Charged polystyrene microplastics inhibit uptake and transformation of 14C-triclosan in hydroponics-cabbage system.

INTRODUCTION: Since the outbreak of COVID-19, microplastics (MPs) and triclosan in pharmaceuticals and personal care products (PPCPs) are markedly rising. MPs and triclosan are co-present in the environment, but their interactions and subsequent implications on the fate of triclosan in plants are not well understood. OBJECTIVE: This study aimed to investigate effects of charged polystyrene microplastics (PS-MPs) on the fate of triclosan in cabbage plants under a hydroponic system. METHODS: 14C-labeling method and liquid chromatography coupled with quadrupole/time-of-flight mass spectrometry (LC-QTOF-MS) analysis were applied to clarify the bioaccumulation, distribution, and metabolism of triclosan in hydroponics-cabbage system. The distribution of differentially charged PS-MPs in cabbage was investigated by confocal laser scanning microscopy and scanning electron microscopy. RESULTS: The results showed that MPs had a significant impact on bioaccumulation and metabolism of triclosan in hydroponics-cabbage system. PS-COO-, PS, and PS-NH3+ MPs decreased the bioaccumulation of triclosan in cabbage by 69.1 %, 81.5 %, and 87.7 %, respectively, in comparison with the non-MP treatment (control). PS-MPs also reduced the translocation of triclosan from the roots to the shoots in cabbage, with a reduction rate of 15.6 %, 28.3 %, and 65.8 % for PS-COO-, PS, and PS-NH3+, respectively. In addition, PS-NH3+ profoundly inhibited the triclosan metabolism pathways such as sulfonation, nitration, and nitrosation in the hydroponics-cabbage system. The above findings might be linked to strong adsorption between PS-NH3+ and triclosan, and PS-NH3+ may also potentially inhibit the growth of cabbage. Specially, the amount of triclosan adsorbed on PS-NH3+ was significantly greater than that on PS and PS-COO-. The cabbage biomass was reduced by 76.9 % in PS-NH3+ groups, in comparison with the control. CONCLUSION: The uptake and transformation of triclosan in hydroponics-cabbage system were significantly inhibited by charged PS-MPs, especially PS-NH3+. This provides new insights into the fate of triclosan and other PPCPs coexisted with microplastics for potential risk assessments.

Desulfovibrio-induced gauzy FeS for efficient hexavalent chromium removal: The influence of SRB metabolism regulated by carbon source and electron carriers.

Biosynthetic metal sulfides showed great application prospects in the environmental treatment against high-valence metal pollutants. However, the efficiency of biosynthesis, agglomeration during the reaction process, and the formation of the passivation layer during the reduction process were always the important factors restricting its development. This study explored the composition of the culture medium to promote the growth of highly corrosive sulfate-reducing bacteria (SRB) and its metabolism to produce FeS nanoparticles (NPs). The results showed that reducing the carbon source (CS) and adding electron carriers in the culture medium effectively promoted the production of small, dispersed, and loose FeS NPs in cells. At pH = 7, 24 °C and 10 min reaction time, 0.1 g/L FeS NPs produced by SRB under the conditions of 10 % CS with 10 ppm cytochrome c medium could achieve 100 % removal efficiency of 1 mM hexavalent chromium (Cr(VI)). Under this condition, FeS NPs could be produced by intracellular metabolism in SRB cells, and environmental factors such as pH, metal cations, and Cl- had little effect on the removal of Cr(VI) by this FeS NPs. The surface proteins of FeS NPs significantly enhanced their antioxidant properties. After 7 days of natural environment exposure, the Cr(VI) removal efficiency of FeS NPs was only reduced by 16 % compared with the initial sample. This work provided an in-depth understanding of Cr(VI) removal by SRB biosynthesis of FeS and contributes to the widespread application of FeS in the future.

Effects of reduced graphene oxide nanomaterials on transformation of 14C-triclosan in soils.

Increasing use and release of graphene nanomaterials and pharmaceutical and personal care products (PPCPs) in soil environment have polluted the environment and posed high ecological risks. However, little is understood about the interactive effects and mechanism of graphene on the behaviors of PPCPs in soil. In the present study, the effects of reduced graphene oxide nanomaterials (RGO) on the fate of triclosan in two typical soils (S1: silty loam; S2: silty clay loam) were investigated with 14C-triclosan, high-resolution mass spectrometry, scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS), density functional theory (DFT) calculations, and microbial community structure analysis. The results showed that RGO prolonged the half-life of triclosan by 23.6-51.3 %, but delayed the formation of transformed products such as methyl triclosan and dechlorinated dimer of triclosan in the two typical soils. Mineralization of triclosan to 14CO2 was inhibited by 48.2-79.3 % in 500 mg kg-1 RGO in comparison with that in the control, whereas the bound residue was 54.2-56.4 % greater than the control. RGO also reduced the relative abundances of triclosan-degrading bacteria (Pseudomonas and Sphingomonas) in soils. Compared to silty loam, RGO more effectively inhibited triclosan degradation in silty clay loam. Furthermore, the DFT calculations suggested a strong association of the adsorption of triclosan on RGO with the van der Waals forces and π-π interactions. These results revealed that RGO inhibited the transformation of 14C-triclosan in soil through strong adsorption and triclosan-degrading bacteria inhibition in soils. Therefore, the presence of RGO may potentially enhance persistence of triclosan in soil. Overall, our study provides valuable insights into the risk assessment of triclosan in the presence of GNs in soil environment.

Lagging pollution of polycyclic aromatic hydrocarbons in the rebuilt e-waste site: From the perspective of characteristics, sources, and risk assessment.

Little information is known regarding how the lagged pollution of polycyclic aromatic hydrocarbon (PAH) influenced the environment and human health after an e-waste dismantling site was rebuilt. This study investigated the characteristics, sources, and risk assessment of PAHs in a rebuilt e-waste site and its surrounding farmland by analyzing the samples of soil, dust, water, and vegetable. Concentrations of PAHs in soil, vegetable and water in the rebuilt site were relatively higher than in its surrounding farmland. The concentrations in surface soils, soil columns, dust, vegetables, and water varied from 55.4 to 3990 ng g-1, 1.65 to 5060 ng g-1, 2190 to 2420 ng g-1, 2670 to 10,300 ng g-1, and 46.8 to 110 µg L-1 in the e-waste site, respectively. On the farmland, PAH concentrations in surface soils, vegetables, and water ranged from 41.5 to 2760 ng g-1, 506 to 7640 ng g-1, and 56.6 to 89.2 µg L-1, respectively. A higher proportion of high-molecular-weight PAHs (HMW-PAHs) appeared in all multimedia compared with low-molecular-weight PAHs (LMW-PAHs). Diagnostic ratio together with positive matrix factorization (PMF) revealed that vehicle emission was the primary source in this area, and the activity of e-waste disposal was another important source in the rebuilt e-waste site. Based on the deterministic health risks, people working in the reconstructed e-waste site were exposed to low risks, whereas the residents living near the surrounding farmland were exposed to low risk. Sensitivity analyses indicated that exposure frequency and PAH concentrations were the main factors that influenced exposure risk. This study provides valuable insight into the comprehension of the lagging pollution effects of PAH on the environment and human health after the e-waste site was rebuilt.

Fate and transformation of uniformly 14C-ring-labeled bisphenol S in different aerobic soils.

Bisphenol S (BPS), being structurally similar to bisphenol A (BPA), has been widely used as an alternative to BPA in industrial applications. However, in-depth studies on the environmental behavior and fate of BPS in various soils have been rarely reported. Here, 14C-labeled BPS was used to investigate its mineralization, bound residues (BRs) formation and extractable residues (ERs) in three soils for 64 days. Significant differences were found in the dissipation rates of BPS in three soils with different pH values. The dissipation of BPS followed pseudo first-order kinetics with half-lives (T1/2) of 15.2 ± 0.1 d, 27.0 ± 0.2 d, 180.4 ± 5.3 d, and 280.5 ± 3.3 d in the alkaline soil (fluvo-aquic soil, FS), the neutral soil (cinnamon soil, CS), the acidic soil (red soil, RS), and sterilized cinnamon soil (CS-S), respectively. The mineralization and BRs formation contributed the most to the dissipation of BPS in soil. BPS was persistent in acidic soil, and may pose a significant threat to plants grown in acidic soils. Additionally, soil microorganisms played a key role in BPS degradation, and the organic matter content might be a major factor that promotes the adsorption and degradation of BPS in soils. Two transformed products, P-hydroxybenzenesulfonic acid and methylated BPS were identified in soils. This study provides new insights into the fate of BPS in various soils, which will be useful for risk assessments of BPS in soil.

Reduced graphene oxide accelerates the dissipation of 14C-Triclosan in paddy soil via adsorption interactions.

Reduced graphene oxide (RGO) is one of common carbon nanomaterials, which is widely used in various fields. Triclosan is an antimicrobial agent added in pharmaceuticals and personal care products. Extensive release of RGO and triclosan has posed potential risks to humans and the environment. The impact of RGO on the fate of triclosan in paddy soil is poorly known. 14C-Triclosan was employed in the present study to determine its distribution, degradation and mineralization in paddy soil mixed with RGO. Compared with the control, RGO (500 mg kg-1) significantly inhibited the mineralization of 14C-triclosan, and reduced its extractability by 6.5%. The bound residues of triclosan in RGO-contaminated soil (100 and 500 mg kg-1) were 2.9-13.3% greater than that of the control at 112 d. RGO also accelerated the dissipation of triclosan, and its degradation products in both treatments and controls were tentatively identified via 14C-labeling method and LC-Q-TOF-MS analysis. The concentrations of the major metabolites (methyl-triclosan and dechlorinated dimer) were inversely related with the concentrations of RGO. RGO at 50 mg kg-1 or lower had a negligible effect on the degradation of triclosan in paddy soil. Triclosan was strongly adsorbed onto RGO-contaminated soil, which may play a vital role in the fate of triclosan in RGO-contaminated paddy soil. Interestingly, RGO had little effect on triclosan-degrading bacteria via soil microbial community analysis. This study helps understand the effects of RGO on the transformation of triclosan in paddy soil, which is of significance to evaluate the environmental risk of triclosan in RGO-contaminated soil.

Uptake, translocation and accumulation of 14C-triclosan in soil-peanut plant system.

Triclosan is an antimicrobial agent that is ubiquitously present in water, biosolids and soil. Current agricultural practices, such as irrigation with treated wastewater and soil amendment with biosolids, often cause further triclosan contamination in agricultural fields. However, the fate and crop uptake of triclosan in agrofood systems and related human exposure are still not fully understood. In the present study, 14C-triclosan was used to trace the fate and distribution of triclosan in a soil-peanut plant system. 14C-triclosan in the system maintained an excellent mass balance ranging from 92.5% to 102.7%. 14C-triclosan uptake from soil to peanut plants at the harvest stage (120 d) was only 1.02 ± 0.17% of the applied 14C. The bioconcentration factors in different tissues followed the order of roots > stems > leaves > fruits. The concentration of 14C-triclosan in peanut fruits was 0.76-0.84 µg g-1. 14C-triclosan was more easily accumulated in peanut kernels (69.2 ± 6.30%) than peanut hulls (27.5 ± 5.77%) and skin (3.28 ± 0.53%). The estimated daily intake (EDI) values suggested that peanut consumption represented a minimal risk to human health. The results of this study help to develop a better understanding of the fate of triclosan in the soil-peanut plant system and assess its environmental and human health risks.