RESUMEN
(1) Background: Numerous studies have shown the beneficial role of fluoride in the primary prevention of dental caries. The aim of the present study was to put into evidence the change in the enamel structure immediately after the application of a fluoride varnish. (2) Methods: A xylitol−fluoride varnish was evaluated. The enamel specimens (n = 10) were analyzed by atomic force microscopy on enamel surface and treatment with fluoride varnish applied. The dimensional topographic analysis was performed by 2D and 3D analysis software. Statistical analysis was performed using SPSS Version 26.00 (IBM, Armonk, NY, USA). A one-sample statistics test was used to identify significant differences (p < 0.05). (3) Results: Surface roughness (Ra) measurements ranged from Ra = 0.039 µm (±0.048), to Ra = 0.049 µm (±0.031), respectively (p < 0.05), with an increase in the surface roughness passing from the intact enamel to the enamel exposed to fluoride varnish. When comparing Ra values of the nonfluorinated enamel and fluorinated enamel, significant differences (p < 0.05) were found, suggesting that the varnish had a protective effect on the enamel surface. (4) Conclusions: Xylitol−fluoride varnish, even in one single short-time application, is effective in reducing the surface roughness of enamel structure exposed to abrasion, thus increasing resistance to dental caries.
RESUMEN
The catalytic behavior of iron phthalocyanine (FePc)-sensitized magnetic nanocatalysts was evaluated for their application in the oxidative treatment of Bisphenol A (BPA) under mild environmental conditions. Two types of FePc (Fe(II)Pc and Fe(III)Pc), which are highly photosensitive compounds, were immobilized on the surface of functionalized magnetite. The nanomaterials were characterized by high resolution transmission electron microscopy (HR-TEM), X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR) and thermogravimetric analyses (TGA). The generation of singlet oxygen by nanomaterials was also investigated. In the presence of UVA light exposure (365 nm) and 15 mM H2O2, the M@Fe(III)Pc photocatalyst gave the best results; for a catalyst concentration of 2.0 g L - 1, around 60% BPA was removed after 120 min of reaction. These experimental conditions were further tested under natural solar light exposure, for which also M@Fe(III)Pc exhibited enhanced oxidative catalytic activity, being able to remove 83% of BPA in solution. The water samples were less cytotoxic after treatment, this being confirmed by the MCF-7 cell viability assay.