Electrochemically Triggered Chain Reactions for the Conversion of Furan Derivatives.

We report an electrochemical method for coupling biomass-derived C5/C6 compounds to value-added fuel precursors. Using only 2 % of equivalent charges, 2-methylfuran (2-MF) was oxidized to yield a cation radical, which readily reacted with 3-hexene-2,5-dione, a derivate of 2,5-dimethylfuran, to produce 3-(5-methylfuran-2-yl)hexane-2,5-dione. The product was converted to 4-ethylnonane (a component of biodiesel/jet fuel) in a single step in excellent yield. Importantly, the reaction was not sensitive to oxygen, and a trace amount of water was found to promote the reaction. Detailed mechanistic studies confirmed the proposed reaction pathways. Key to the mechanism is the radical generation that is enabled by electrochemistry. The radical is regenerated at the end of a reaction cycle to ensure chain propagation for an average of ca. 47 times, resulting in an apparent Faradaic efficiency of 4700 %.

Enabling Lithium Metal Anode in Nonflammable Phosphate Electrolyte with Electrochemically Induced Chemical Reactions.

Lithium metal anode holds great promises for next-generation battery technologies but is notoriously difficult to work with. The key to solving this challenge is believed to lie in the ability of forming stable solid-electrolyte interphase (SEI) layers. To further address potential safety issues, it is critical to achieve this goal in nonflammable electrolytes. Building upon previous successes in forming stable SEI in conventional carbonate-based electrolytes, here we report that reversible Li stripping/plating could be realized in triethyl phosphate (TEP), a known flame retardant. The critical enabling factor of our approach was the introduction of oxygen, which upon electrochemical reduction induces the initial decomposition of TEP and produces Li3 PO4 and poly-phosphates. Importantly, the reaction was self-limiting, and the resulting material regulated Li plating by limiting dendrite formation. In effect, we obtained a functional SEI on Li metal in a nonflammable electrolyte. When tested in a symmetric Li∥Li cell, more than 300 cycles of stripping/plating were measured at a current density of 0.5 mA cm-2 . Prototypical Li-O2 and Li-ion batteries were also fabricated and tested to further support the effectiveness of this strategy. The mechanism by which the SEI forms was studied by density functional theory (DFT), and the predictions were corroborated by the successful detection of the intermediates and products.

Atomically dispersed Ir catalysts exhibit support-dependent water oxidation kinetics during photocatalysis.

Heterogeneous water oxidation catalysis is central to the development of renewable energy technologies. Recent research has suggested that the reaction mechanisms are sensitive to the hole density at the active sites. However, these previous results were obtained on catalysts of different materials featuring distinct active sites, making it difficult to discriminate between competing explanations. Here, a comparison study based on heterogenized dinuclear Ir catalysts (Ir-DHC), which feature the same type of active site on different supports, is reported. The prototypical reaction was water oxidation triggered by pulsed irradiation of suspensions containing a light sensitizer, Ru(bpy)32+, and a sacrificial electron scavenger, S2O82-. It was found that at relatively low temperatures (288-298 K), the water oxidation activities of Ir-DHC on indium tin oxide (ITO) and CeO2 supports were comparable within the studied range of fluences (62-151 mW cm-2). By contrast, at higher temperatures (310-323 K), Ir-DHC on ITO exhibited a ca. 100% higher water oxidation activity than on CeO2. The divergent activities were attributed to the distinct abilities of the supporting substrates in redistributing holes. The differences were only apparent at relatively high temperatures when hole redistribution to the active site became a limiting factor. These findings highlight the critical role of the supporting substrate in determining the turnover at active sites of heterogeneous catalysts.

Electrochemically switchable polymerization from surface-anchored molecular catalysts.

Redox-switchable polymerizations of lactide and epoxides were extended to the solid state by anchoring an iron-based polymerization catalyst to TiO2 nanoparticles. The reactivity of the molecular complexes and their redox-switching characteristics were maintained in the solid-state. These properties resulted in surface-initiated polymerization reactions that produced polymer brushes whose chemical composition is dictated by the oxidation state of the iron-based complex. Depositing the catalyst-functionalized TiO2 nanoparticles on fluorine-doped tin oxide resulted in an electrically addressable surface that could be used to demonstrate spatial control in redox-switchable polymerization reactions. By using a substrate that contained two electrically isolated domains wherein one domain was exposed to an oxidizing potential, patterns of surface-bound polyesters and polyethers were accessible through sequential application of lactide and cyclohexene oxide. The differentially functionalized surfaces demonstrated distinct physical properties that illustrated the promise for using the method to pattern surfaces with multiple, chemically distinct polymer brushes.

Transcription factor NF-κB in a basal metazoan, the sponge, has conserved and unique sequences, activities, and regulation.

Herein, we characterize transcription factor NF-κB from the demosponge Amphimedon queenslandica (Aq). Aq-NF-κB is most similar to NF-κB p100/p105 among vertebrate proteins, with an N-terminal DNA-binding domain, a C-terminal Ankyrin (ANK) repeat domain, and a DNA binding-site profile akin to human NF-κB proteins. Like mammalian NF-κB p100, C-terminal truncation allows nuclear translocation of Aq-NF-κB and increases its transcriptional activation activity. Expression of IκB kinases (IKKs) induces proteasome-dependent C-terminal processing of Aq-NF-κB in human cells, and processing requires C-terminal serines in Aq-NF-κB. Unlike NF-κB p100, C-terminal sequences of Aq-NF-κB do not inhibit its DNA-binding activity. Tissue of a black encrusting demosponge contains NF-κB site DNA-binding activity, as well as nuclear and processed NF-κB. Treatment of sponge tissue with LPS increases both DNA-binding activity and processing of NF-κB. A. queenslandica transcriptomes contain homologs to upstream NF-κB pathway components. This is first functional characterization of NF-κB in sponge, the most basal multicellular animal.