention on ionised silanols on the underlying silica base materials, as results using PA at lower pH (where their ionisation is suppressed) were inferior to those in AF. Besides the moderating influence of the salt cation on ionic retention, it is likely that salt buffers improve peak shape due to the increased ionic strength of the mobile phase and its impact on the formation of the water layer on the column surface.

Effect of increasing concentration of ammonium acetate as an additive in supercritical fluid chromatography using CO2-methanol mobile phase.

The effects of increasing concentrations of ammonium acetate additive in supercritical fluid chromatography were studied on silica, 2-ethyl-pyridine and endcapped 2-ethyl-pyridine stationary phases. The study involved the addition of increasing concentrations of the ammonium acetate either in the mobile phase modifier (methanol) or in the sample solvent. The effects of ammonium acetate on retention and peak shape of the analytes were evaluated. Compounds that exhibited satisfactory chromatographic behaviour in the absence of the additive were virtually unaffected by its presence in the mobile phase or sample solvent. Nevertheless, compounds that exhibited late elution and strongly tailing peak shapes when pure methanol was used showed dramatically improved chromatographic behaviour in the presence of the additive. Shorter retention was observed not only when the modifier was introduced in the mobile phase but also when it was in the sample solvent.

Ionisation in the absence of high voltage using supercritical fluid chromatography: a possible route to increased signal.

Supercritical fluid chromatography (SFC) is fast becoming a technique of choice for the analysis of a wide range of compounds and has been found to be complementary to high-performance liquid chromatography (HPLC). The combination of SFC and mass spectrometry (MS) affords a very useful tool in the separation and analysis of compounds. In this study the ionisation of samples in the absence of an applied electrospray voltage has been observed when using SFC/MS, with some compounds showing increased sensitivity when all ionisation source high voltage (HV) is removed. In an attempt to understand the mechanism of ionisation, a series of test compounds were analysed using standard electrospray ionisation (ESI) and atmospheric pressure chemical ionisation (APCI) source configurations and also different API source designs. In both cases, data were acquired with the applied high voltage on (normal conditions) or with the high voltage off, i.e. no voltage spray (novo-spray). The standards were analysed with a range of pressure and modifier percentage conditions. To understand the nature of the ionisation process observed, this was compared with three established liquid-to-gas ionisation mechanisms. These were thermospray (TSP), charge residue model (CRM) of ESI and sonic spray ionisation (SSI). Experiments were undertaken in an attempt to explain this ionisation phenomenon and quantify any observed change in sensitivity. The most important point to note is that enhanced ionisation was observed under novo-spray conditions in a SFC/MS configuration, which in certain cases provides a lowering in the overall limit of detection (LOD).