RESUMEN
We report a new class of functionalized polylutidine polymers that are prepared by chemical vapor deposition polymerization of substituted [2](1,4)benzeno[2](2,5)pyridinophanes. To prepare sufficient amounts of monomer for CVD polymerization, a new synthesis route for ethynylpyridinophane has been developed in three steps with an overall yield of 59 %. Subsequent CVD polymerization yielded well-defined films of poly(2,5-lutidinylene-co-p-xylylene) and poly(4-ethynyl-2,5-lutidinylene-co-p-xylylene). All polymers were characterized by infrared reflection-absorption spectroscopy, ellipsometry, contact angle studies, and X-ray photoelectron spectroscopy. Moreover, ζ-potential measurements revealed that polylutidine films have higher isoelectric points than the corresponding poly-xylylene surfaces owing to the nitrogen atoms in the polymer backbone. The availability of reactive alkyne groups on the surface of poly(4-ethynyl-2,5-lutidinylene-co-p-xylylene) coatings was confirmed by spatially controlled surface modification by means of Huisgen 1,3-dipolar cycloaddition. Compared to the more hydrophobic poly-p-xylylyenes, the presence of the heteroatom in the polymer backbone of polylutidine polymers resulted in surfaces that supported an increased adhesion of primary human umbilical vein endothelial cells (HUVECs). Vapor-based polylutidine coatings are a new class of polymers that feature increased hydrophilicity and increased cell adhesion without limiting the flexibility in selecting appropriate functional side groups.
RESUMEN
We report the chemical vapor deposition (CVD) of dual-functional polymer films for the specific and orthogonal immobilization of two biomolecules (notch ligand delta-like 1 (DLL1) and an RGD-peptide) that govern the fate of hematopoietic stem and progenitor cells. The composition of the CVD polymer and thus the biomolecule ratio can be tailored to investigate and optimize the influence of the relative surface concentrations of biomolecules on stem cell behavior. Prior to cell experiments, all surfaces were characterized by infrared reflection adsorption spectroscopy, time-of-flight secondary ion mass spectrometry, and X-ray photoelectron spectroscopy to confirm the presence of both biomolecules. In a proof-of-principle stem cell culture study, we show that all polymer surfaces are cytocompatible and that the proliferation of the hematopoietic stem and progenitor cells is predominantly influenced by the surface concentration of immobilized DLL1.
Asunto(s)
Materiales Biocompatibles/farmacología , Células Madre Hematopoyéticas/efectos de los fármacos , Polímeros/farmacología , Materiales Biocompatibles/síntesis química , Materiales Biocompatibles/química , Proliferación Celular , Células Cultivadas , Células Madre Hematopoyéticas/fisiología , Humanos , Péptidos y Proteínas de Señalización Intercelular/química , Oligopéptidos/química , Polimerizacion , Polímeros/síntesis química , Polímeros/química , VolatilizaciónRESUMEN
Extrusion, electrospinning, and microdrawing are widely used to create fibrous polymer mats, but these approaches offer limited access to oriented arrays of nanometer-scale fibers with controlled size, shape, and lateral organization. We show that chemical vapor polymerization can be performed on surfaces coated with thin films of liquid crystals to synthesize organized assemblies of end-attached polymer nanofibers. The process uses low concentrations of radical monomers formed initially in the vapor phase and then diffused into the liquid-crystal template. This minimizes monomer-induced changes to the liquid-crystal phase and enables access to nanofiber arrays with complex yet precisely defined structures and compositions. The nanofiber arrays permit tailoring of a wide range of functional properties, including adhesion that depends on nanofiber chirality.