RESUMEN
Millimeter-wave components were re-examined for high power (Mega-Watt) and steady-state (greater than one hour) operation. Some millimeter-wave components, including waveguide joints, vacuum pumping sections, power monitors, sliding waveguides, and injection windows, have been improved for high power CW (Continuous Waves) transmission. To improve transmission efficiency, information about the wave phase and mode content of high power millimeter-waves propagating in corrugated waveguides, which are difficult to measure directly, were obtained by a newly developed method based on retrieved phase information. To optimize the plasma heating efficiency, a proof-of-principle study of the injection polarization feedback control was performed in the low power test stand.
RESUMEN
An instantaneous measurement system of high-power millimeter-wave was proposed and demonstrated with a 28 GHz gyrotron at the Plasma Research Center, University of Tsukuba. The high-power detector consists of an attenuator and a linear polarized microstrip antenna with an F-class load rectifier, which is a commonly used system for radio-frequency wireless power transmission. The detector obtained the power distribution of the gyrotron output beam which showed good agreement with the infrared camera image. The rectenna array detector received 45 W RF input power with a 0.4 ms response time. The results revealed that the proposed narrow band detector is useful as an imaging sensor and power meter for high-power millimeter-wave beam output with a wide wavelength range.