RESUMEN
We investigated non-invasive flow rate measurements in heating, ventilation, and air conditioning (HVAC) systems utilizing thermal transduction instead of commonly used ultrasonic techniques. The proposed thermal flow transduction comprises two temperature sensors and a heater, all mounted non-invasively on the outer surface of metal-pipes and, therefore, not disturbing the fluid flow inside. One temperature sensor measures the heater temperature, whereas the other one, mounted upstream of the heater, follows the fluid temperature for reference. The temperature difference (i.e., the heater excess temperature) depends on the fluid flow velocity and can be used to derive the mean volume flow inside the pipe. Experimental characterizations were conducted using two sensor prototypes. Beside output characteristics, other main issues such as dynamic behavior and noise density were investigated in detail. Special attention was paid to error compensation allowing measurements within a large range of fluid temperatures. Measurement results confirm the feasibility of this approach, however with some constraints regarding response time.
RESUMEN
We present a thermal flow sensor designed for measuring air as well as water flow velocities in heating, ventilation, and air conditioning (HVAC) systems. The sensor is designed to integrate the flow along the entire diameter of the pipe also quantifying the volume flow rate of the streaming fluid where the calorimetric principle in constant temperature operation is utilized as a readout method. In the constant temperature mode, a controller keeps a specific excess temperature between sensing elements at a constant level resulting in a flow dependent heater voltage. To achieve cost-effective sensors, the fabrication of the transducer is fully based on printed circuit board technology allowing low-cost mass production with different form factors. In addition, 2D-FEM simulations were carried out in order to predict the sensor characteristic of envisaged setups. The simulation enables a fast and easy way to evaluate the sensor's behaviour in different fluids. The results of the FEM simulations are compared to measurements in real environments, proving the credibility of the model.
RESUMEN
A faster treatment reduces the risk of intra-fraction movement of organs, offers a more comfortable treatment to the patient, allows to treat lesion of larger volumes in a reasonable time and most of all expands the capacity of the facility. This work presents possible machine upgrades for synchrotron based ion beam therapy centers to shorten the irradiation time. The expected delivery times for each scenario are simulated for the study case of proton beams of MedAustron. The second part of the work focuses on the MedAustron development roadmap, where recently increase of ring fillings and delivered intensities were implemented for proton treatments achieving an average irradiation time of ~50% since start of operation.