Impact of blocking layers based on TiO2 and ZnO prepared via direct current reactive magnetron sputtering on DSSC solar cells.

The optimization of dye-sensitized solar cells (DSSCs) technology towards suppressing charge recombination between the contact and the electron transport layer is a key factor in achieving high conversion efficiency and the successful commercialization of this type of product. An important aspect of the DSSC structure is the front blocking layer (BL): optimizing this component may increase the efficiency of photoelectron transfer from the dye to the semiconductor by reduction charge recombination at the TiO2/electrolyte and FTO/electrolyte interfaces. In this paper, a series of blocking layer variants, based on TiO2 and ZnO:TiO2, were obtained using the reactive magnetron sputtering method. Material composition, structure and layer thickness were referred to each process parameters. Complete DSSCs with structure FTO/BL/m-TiO2@N719/ EL-HSE/Pt/FTO were obtained on such bases. In the final results, verification of opto-electrical parameters of these cells were tested and used for the conclusions on the optimal blocking layer composition. As the conclusion, application of blocking layer consists of neat TiO2 resulted in improvement of device efficiency. It should be noted that for TiO2:ZnO/CuxO and TiO2/CuxO cells, higher efficiencies were also achieved when pure TiO2 was used as window layer. Additionally it was proven that the admixture of ZnO phase inspires Voc and FF growth, but is overall unfavorable compared to pristine TiO2 blocking layer and the reference cell, according to the final cell efficiency.

3D vector MR elastography applications in small organs.

BACKGROUND: Magnetic resonance elastography (MRE) is a rapidly developing medical imaging technique that allows for quantitative assessment of the biomechanical properties of the tissue. MRE is now regarded as the most accurate noninvasive test for detecting and staging liver fibrosis. A two-dimensional (2D MRE) acquisition version is currently deployed at >2000 locations worldwide. 2D MRE allows for the evaluation of the magnitude of the complex shear modulus, also referred to as stiffness. The development of 3D vector MRE has enabled researchers to assess the biomechanical properties of small organs where wave propagation cannot be adequately analyzed with the 2D MRE imaging approach used in the liver. In 3D vector MRE, the shear waves are imaged and processed throughout a 3D volume and processed with an algorithm that accounts for wave propagation in any direction. Additionally, the motion is also imaged in x, y, and z directions at each voxel, allowing for more advanced processing to be applied. PURPOSE: This review describes the technical principles of 3D vector MRE, surveys its clinical applications in small organs, and discusses potential clinical significance of 3D vector MRE. CONCLUSION: 3D vector MRE is a promising tool for characterizing the biomechanical properties of small organs such as the uterus, pancreas, thyroid, prostate, and salivary glands. However, its potential has not yet been fully explored.