RESUMEN
BiFeO3 (BFO) has been widely investigated in many forms and morphologies because of its combined multiferroic and photovoltaic properties. However, direct growth of vertically aligned BFO nanorods on an underlying substrate has remained a challenge. In this work, we report template free growth of BiFeO3 nanorod arrays on fluorine doped tin oxide coated glass substrate. This has been achieved by a two-step process, in which FeOOH nanorods are grown by chemical bath deposition and converted into BFO using bismuth (Bi) coating by physical vapour deposition (PVD). Both DC sputtering and thermal evaporation are attempted under PVD and the results suggest that Bi deposited by DC sputtering leads to well-defined BFO nanorods, which show superior performance in both multiferroic and photoelectrochemical studies. Piezoelectric force microscopy data shows the signature butterfly loop that confirms piezoelectric behaviour with a d 33 value of 8 pmV-1 in the BFO nanorods grown by DC sputtering. Further, the M-H hysteresis curve for the same samples reveals a remanent magnetization (Mr) value of 0.54 emu cc-1 and antiferromagnetic nature at room temperature. Finally, a stable photocurrent density of 0.05 mA cm-2 is achieved at 0.8 V vs Ag/AgCl under 1 Sun illumination. This work opens up new avenues for BFO in applications involving 1D nanostructures.
RESUMEN
This research utilizes waste heat energy as a sustainable energy source to enhance pyroelectric power output by combining pyroelectric nanogenerators with an external pulsed electric field. When the surface temperature of the pyroelectric body varies, applying different pulses of the external electric field results in maximum power accumulation. A novel power-generating experimental setup was developed to measure and compute pyroelectric power generation. A standard Fuji ceramic C-9 sample was used to generate pyroelectric energy in a 20 °C temperature range from 120 to 140 °C. The continuous temperature variation frequency was 0.05 Hz, and the pulsed electric field was applied when the temperature rose. Pulses of the electric field with widths of 10, 50, 100, and 200 ms were applied to the sample under different pulse amplitudes, and the amplitude of each pulse was 250, 500, 1000, or 1500 V/mm. The maximum power generated through the application of an external pulsed electric field under the above-mentioned conditions was evaluated. This system had the highest power density of 0.204 mJ cm-2 °C-1 kV-1. In addition, for the lowest input power, the maximum power generation condition was a 10 ms pulse width and an amplitude of 250 V mm-1 in the applied electric field. This state might power smart sensor modules, IoT devices, automobiles, and other waste heat energy applications. Nano-pulse electric field applications may reduce input power to its lowest level, dependent on net-producing power. Therefore, new researchers can use net-generation power efficiency to create a large-scale power source using multiple pyroelectric arrays.