Development of Essential Oil-Loaded Polymeric Nanocapsules as Skin Delivery Systems: Biophysical Parameters and Dermatokinetics Ex Vivo Evaluation.

Essential oils (EOs) are natural antioxidant alternatives that reduce skin damage. However, EOs are highly volatile; therefore, their nanoencapsulation represents a feasible alternative to increase their stability and favor their residence time on the skin to guarantee their effect. In this study, EOs of Rosmarinus officinalis and Lavandula dentata were nanoencapsulated and evaluated as skin delivery systems with potential antioxidant activity. The EOs were characterized and incorporated into polymeric nanocapsules (NC-EOs) using nanoprecipitation. The antioxidant activity was evaluated using the ferric thiocyanate method. The ex vivo effects on pig skin were evaluated based on biophysical parameters using bioengineering techniques. An ex vivo dermatokinetic evaluation on pig skin was performed using modified Franz cells and the tape-stripping technique. The results showed that the EOs had good antioxidant activity (>65%), which was maintained after nanoencapsulation and purification. The nanoencapsulation of the EOs favored its deposition in the stratum corneum compared to free EOs; the highest deposition rate was obtained for 1,8-cineole, a major component of L. dentata, at 1 h contact time, compared to R. officinalis with a major deposition of the camphor component. In conclusion, NC-EOs can be used as an alternative antioxidant for skin care.

Inclusion Complexes of Concentrated Orange Oils and ß-Cyclodextrin: Physicochemical and Biological Characterizations.

Concentrated orange oils (5x, 10x, 20x) are ingredients used in different industries as components of flavors and aromas due to their great organoleptic qualities. This research focuses on the search for alternative uses for their application through encapsulation in inclusion complexes with ß-cyclodextrin (ß-CD). Inclusion complexes of concentrated orange oils (COEO) and ß-CD were developed by the co-precipitated method in ratios of 4:96, 12:88, and 16:84 (w/w, COEO: ß-CD). The best powder recovery was in the ratio 16:84 for the three oils, with values between 82% and 84.8%. The 20x oil in relation 12:88 showed the highest entrapment efficiency (89.5%) with 102.3 mg/g of ß-CD. The FT-IR analysis may suggest an interaction between the oil and the ß-CD. The best antioxidant activity was observed in the ratio 12:88 for the three oils. The antifungal activity was determined for all the inclusion complexes, and the 10x fraction showed the highest inhibition at a concentration of 10 mg/mL in ratios 12:88 and 16:84. Antibacterial activity was determined by the minimum inhibitory concentration (MIC) and was found at a concentration of 1.25 mg/mL in ratios 12:88 and 16:84 for 5x and 20x oils.

Evaluation of hypocholesterolemic activity of extracts of Bidens odorata and Brickellia eupatorioides.

We sought to evaluate the hypolipidemic activity of extracts of Bidens odorata and Brickellia eupatorioides using a model of hyperlipidemia induced in rats by Triton WR-1339 (300mg/kg intraperitoneally). The rats were divided into 5 groups of 3 rats each: normal control group, hyperlipidemic control group, hyperlipidemic with 20 mg/kg atorvastatin, hyperlipidemic with 300 mg/kg B. odorata extract, and hyperlipidemic with 300mg/kg B. eupatorioides extract, respectively. After 10 d of treatment by intragastric administration, the extract of B. odorata caused a significant decrease of serum total cholesterol and triglyceride levels without altering the liver enzymes aspartate transaminase and alanine aminotransferase. In addition, the extract had antioxidant potential as shown by the 2,2-diphenyl-1-picrylhydrazyl technique. These findings indicate that B. odorata has potential as a hypolipidemic agent and might be beneficial in treatment of hyperlipidemia and atherosclerosis.

Enhancement of Strawberry Shelf Life via a Multisystem Coating Based on Lippia graveolens Essential Oil Loaded in Polymeric Nanocapsules.

Strawberries (Fragaria xannanasa) are susceptible to mechanical, physical, and physiological damage, which increases their incidence of rot during storage. Therefore, a method of protection is necessary in order to minimize quality losses. One way to achieve this is by applying polymer coatings. In this study, multisystem coatings were created based on polymer nanocapsules loaded with Lippia graveolens essential oil, and it was found to have excellent optical, mechanical, and water vapor barrier properties compared to the control (coating formed with alginate and with nanoparticles without the essential oil). As for the strawberries coated with the multisystem formed from the polymer nanocapsules loaded with the essential oil of Lippia graveolens, these did not present microbial growth and only had a loss of firmness of 17.02% after 10 days of storage compared to their initial value. This study demonstrated that the multisystem coating formed from the polymer nanocapsules loaded with the essential oil of Lippia graveolens could be a viable alternative to preserve horticultural products for longer storage periods.

Formulation and optimization of polymeric nanoparticles loaded with riolozatrione: a promising nanoformulation with potential antiherpetic activity.

Riolozatrione (RZ) is a diterpenoid compound isolated from a dichloromethane extract of the Jatropha dioica root. This compound has been shown to possess moderate antiherpetic activity in vitro. However, because of the poor solubility of this compound in aqueous vehicles, generating a stable formulation for potential use in the treatment of infection is challenging. The aim of this work was to optimize and physio-chemically characterize Eudragit® L100-55-based polymeric nanoparticles (NPs) loaded with RZ (NPR) for in vitro antiherpetic application. The NPs formulation was initially optimized using the dichloromethane extract of J. dioica, the major component of which was RZ. The optimized NPR formulation was stable, with a size of 263 nm, polydispersity index < 0.2, the zeta potential of -37 mV, and RZ encapsulation efficiency of 89 %. The NPR showed sustained release of RZ for 48 h with release percentages of 95 and 97 % at neutral and slightly acidic pH, respectively. Regarding in vitro antiherpetic activity, the optimized NPR showed a selectivity index for HSV-1 of ≈16 and for HSV-2 of 13.

Development of a Portland Cement-Based Material with Agave salmiana Leaves Bioaggregate.

Depending on the morphology of the natural fibers, they can be used as reinforcement to improve flexural strength in cement-based composites or as aggregates to improve thermal conductivity properties. In this last aspect, hemp, coconut, flax, sunflower, and corn fibers have been used extensively, and further study is expected into different bioaggregates that allow diversifying of the raw materials. The objective of the research was to develop plant-based concretes with a matrix based on Portland cement and an aggregate of Agave salmiana (AS) leaves, obtained from the residues of the tequila industry that have no current purpose, as a total replacement for the calcareous aggregates commonly used in the manufacturing of mortars and whose extraction is associated with high levels of pollution, to improve their thermal properties and reduce the energy demand for air conditioning in homes. Characterization tests were carried out on the raw materials and the vegetal aggregate was processed to improve its compatibility with the cement paste through four different treatments: (a) freezing (T/C), (b) hornification (T/H), (c) sodium hydroxide (T/NaOH), and (d) solid paraffin (T/P). The effect of the treatments on the physical properties of the resulting composite was evaluated by studying the vegetal concrete under thermal conductivity, bulk density, and compressive strength tests with a volumetric ratio between the vegetal aggregate and the cement paste of 0.36 and a water/cement ratio of 0.35. The hornification treatment showed a 15.2% decrease in the water absorption capacity of the aggregate, resulting in a composite with a thermal conductivity of 0.49 W/mK and a compressive strength of 8.66 MPa, which allows its utilization as a construction material to produce prefabricated blocks.

Simultaneous GC-FID Quantification of Main Components of Rosmarinus officinalis L. and Lavandula dentata Essential Oils in Polymeric Nanocapsules for Antioxidant Application.

The essential oils (EO) of R. officinalis and L. dentata have been widely used due to their antioxidant activity. However, due to their high volatility, the loading of EO into polymeric nanocapsules (NC) represents an efficient way of retaining their effect in future topical administration. In this way, the quantitative determination of EO incorporated into NC is necessary for simultaneous monitoring of the main components of the EO during the nanoencapsulation process as well as for precise and exact dosing of the components used during the performance of in vitro and in vivo biological tests. In this study, EO were isolated by hydrodistillation in a Clevenger-type apparatus and characterized by GC-MS and GC-FID analyses. The major constituents of EO-R. officinalis were camphor (39.46%) and 1,8-cineole (14.63%), and for EO-L. dentata were 1,8-cineole (68.59%) and ß-pinene (11.53%). A new analytical method based on GC-FID for quantification of free and encapsulated EO was developed and validated according to ICH. Linearity, limit of detection and quantification, and intra- and interday precision parameters were determined. The methods were linear and precise for the quantification of the main components of EO. The EO were encapsulated by nanoprecipitation and were analyzed by the GC-FID method validated for their direct quantification. The NC size was 200 nm with homogeneous size distribution. The quantification of the incorporated EO within a NC is an important step in NC characterization. In this way, an encapsulation efficiency of at least 59.03% and 41.15% of total EO-R. officinalis and EO-L. dentata, respectively, was obtained. Simple, repeatable, and reproducible methods were developed as an analytical tool for the simultaneous quantification of the main components of EO loaded in polymeric nanocapsules as well as their monitoring in biological assays.

Quantitative Aspect of Leucophyllum frutescens Fraction before and after Encapsulation in Polymeric Nanoparticles.

The interest on plants has been focalized due to their biological activities. Extracts or fractions from plants in biodegradable polymeric nanoparticles (NP) provide many advantages on application studies. The encapsulation of the extract or fraction in NP is determined for the establishment of the test dose. HPLC method is an alternative to calculate this parameter. An analytical method based on HPLC for quantification of a hexane fraction from L. frutescens was developed and validated according to ICH. Different concentrations of the hexane fraction from leaves (HFL) were prepared (100-600 µg/mL). Linearity, limit of detection, limit of quantification, and intra- and interday precision parameters were determined. HFL was encapsulated by nanoprecipitation technique and analyzed by HPLC for quantitative aspect. The method was linear and precise for the quantification of the HFL components. NP size was 190 nm with homogeneous size distribution. Through validation method, it was determined that the encapsulation of components (1), (2), (3), and (4) was 44, 74, 86, and 97%, respectively. A simple, repeatable, and reproducible methodology was developed for the propose of quantifying the components of a vegetable material loaded in NP, using as a model the hexane fraction of L. frutescens leaves.

Nanoprecipitation process: From encapsulation to drug delivery.

Drugs encapsulation is a suitable strategy in order to cope with the limitations of conventional dosage forms such as unsuitable bioavailability, stability, taste, and odor. Nanoprecipitation technique has been used in the pharmaceutical and agricultural research as clean alternative for other drug carrier formulations. This technique is based on precipitation mechanism. Polymer precipitation occurs after the addition of a non-solvent to a polymer solution in four steps mechanism: supersaturation, nucleation, growth by condensation, and growth by coagulation that leads to the formation of polymer nanoparticles or aggregates. The scale-up of laboratory-based nanoprecipitation method shows a good reproducibility. In addition, flash nanoprecipitation is a good strategy for industrial scale production of nanoparticles. Nanoprecipitation is usually used for encapsulation of hydrophobic or hydrophilic compounds. Nanoprecipitation was also shown to be a good alternative for the encapsulation of natural compounds. As a whole, process and formulation related parameters in nanoprecipitation technique have critical effect on nanoparticles characteristics. Biodegradable or non-biodegradable polymers have been used for the preparation of nanoparticles intended to in vivo studies. Literature studies have demonstrated the biodistribution of the active loaded nanoparticles in different organs after administration via various routes. In general, in vitro drug release from nanoparticles prepared by nanoprecipitation includes two phases: a first phase of "burst release" which is followed by a second phase of prolonged release. Moreover, many encapsulated active molecules have been commercialized in the pharmaceutical market.

Plant extracts: from encapsulation to application.

INTRODUCTION: Plants are a natural source of various products with diverse biological activities offering treatment for several diseases. Plant extract is a complex mixture of compounds, which can have antioxidant, antibiotic, antiviral, anticancer, antiparasitic, antifungal, hypoglycemic, anti-hypertensive and insecticide properties. The extraction of these extracts requires the use of organic solvents, which not only complicates the formulations but also makes it difficult to directly use the extracts for humans. To overcome these problems, recent research has been focused on developing new ways to formulate the plant extracts and delivering them safely with enhanced therapeutic efficacy. AREAS COVERED: This review focuses on the research done in the development and use of polymeric nanoparticles for the encapsulation and administration of plant extracts. It describes in detail, the different encapsulation techniques, main physicochemical characteristics of the nanoparticles, toxicity tests and results obtained from in vivo or in vitro assays. EXPERT OPINION: Major obstacles associated with the use of plant extracts for clinical applications include their complex composition, toxicity risks and extract instability. It is observed that encapsulation can be successfully used to decrease plant extracts toxicity, to provide targeted drug delivery and to solve stability related problems.