Metal-Organic Framework Photocatalyst Incorporating Bis(4'-(4-carboxyphenyl)-terpyridine)ruthenium(II) for Visible-Light-Driven Carbon Dioxide Reduction.

In this study, we report the successful incorporation of the photoactive bis(4'-(4-carboxyphenyl)-terpyridine)ruthenium(II) (Ru(cptpy)2) strut into a robust metal-organic framework (MOF), AUBM-4. The single crystal X-ray analysis revealed the formation of a new one-dimensional structure of Ru(cptpy)2 complexes linked together by Zr atoms that are eight coordinated with O atoms. The chemically stable MOF structure was employed as an efficient photocatalyst for carbon dioxide conversion to formate under visible light irradiation. To the best of our knowledge, the obtained conversion rate is among the highest reported in the literature for similar systems. Our strategy of using the Ru(cptpy)2 complex as a linker to construct the MOF catalyst appears to be very promising in artificial photosynthesis.

Re-evaluation of recombination losses in dye-sensitized cells: the failure of dynamic relaxation methods to correctly predict diffusion length in nanoporous photoelectrodes.

Photocurrents generated by thick, strongly absorbing, dye-sensitized cells were reduced when the electrolyte iodine concentration was increased. Electron diffusion lengths measured using common transient techniques (L(n)) were at least two times higher than diffusion lengths measured at steady state (L(IPCE)). Charge collection efficiency calculated using L(n) seriously overpredicted photocurrent, while L(IPCE) correctly predicted photocurrent. This has implications for optimizing cell design.

High photo-currents with a zwitterionic thiocyanate-free dye in aqueous-based dye sensitized solar cells.

We report a new water soluble and stable thiolate/disulfide redox couple (T(-)/DS) and its use with a new zwitterionic and thiocyanate-free dye (T169) in a 100% aqueous electrolyte system. A DSSC incorporating T169 and the T(-)/DS showed the highest photocurrents (Jsc = 13.30 mA cm(-2)) and IPCE% (84%) values reported to date. In addition, a 2000 h long-term stability measurement was performed, where Jsc and Voc of the above mentioned DSSC stayed somehow the same except for the fill factor (FF) which decreased from 0.62 to 0.48 and consequently lowered the total efficiency (from η = 4.5% on day 1 to η = 3.3% after 2000 h).

Time resolved study of three ruthenium(II) complexes at micellar surfaces: A new long excited state lifetime probe for determining critical micelle concentration of surfactant nano-aggregates.

Three different ruthenium complexes have been synthesized and their luminescence properties in different solvent environments are reported. Luminescence intensities and excited state lifetimes of Ru-I, Ru-II and Ru-III vary with solvent viscosity. The excited state lifetime of Ru-I linearly increases in the viscosity range 1.76-12,100cP. Ru-II shows two linear increases: one in the low and another in the high viscosity ranges, whereas Ru-III illustrates a linear enhancement only in the low viscosity range. Interestingly, luminescence intensities and excited state lifetimes of Ru-I, Ru-II and Ru-III are found to be sensitive to nano-aggregation. However, the surfactant head charge and that of the ruthenium center as well as the hydrophobic tail of the ancillary ligand of the complexes have a great role in deciding the nature of the interaction and on the excited state properties at micellar surfaces. It is proposed that the long lifetime of Ru-III in water could be due to the coiling of the carbon chain of the ancillary ligand around the ruthenium center. At micelle surface, this coiling of the carbon chain is lost due to the parallel alignment with surfactants and thus quenching of the excited state lifetime is seen. Furthermore, it is shown that the variation of the excited state lifetime with respect to the change in surfactant concentration is a result of the formation of micelles from the surfactant monomer, thus, a novel technique for the determination of the critical micelle concentration (cmc) based on the long excited state lifetime of Ru-III located at the micellar nano-aggregates is reported.

Anti-Inflammatory and Cytostatic Activities of a Parthenolide-Like Sesquiterpene Lactone from Cota palaestina subsp. syriaca.

A sesquiterpene lactone 1-ß,10-Epoxy-6-hydroxy-1,10H-inunolide (K100) was isolated through "bioassay-guided fractionation" from Cota palaestina subsp. syriaca, an Eastern Mediterranean endemic plant. K100 inhibited endotoxin- (ET-) induced proinflammatory markers: IL-6, MMP-9, and NO in normal mouse mammary SCp2 Cells. Molecular docking in silico suggested that K100, having highly analogous structure as parthenolide (PTL), an anticancer compound, could bind PTL target proteins at similar positions and with comparable binding affinities. Both compounds, K100 and PTL, inhibited the proliferation and prolonged the S-phase of the cell cycle of breast adenocarcinoma MDA-MB-231 cells grown in 2D cultures. Noncytotoxic concentrations of K100 and PTL decreased the proliferation rate of MDA-MB-231 and shifted their morphology from stellate to spherical colonies in 3D cultures. This was accompanied with a significant increase in the amount of small colonies and a decrease in the amount of large colonies. Moreover, K100 and PTL decreased cellular motility and invasiveness of MDA-MB-231 cells. In summary, these results suggest that K100 exhibits PTL-analogous anti-inflammatory, cytostatic, and antimetastatic effects.

Universal low-temperature MWCNT-COOH-based counter electrode and a new thiolate/disulfide electrolyte system for dye-sensitized solar cells.

A new thiolate/disulfide organic-based electrolyte system composed of the tetrabutylammonium salt of 2-methyl-5-trifluoromethyl-2H-[1,2,4]triazole-3-thiol (S(-)) and its oxidized form 3,3'-dithiobis(2-methyl-5-trifluoromethyl-2H-[1,2,4]triazole) (DS) has been formulated and used in dye-sensitized solar cells (DSSCs). The electrocatalytic activity of different counter electrodes (CEs) has been evaluated by means of measuring J-V curves, cyclic voltammetry, Tafel plots, and electrochemical impedance spectroscopy. A stable and low-temperature CE based on acid-functionalized multiwalled carbon nanotubes (MWCNT-COOH) was investigated with our S(-)/DS, I(-)/I3(-), T(-)/T2, and Co(II/III)-based electrolyte systems. The proposed CE showed superb electrocatalytic activity toward the regeneration of the different electrolytes. In addition, good stability of solar cell devices based on the reported electrolyte and CE was shown.

Photophysical properties of new cyclometalated ruthenium complexes and their use in dye sensitized solar cells.

A new class of cyclometalated ruthenium complexes, Ru(C^N^N')(N^N'^N'')·Cl where N^N'^N'' = 4,4',4''-tricarboxy-2,2':6',2''-terpyridine and C^N^N' = substituted 6-phenyl-2,2'-bipyridine, for Dye Sensitized Solar Cells (DSSCs) is proposed. We have investigated the effect of different substituents (R = COOH, thiophen-2-yl, F and OCH(3)) on the ancillary C^N^N' ligand on the photophysical properties and performance of the six different cyclometalated ruthenium complexes in DSSCs. Using an ionic liquid based electrolyte, efficiencies up to η = 3.06% have been attained under 1 sun irradiation. Moreover, the T66 based DSSC exhibited a good stability under 1000 W m(2) light soaking at 60 °C for 24 days, retaining 92.8% of its initial efficiency.

Enhancement of photocurrent in dye sensitized solar cells incorporating a cyclometalated ruthenium complex with cuprous iodide as an electrolyte additive.

A new cyclometalated ruthenium complex, [Ru(6'-phenyl-4'-thiophen-2-yl-[2,2']bipyridinyl-4-carboxylic acid)(4,4',4''-tricarboxy- 2,2':6',2''-terpyridine)]Cl, for Dye Sensitized Solar Cells (DSSCs) is proposed. We have investigated the use of cuprous iodide (CuI) as an electrolyte additive, which in turn has shown photocurrent enhancements of more than 25% in our dye based cells. Using an ionic liquid based electrolyte, an efficiency of η = 5.7% has been accomplished under 1 sun irradiation. The origin of this photocurrent enhancement upon the CuI addition was studied by means of impedance spectroscopy and cyclic voltammetry under dark conditions. The reason behind such a photocurrent enhancement is attributed to an electrocatalytic effect of the CuI on the regeneration of the oxidized dye. Furthermore, the CuI addition did not affect the recombination processes between the injected electrons and the electrolyte nor the electron lifetime in the semiconductor TiO(2) film, which in turn resulted in no changes in the photovoltage.

Application of synchronous fluorescence scan spectroscopy for size dependent simultaneous analysis of CdTe nanocrystals and their mixtures.

In this paper, synchronous fluorescence scan (SFS) spectroscopy has been applied for the first time for the simultaneous determination of a mixture of CdTe fluorescent nanocrystals (NCs) of various sizes without a pre-separation step. It is observed that synchronous fluorescence maximum correlates well with the size of the nanocrystals, i.e.; the lambda(SFS)(max) is useful to determine size dependency of NCs. Synchronous fluorescence maximum along with the second derivative can identify individual NCs in a mixture in water. The method is found to be simple, sensitive, selective and fast for NCs determination in aqueous media.

Synthesis and photophysical properties of ruthenium-based dendrimers and their use in dye sensitized solar cells.

First- and second-generation dendrimers (Ru3 and Ru6) have been synthesized, and their photophysical properties were investigated in solution and when adsorbed on the nanocrystalline TiO2 surface. The performance of Ru3 and Ru6 as charge transfer photosensitizers in nanocrytalline TiO2 based solar cells was also investigated. The best photovoltaic performance was obtained by the Ru3 based solar cell yielding a short circuit current of J sc = 5.52 mA.cm (-2) and an open circuit voltage of V oc = 626 mV, corresponding to an overall conversion efficiency of eta = 1.80% that is approximately double the conversion efficiency of the reference compound Ru1 (eta = 0.91%) and of the second generation dendrimer Ru6 (eta = 0.95%). The particular efficiency of the first generation dendrimer, Ru3, is attributed to the better light-harvesting properties of the doped nanocrystalline TiO2 film when compared to Ru1, whereas the poor performance of the second generation dendrimer, Ru6, is attributed to the uneven adsorption of all of the ruthenium moieties to the nanocrystalline TiO2 surface at the same time.

Photocurrent generation in layer-by-layer assembled dendrimers with ruthenium tris-bipyridine peripheral groups and a viologen-like core.

The photophysical and photoelectrochemical properties of first- and second-generation dendrimers with ruthenium tris-bipyridine peripheral groups and a tri-viologen like core (Ru3V3 and Ru6V3) were investigated in solution and when embedded within assembled films. The stepwise assembly of these dendrimers on quartz and ITO surfaces utilizing the layer-by-layer approach was investigated. The amount of the assembled dendrimers was found to increase on going to the higher generation dendrimer. This dendrimer generation effect was evident from the UV-vis, atomic force microscopy, and electrochemical measurements of the dendrimers in either solution phase or when embedded in films. The anodic and cathodic photocurrent generation was seen upon visible light irradiation, with higher photocurrents for Ru6V3 than Ru3V3. This observation was attributed to better light-harvesting properties, thicker films, and slower charge recombination processes in Ru6V3 when compared to Ru3V3.

Electrostatic layer-by-layer deposition of photoactive dendrimers with triviologen-like cores on their surfaces. Synthesis and electrochemical and photocurrent generation measurements.

The stepwise assembly of Fréchet-type dendrimers with naphthalene peripheral groups and positively charged viologen-like cores on quartz and ITO surfaces utilizing the layer-by-layer approach was investigated. We were able to deposit only the (+6) charged dendrimers series on ITO. The number of assembled dendrimers was found to increase as we go to higher-generation dendrimers. This dendrimer generation effect was evident from the UV-vis and electrochemical measurements of the assembled dendrimers. The half-wave potentials (E1/2) of the dendrimers shift to less negative values as the dendrimer generation increases in acetonitrile and to more negative values when assembled on ITO. Anodic photocurrent generation was seen upon light irradiation of the second- and third-generation dendrimers, NB1V3+6 and NB2V3+6, assembled on ITO but not for the zero-generation one, NV3+6. This observation was attributed to a fast charge recombination process in NV3+6 when compared to that of NB1V3+6 and NB2V3+6 dendrimers.

A dendrimer-based electron antenna: paired electron-transfer reactions in dendrimers with a 4,4'-bipyridine core and naphthalene peripheral groups.

Paired electron transfers (ET) induced by the absorption of two photons by synthetic dendrimers are observed in first-, second-, and third-generation dendrimers comprised of a viologen-like core and an array of naphthalene peripheral groups. Flash photolysis and transient absorption techniques show that the yield of photoinduced double ET depends on laser intensity in the two largest dendrimers, NBV2(+2) and NBV3(+2). Their photochemical behavior thus requires an unusual multiphoton kinetic scheme. These dendrimers constitute the first synthetic models capable of multiple electron redox events deriving from a defined molecular architecture, thus mimicking natural light-collecting antenna systems.