The influence of cement filler load on the radiopacity of various fibre posts ex vivo.

AIM: To verify whether the filler load of luting agents influences the radiopacity of intraradicularly placed posts. METHODOLOGY: Digital radiographs of the following posts were taken: RelyX Fiber Post (3M ESPE), GC Fiber Post (GC Corporation), DT Light Post Illusion (RTD), DT Light SL Post (RTD), Endo-Composipost (RTD), FibreKleer Parallel Post (Jeneric Pentron Incorporated), FRC Postec (Ivoclar Vivadent), Parapost Taper Lux (Còltene/Whaledent AG), Radix Fiber Post (Dentsply Maillefer), EverStick Post (Stick Tech Ltd), Dentin Post X (Komet), Tech 21 X-op (Isasan), ENA Post (Micerium). Post radiopacity was measured in millimetres of aluminium (mmAl) with reference to an aluminium step wedge. Two extracted contralateral premolars were root filled. After post space preparation, taking the midpoint of the post hole as a reference, each tooth was cut longitudinally into two halves in a mesiodistal direction. On each half, the exposed root dentine was ground flat to the deepest point of the post space, and an even layer of cement was placed and light-cured. To obtain a clinically relevant layer of cement, the material thickness was reduced to 75 µm by grinding with wet abrasive paper. A cement formulation with 30 wt% of filler was tested in one premolar, whilst a formulation with 70 wt% of filler was utilized in the contralateral tooth. Posts were then placed between the two facing root halves of each premolar, and radiopacity was measured in mmAl. Data were analysed using t-test for paired samples (P < 0.05). RESULTS: Radiopacity of posts ranged between 1.44 (ENA Post) and 5.78 mmAl (FibreKleer). In the presence of the more heavily filled cement, significantly higher values of post radiopacity were measured (P < 0.001). CONCLUSION: The radiopacity of the luting agent contributed to the overall post radiovisibility within the root. Even when the cement with lower filler content was used in combination with the least radiodense dowels, the post was detectable within the root.

Nonsteroidal anti-inflammatory drugs: as inappropriate pharmacotherapy in the elderly?

Nonsteroidal anti-inflammatory drugs (NSAID) are one of the most used groups of drugs in elderly population. The aim of this study was to establish the frequency of reported disorders while using NSAID in elderly patients. A multi-centric study was conducted with a standard questionnaire for all geriatrician outpatients who were using NSAID. It has been found that out of 421 patients, 320 reported some kind of disorder; 287 of them used other drugs beside NSAID, 33 used only NSAID during the study. It has been concluded that frequency of reported disorders was significantly higher among patients who used another drug beside NSAID, and statistically most frequent reported disorders were gastrointestinal.

Post-Retained Single Crowns versus Fixed Dental Prostheses: A 7-Year Prospective Clinical Study.

Biomechanical integrity of endodontically treated teeth (ETT) is often compromised. Degree of hard tissue loss and type of final prosthetic restoration should be carefully considered when making a treatment plan. The objective of this prospective clinical trial was to assess the influence of the type of prosthetic restoration as well as the degree of hard tissue loss on 7-y clinical performance of ETT restored with fiber posts. Two groups ( n = 60) were defined depending on the type of prosthetic restoration needed: 1) single unit porcelain-fused-to-metal (PFM) crowns (SCs) and 2) 3- to 4-unit PFM fixed dental prostheses (FDPs), with 1 healthy and 1 endodontically treated and fiber post-restored abutment. Within each group, samples were divided into 2 subgroups ( n = 30) according to the amount of residual coronal tissues after abutment buildup and final preparation: A) >50% of coronal residual structure or B) equal to or <50% of coronal residual structure. The clinical outcome was assessed based on clinical and intraoral radiographic examinations at the recalls after 6, 12, 24, 36, 48, and 84 mo. Data were analyzed by Kaplan-Meier log-rank test and Cox regression analysis ( P < 0.05). The overall 7-y survival rate of ETT restored with fiber post and either SCs or FDPs was 69.2%. The highest 84-mo survival rate was recorded in group 1A (90%), whereas teeth in group 2B exhibited the lowest performance (56.7% survival rate). The log-rank test detected statistically significant differences in survival rates among the groups ( P = 0.048). Cox regression analysis revealed that the amount of residual coronal structure ( P = 0.041; hazard ratio [HR], 2.026; 95% confidence interval [CI] for HR, 1.031-3.982) and the interaction between the type of prosthetic restoration and the amount of residual coronal structure ( P = 0.024; HR, 1.372; 95% CI for HR, 1.042-1.806) were statistically significant factors for survival ( ClinicalTrials.gov NCT01532947).

Four-year Survival of Endodontically Treated Premolars Restored with Fiber Posts.

The objective of this prospective clinical trial was to investigate the influence of the residual coronal structure of endodontically treated teeth and the type of cement used for luting fiber posts on four-year clinical survival. Two groups (n = 60) were defined, depending on the amount of residual coronal dentin after abutment build-up and final preparation: (1) more than 50% of coronal residual structure; and (2) equal to or less than 50% of coronal residual structure. Within each group, teeth were randomly divided into 2 subgroups (n = 30) according to the material used for luting fiber posts: (A) resin core build-up material, Gradia Core; or (B) self-adhesive universal cement GCem Automix. The rate of success was assessed based on clinical and intra-oral radiographic examinations at the follow-up after 6, 12, 24, 36, and 48 months. The highest 48-month success and survival rates were recorded in group 1A (90% and 100%, respectively), whereas teeth in group 2B exhibited the lowest performance (63.3% success rate, 86.6% survival rate). Cox regression analysis revealed that neither the amount of coronal residual structure nor the luting material significantly influenced the failure risk (p > .05) (ClinicalTrials.gov, NCT01532947).

Influence of phosphoric acid etching on microleakage of a self-etch adhesive and a self-adhering composite.

BACKGROUND: The aim of this study was to evaluate the influence of preliminary phosphoric acid etching on the microleakage of a self-adhering flowable composite and a self-etch adhesive used in combination with the proprietary flowable composite. METHODS: Standard Class V cavities were prepared on the buccal side of 20 extracted sound human molars. Specimens were randomly divided into five groups: (1) Gel Etchant/Optibond FL/Premise Flowable; (2) Vertise Flow; (3) Optibond XTR/Premise Flowable; (4) Gel Etchant/Vertise Flow; and (5) Gel Etchant/Optibond XTR/Premise Flowable (Kerr). The interfacial sealing ability of the materials was evaluated by scoring the depth of silver nitrate penetration and through scanning electron microscopy observations. Differences in leakage at either the enamel or the dentine interface were evaluated for statistical significance (Kruskal-Wallis ANOVA, Mann-Whitney U test, p < 0.05). RESULTS: At the enamel interface, no significant differences were found among the materials. On dentine, Gel Etchant/Vertise Flow had the highest leakage scores and the difference was statistically significant (p < 0.05). CONCLUSIONS: The early sealing ability of the self-adhering flowable composite and the self-etch adhesive in Class V restorations did not significantly benefit from selective enamel etching. Preliminary phosphoric acid etching of dentine negatively affected the quality of the seal when using the adhesive-free flowable composite.