Experimental characterization of a commercial TEG device under mimicked operating conditions.

A long-standingzT= 1 barrier is still present in commercial thermoelectric generator devices (TEG) and is typically not overcome. Although it is possible to accept the current limits of such devices, the performances reported on the datasheets are frequently not obtainable when these thermoelectric devices are arranged for use in the actual operating conditions. Despite this, the current primary energy prices and ongoing climate change make their use attractive for many industrial sectors. An experimental investigation is here proposed on a single type of TEG available on the market; the temperature relationships of the electrical resistivity, Seebeck coefficient, and thermal conductivity in a thermostatic chamber were first determined. A piece of apparatus was assembled to mimic the operating conditions of the TEG device and verify its performance, but some critical issues were highlighted regarding the heat transfer and its ability to maintain an adequate contact pressure on the hot and cold sides of the module. In order to extend the recovery of waste heat to a non-excessively high temperature in the hot forging process, the maximum temperature attained on the hot side of the TEG in the performed experiments was not allowed to exceed 180 °C. With temperatures of around 160 °C on the hot side and just over 40 °C on the cold side, the conversion efficiency was close to 3%. Considering this conversion efficiency and the operating conditions, the estimated order of magnitude of the electricity that could be produced by recovering heat waste in the Italian hot forging sector could be in the region of some hundreds of MWh per year.

Experimental Investigation on Thermal Conductivity and Thermal Diffusivity of Ex-Vivo Bovine Liver from Room Temperature down to -60 °C.

Ex vivo animal tissues (e.g., bovine liver) as well as water-agar gel are commonly used to simulate both experimentally and numerically the response of human tissues to cryoablation treatments. Data on the low temperature thermal properties of bovine liver are difficult to find in the literature and very often are not provided for the whole temperature range of interest. This article presents the thermal conductivity and thermal diffusivity measurements performed on ex-vivo bovine liver samples using the transient plane source method. Regression coefficients are provided to determine these properties in different temperature ranges except for the phase transition during which no results were obtained, which suggests an ad hoc calorimetric analysis. A quick procedure is also suggested to determine the water mass fraction in the tissue. Moreover, an attempt to estimate the liver density in the frozen state using measurements performed solely at room temperature is also presented. The measured thermal conductivity and thermal diffusivity values are compared with data reported in literature highlighting a spread up to 40%. Moreover, it emerges that water-agar gel usually made with 2% by weight of agar does not show the same thermal properties as the bovine liver.

Calorimetric analysis of ice onset temperature during cryoablation: a model approach to identify early predictors of effective applications.

Aim of the present study is to analyze thermal events occurring during cryoablation. Different bovine liver samples underwent freezing cycles at different cooling rate (from 0.0075 to 25 K/min). Ice onset temperature and specific latent heat capacity of the ice formation process were measured according to differential scanning calorimetry signals. A computational model of the thermal events occurring during cryoablation was compiled using Neumann's analytical solution. Latent heat (#1 = 139.8 ± 7.4 J/g, #2 = 147.8 ± 7.9 J/g, #3 = 159.0 ± 4.1 J/g) of all liver samples was independent of the ice onset temperature, but linearly dependent on the water content. Ice onset temperature was proportional to the logarithm of the cooling rate in the range 5 ÷ 25 K/min (#3a = - 12.2 °C, #3b = - 16.2 °C, #3c = - 6.6 °C at 5K/min; #3a = - 16.5 °C, #3b = - 19.3 °C, #3c = - 11.6 °C at 25 K/min). Ice onset temperature was associated with both the way in which the heat involved into the phase transition was delivered and with the thermal gradient inside the tissue. Ice onset temperature should be evaluated in the early phase of the ablation to tailor cryoenergy delivery. In order to obtain low ice trigger temperatures and consequent low ablation temperatures a high cooling rate is necessary.

Surface-immobilized pyridine-functionalized gamma-cyclodextrin: alkanethiol co-adsorption-induced reorientation.

Monolayers of di-6A,6B-deoxy-6-(4-pyridylmethyl)amino-gamma-cyclodextrin (gamma-CD-(py)2) have been formed on polycrystalline platinum electrodes and investigated using electrochemical and surface-enhanced Raman spectroscopy (SERS). The behavior of self-assembled monolayers of (gamma-CD-(py)2) alone, (gamma-CD-(py)2) backfilled with 1-nonanethiol, and 1-nonanethiol are reported. The potential dependence of the capacitance indicates that the film capacitance is higher for the backfilled CD layers than for 1-nonanethiol layers, most likely due to ion flux through the CD cavity. SERS spectra of the backfilled layer exhibit features associated with both pyridine-functionalized CD and alkane moieties. Investigations using [Fe(CN)6]4- as a solution-phase probe indicate that the backfilled CD-alkane thiol layer exhibits enhanced blocking properties compared to gamma-CD-(py)2 films alone. Complete blocking was achieved by a combination of backfilling and insertion of a high-affinity guest 1-adamantylamine into the cavity. Significantly, an electroactive guest with high affinity for gamma-CD, [Co(biptpy)2]2+, does not exhibit a redox response at the gamma-CD-(py)2 layer but molecular recognition is turned on by backfilling the CD layer with 1-nonanethiol molecules. This switching on of the electrochemical activity suggests that the CD hosts are initially inaccessible but reorientate upon backfilling, exposing the CD opening to solution and permitting a supramolecular host-guest complex to form. The binding of [Co(biptpy)2]2+ to gamma-CD in the backfilled monolayer depends on the bulk concentration of guest and is modeled by the Langmuir isotherm, yielding an association constant for the Co2+ state of 1.45 +/- 0.46 x 105 M-1 and a limiting surface coverage 1.49 +/- 0.25 x 10-11 mol cm-2. The surface coverage of the divalent state is higher than the trivalent state, reflecting the dynamic nature of the inclusion.