RESUMEN
This study aimed to investigate the liquid-liquid equilibrium (LLE) behavior of sesame fatty acid ethyl ester (FAEE) and methyl ester (FAME) in combination with glycerol and the co-solvents ethanol and methanol. FAEE and FAME were produced through the transesterification of mechanically extracted and purified sesame oil, using potassium hydroxide (KOH) as a homogeneous base catalyst. The reactions were conducted in ethanol and methanol to produce FAEE and FAME, respectively. Post-reaction, the products were separated and purified, followed by an analysis of the LLE behavior at 313.15 K and 323.15 K under atmospheric pressure (101.3 kPa). The experimental process for the miscibility analysis utilized a jacketed glass cell adapted for this study. Miscibility limits or binodal curves were determined using the turbidity-point method. Tie lines were constructed by preparing mixtures of known concentrations within the two-phase region, which allowed the phases to separate after agitation. Samples from both phases were analyzed to determine their composition. This study revealed that higher temperatures promoted greater phase separation and enhanced the biodiesel purification process. The NRTL model effectively correlated the activity coefficients with the experimental data, showing good agreement, with a root-mean-square deviation of 3.5%. Additionally, the data quality was validated using Marcilla's method, which yielded an R2 value close to 1. Attraction factors and distribution coefficients were also calculated to evaluate the efficiency of the co-solvents as extraction agents. The findings indicated higher selectivity for methanol than for ethanol, with varying degrees of distribution among the co-solvents. These results offer significant insights into enhancing biodiesel production processes by considering the effects of co-solvents on the LLE properties of mixtures, ultimately contributing to more efficient and cost-effective biodiesel production.
RESUMEN
Caryocar brasiliense Cambess (pequi) is the fruit of the pequizeiro tree found in the Brazilian Cerrado (savanna). Supercritical fluids have been used to effectively extract bioactive chemicals. In light of the paucity of research on the supercritical extraction of pequi, in this study, experimental tests were conducted on the extraction of pequi almond oil using supercritical CO2; the optimal extraction conditions were determined, and the fatty acids and active compounds in the oil were characterized. The experiments were conducted using the Box-Behnken experimental design of a three-variable system: pressure (15, 20, and 25 MPa), temperature (303.15, 318.15, and 333.15 K), and flow rate (2, 3, and 5 g.min-1). The optimal extraction conditions were 318.15 K, 25 MPa, and 5.0 g.min-1, which yielded 27.6 wt% of oil. The experimental kinetic curves were described using a second-order quadratic model (based on the Sovová model), which demonstrated a satisfactory correspondence with the kinetic curves. Significant amounts of squalene, stigmasterol, oleic fatty acids, and palmitic fatty acids were detected in pequi almond oil.
RESUMEN
This study reports an alternative method for black liquor treatment with potential for energy and process savings in the paper and pulp industry. Gasification of black liquor was carried out under sub- and supercritical conditions, varying the black liquor feed composition (0.10, 2.55 and 5.00 wb%) and temperature (350, 425 and 500 °C). Liquid products were identified by high resolution mass spectrometry (FT-Orbitrap MS) and compounds belonging to classes O3 and O4 were found to be the most representative in the products of reactions performed at 500 °C. The mass spectra results also revealed the overall selectivity of reactions, where decarboxylation and demethoxylation reactions were favored under subcritical and supercritical conditions, respectively. Among the gaseous products, hydrogen and methane were produced with maximum of 69.04 and 28.75 mol%, respectively, at 2.55 wb% and 425 °C. The proposed thermodynamic modelling of the reaction system satisfactorily predicted the gas phase behavior of the system. In the economic analysis, the simulated conditions indicated that the main energy requirements for a scaled-up black liquor gasification process are related to the necessary heat exchangers and pressurizing of the black liquor solution. Furthermore, the cost of the black liquor gasification is around 0.06 US$ per kg of feed stream. Liquid and gaseous products from gasification could be obtained at a cost of 56.64 US$ and 3.35 US$ per tonne of stream, respectively. Therefore, black liquor gasification is an interesting route for obtaining combustible gases and value-added bioproducts.