Measurement of 227Ac impurity in 225Ac using decay energy spectroscopy.

225Ac is a valuable medical radionuclide for targeted α therapy, but 227Ac is an undesirable byproduct of an accelerator-based synthesis method under investigation. Sufficient detector sensitivity is critical for quantifying the trace impurity of 227Ac, with the 227Ac/225Ac activity ratio predicted to be approximately 0.15% by end-of-bombardment (EOB). Superconducting transition edge sensor (TES) microcalorimeters offer high resolution energy spectroscopy using the normal-to-superconducting phase transition to measure small changes in temperature. By embedding 225Ac production samples in a gold foil thermally coupled to a TES microcalorimeter we can measure the decay energies of the radionuclides embedded with high resolution and 100% detection efficiency. This technique, known as decay energy spectroscopy (DES), collapses several peaks from α decays into single Q-value peaks. In practice there are more complex factors in the interpretation of data using DES, which we will discuss herein. Using this technique we measured the EOB 227Ac impurity to be (0.142 ± 0.005)% for a single production sample. This demonstration has shown that DES is a useful tool for quantitative measurements of complicated spectra.

Separation of 44Ti from proton irradiated scandium by using solid-phase extraction chromatography and design of 44Ti/44Sc generator system.

Scandium-44g (half-life 3.97h [1]) shows promise for positron emission tomography (PET) imaging of longer biological processes than that of the current gold standard, 18F, due to its favorable decay parameters. One source of 44gSc is the long-lived parent nuclide 44Ti (half-life 60.0 a). A 44Ti/44gSc generator would have the ability to provide radionuclidically pure 44gSc on a daily basis. The production of 44Ti via the 45Sc(p,2n) reaction requires high proton beam currents and long irradiation times. Recovery and purification of no-carrier added (nca) 44Ti from scandium metal targets involves complex separation chemistry. In this study, separation systems based on solid phase extraction chromatography were investigated, including branched diglycolamide (BDGA) resin and hydroxamate based ZR resin. Results indicate that ZR resin in HCl media represents an effective 44Ti/44gSc separation system.

Large scale accelerator production of 225Ac: Effective cross sections for 78-192MeV protons incident on 232Th targets.

Actinium-225 and 213Bi have been used successfully in targeted alpha therapy (TAT) in preclinical and clinical research. This paper is a continuation of research activities aiming to expand the availability of 225Ac. The high-energy proton spallation reaction on natural thorium metal targets has been utilized to produce millicurie quantities of 225Ac. The results of sixteen irradiation experiments of thorium metal at beam energies between 78 and 192MeV are summarized in this work. Irradiations have been conducted at Brookhaven National Laboratory (BNL) and Los Alamos National Laboratory (LANL), while target dissolution and processing was carried out at Oak Ridge National Laboratory (ORNL). Excitation functions for actinium and thorium isotopes, as well as for some of the fission products, are presented. The cross sections for production of 225Ac range from 3.6 to 16.7mb in the incident proton energy range of 78-192MeV. Based on these data, production of curie quantities of 225Ac is possible by irradiating a 5.0gcm-2 232Th target for 10 days in either BNL or LANL proton irradiation facilities.

Application of ion exchange and extraction chromatography to the separation of actinium from proton-irradiated thorium metal for analytical purposes.

Actinium-225 (t1/2=9.92d) is an α-emitting radionuclide with nuclear properties well-suited for use in targeted alpha therapy (TAT), a powerful treatment method for malignant tumors. Actinium-225 can also be utilized as a generator for (213)Bi (t1/2 45.6 min), which is another valuable candidate for TAT. Actinium-225 can be produced via proton irradiation of thorium metal; however, long-lived (227)Ac (t1/2=21.8a, 99% ß(-), 1% α) is co-produced during this process and will impact the quality of the final product. Thus, accurate assays are needed to determine the (225)Ac/(227)Ac ratio, which is dependent on beam energy, irradiation time and target design. Accurate actinium assays, in turn, require efficient separation of actinium isotopes from both the Th matrix and highly radioactive activation by-products, especially radiolanthanides formed from proton-induced fission. In this study, we introduce a novel, selective chromatographic technique for the recovery and purification of actinium isotopes from irradiated Th matrices. A two-step sequence of cation exchange and extraction chromatography was implemented. Radiolanthanides were quantitatively removed from Ac, and no non-Ac radionuclidic impurities were detected in the final Ac fraction. An (225)Ac spike added prior to separation was recovered at ≥ 98%, and Ac decontamination from Th was found to be ≥ 10(6). The purified actinium fraction allowed for highly accurate (227)Ac determination at analytical scales, i.e., at (227)Ac activities of 1-100 kBq (27 nCi to 2.7 µCi).

Radioarsenic from a portable (72)Se/(72)As generator: a current perspective.

Positron emission tomography (PET) of slower biological processes calls for the use of longer lived positron emitting radioisotopes. Beyond radionuclide production considerations, practicality and rapidity of subsequent labeling chemistry further limits the selection of radioisotopes with potentially favorable nuclear properties. One additional limitation is the availability of PET radiotracers at the point-of-care with appropriate on-site production methodologies or robust radionuclide generator systems. The positron emitter (72)As (half-life 26 h) is generated via decay of (72)Se (half-life 8.5 d); this pair comprises and excellent generator system for clinical availability of a longer lived PET isotope. Many (72)Se/As generator systems have been introduced utilizing the rich interplay of Se(IV)/Se(VI) and As(III) /As(V) chemical behavior. This paper describes available generator concepts, and briefly outlines some current arsenic labeling methodologies for the introduction of radioarsenic into biomolecules.

Selenium-72 formation via nat Br(p,x) induced by 100 MeV protons: steps towards a novel 72Se/72As generator system.

Selenium-72 production by the proton bombardment of a natural NaBr target has been successfully demonstrated at the Los Alamos National Laboratory Isotope Production Facility (LANL-IPF). Arsenic-72 (half life 26 h) is a medium-lived positron emitting radionuclide with the major advantage of being formed as the daughter of another "generator" radioisotope (Se-72, 8.5 d). A (72)Se/(72)As generator would be the preferred mechanism for clinical utilization of (72)As for positron emission tomography (PET). No portable (72)Se/(72)As generator system has been demonstrated for convenient, repeated (72)As elution ("milking"). In this work, we describe (72)Se production and recovery from irradiated NaBr targets using a 100 MeV proton beam. We also introduce an (72)As generator principle based on (72)Se chelation followed by liquid-liquid extraction, which will be transferred to a solid-phase sorption/elution system.

Proton-induced cross sections relevant to production of 225Ac and 223Ra in natural thorium targets below 200 MeV.

Cross sections for (223,)(225)Ra, (225)Ac and (227)Th production by the proton bombardment of natural thorium targets were measured at proton energies below 200 MeV. Our measurements are in good agreement with previously published data and offer a complete excitation function for (223,)(225)Ra in the energy range above 90 MeV. Comparison of theoretical predictions with the experimental data shows reasonable-to-good agreement. Results indicate that accelerator-based production of (225)Ac and (223)Ra below 200 MeV is a viable production method.

225Ac and 223Ra production via 800 MeV proton irradiation of natural thorium targets.

Cross sections for the formation of (225,227)Ac, (223,225)Ra, and (227)Th via the proton bombardment of natural thorium targets were measured at a nominal proton energy of 800 MeV. No earlier experimental cross section data for the production of (223,225)Ra, (227)Ac and (227)Th by this method were found in the literature. A comparison of theoretical predictions with the experimental data shows agreement within a factor of two. Results indicate that accelerator-based production of (225)Ac and (223)Ra is a viable production method.