RESUMEN
As the optical communication industry advances, metropolitan area networks (MANs) and radio access networks (RANs) are extensively deployed on a large scale, demanding energy-efficient integrated light sources and simplified digital signal processing (DSP) technologies. The emergence of thin-film lithium niobate (TFLN) has given rise to high-performance, energy-efficient on-chip modulators, making on-chip optical frequency comb (OFC) more appealing. Owing to the phase uniformity and stability of this chip-scale device, it has been possible to eliminate the carrier frequency phase estimation (CPE) in DSP stacks using comb-clone-enabled self-homodyne detection. Here we report the first use, to our knowledge, of a TFLN on-chip electro-optic (EO) frequency comb to realize comb cloning and self-homodyne coherent detection. We transmit three optical pilot tones and eight data channels encoded with 20 Gbaud polarization-multiplexed 16-ary quadrature amplitude modulation (PM-16-QAM) over 10 km and 80 km standard single-mode fibers. The bit error ratios (BERs) of the eight channels reach below 10-3, a result made possible by our on-chip comb. The scalability and mass producibility of on-chip EO combs, combined with the simplified DSP, show potential in our proposed fifth-generation (5G) RAN and MAN transmission scheme.
RESUMEN
Frequency-modulated continuous wave (FMCW) light detection and ranging (lidar) is a promising solution for three-dimensional (3D) imaging and autonomous driving. This technique maps range and velocity measurement to frequency counting via coherent detection. Compared with single-channel FMCW lidar, multi-channel FMCW lidar can greatly improve the measurement rate. A chip-scale soliton micro-comb is currently used in FMCW lidar to enable multi-channel parallel ranging and significantly increase the measurement rate. However, its range resolution is limited due to the soliton comb having only a few-GHz frequency sweep bandwidth. To overcome this limitation, we propose using a cascaded modulator electro-optic (EO) frequency comb for massively parallel FMCW lidar. We demonstrate a 31-channel FMCW lidar with a bulk EO frequency comb and a 19-channel FMCW lidar using an integrated thin-film lithium niobate (TFLN) EO frequency comb. Both systems have a sweep bandwidth of up to 15 GHz for each channel, corresponding to a 1-cm range resolution. We also analyze the limiting factors of the sweep bandwidth in 3D imaging and perform 3D imaging for a specific target. The measurement rate achieved is over 12 megapixels per second, which verifies its feasibility for massively parallel ranging. Our approach has the potential to greatly benefit 3D imaging in fields where high range resolution is required, such as in criminal investigation and precision machining.