Dual-frequency modulated heterodyne quartz-enhanced photoacoustic spectroscopy.

A novel dual-frequency modulated heterodyne quartz-enhanced photoacoustic spectroscopy (DFH-QEPAS) was demonstrated for what we believe to be the first time in this study. In traditional H-QEPAS, the frequency of modulated sinusoidal wave has a frequency difference (Δf) with the resonance frequency (f0) of a quartz tuning fork (QTF). Owing to the resonance characteristic of QTF, it cannot excite QTF to the strongest response. To achieve a stronger response, a sinusoidal wave with a frequency of f0 was added to the modulation wave to compose a dual-frequency modulation. Acetylene (C2H2) was chosen as the target gas to verify the sensor performance. The proposed DFH-QEPAS improved 4.05 times of signal-to-noise ratio (SNR) compared with the traditional H-QEPAS in the same environmental conditions.

Hollow-waveguide-based light-induced thermoelastic spectroscopy sensing.

In this Letter, a hollow waveguide (HWG)-based light-induced thermoelastic spectroscopy (LITES) gas sensing is proposed. An HWG with a length of 65 cm and inner diameter of 4 mm was used as the light transmission medium and gas chamber. The inner wall of the HWG was coated with a silver (Ag) film to improve reflectivity. Compared with the usually used multi-pass cell (MPC), the HWG has many advantages, such as small size, simple structure and fast filling. Compared with a hollow-core anti-resonant fiber (HC-ARF), the HWG has the merits of easy optical coupling, high system stability, and wide transmission range. A diode laser with output wavelength of 1.53 µm and a quantum cascade laser (QCL) with output wavelength of 4.58 µm were selected as the sources of excitation to target acetylene (C2H2) and carbon monoxide (CO), respectively, to verify the performance of the HWG-based LITES sensor in the near-infrared and mid-infrared regions. The experimental results showed that the HWG-based LITES sensor had a great linear responsiveness to the target gas concentration. The minimum detection limit (MDL) for C2H2 and CO was 6.07 ppm and 98.66 ppb, respectively.

Acoustic microresonator based in-plane quartz-enhanced photoacoustic spectroscopy sensor with a line interaction mode.

An acoustic microresonator (AmR) based in-plane quartz-enhanced photoacoustic spectroscopy (IP-QEPAS) sensor with a line interaction mode is proposed for what is believed to be the first time. The interaction area for the acoustic wave of the proposed AmR, with a slotted sidewall, is not limited to a point of the quartz tuning fork (QTF) prongs, but extends along the whole plane of the QTF prongs. Sixteen types of AmRs are designed to identify the best parameters. Water vapor (H2O) is chosen as the analyte to verify the reported method. The results indicate that this AmR for IP-QEPAS with a line interaction mode not only provides a high signal level, but also reduces the thermal noise caused by the laser directly illuminating the QTF. Compared with standard IP-QEPAS without an AmR, the minimum detection limit (MDL) is improved by 4.11 times with the use of the technique proposed in this study.

H-shaped acoustic micro-resonator-based quartz-enhanced photoacoustic spectroscopy.

An H-shaped acoustic micro-resonator (AmR)-based quartz-enhanced photoacoustic spectroscopy (QEPAS) sensor is demonstrated for the first time. The H-shaped AmR has the advantages of easy optical alignment, high utilization of laser energy, and reduction in optical noise. The parameter of the H-shaped AmR is designed based on the standing wave enhancement characteristic. The performance of the H-shaped AmR-based QEPAS sensor system and bare quartz tuning fork (QTF)-based sensor system are measured under the same conditions by choosing water vapor (H2O) as the target gas. Compared with the QEAPS sensor based on a bare QTF, the detection sensitivity of the optimal H-shaped AmR-based QEPAS sensor exhibits a 17.2 times enhancement.

Highly Sensitive Trace Gas Detection Based on In-Plane Single-Quartz-Enhanced Dual Spectroscopy.

For this invited manuscript, an in-plane single-quartz-enhanced dual spectroscopy (IP-SQEDS)-based trace gas sensor was demonstrated for the first time. A single quartz tuning fork (QTF) was employed to combine in-plane quartz-enhanced photoacoustic spectroscopy (IP-QEPAS) with light-induced thermoelastic spectroscopy (LITES) techniques. Water vapor (H2O) was chosen as the target gas. Compared to traditional QEPAS, IP-SQEDS not only allowed for simple structures, but also obtained nearly three times signal amplitude enhancement.

Quartz-enhanced photoacoustic-photothermal spectroscopy for trace gas sensing.

A trace gas detection technique of quartz-enhanced photoacoustic-photothermal spectroscopy (QEPA-PTS) is demonstrated. Different from quartz-enhanced photoacoustic spectroscopy (QEPAS) or quartz-enhanced photothermal spectroscopy (QEPTS), which detected only one single kind of signal, QEPA-PTS was realized by adding the photoacoustic and photothermal signals generated from two quartz tuning forks (QTFs), respectively. Water vapor (H2O) with a volume concentration of 1.01% was selected as the analyte gas to investigate the QEPA-PTS sensor performance. Compared to QEPAS and QEPTS, an enhanced signal level was achieved for this QEPA-PTS system. Further improvement of such a technique was proposed.

Multi-pass quartz-enhanced photoacoustic spectroscopy-based trace gas sensing.

A multi-pass quartz-enhanced photoacoustic spectroscopy (MP-QEPAS)-based trace gas sensor is reported. In MP-QEPAS, a multi-pass laser beam pattern through the prong spacing of a quartz tuning fork (QTF) is obtained by means of two right-angle prisms. A large QTF with the prong length of 17 mm and prong spacing of 0.8 mm was employed to increase the passage of multi-pass time and ease the alignment of the beam reflection pattern through the QTF. This multi-pass configuration allows the laser beam to pass through the QTF prong spacing six times. Water vapor (H2O) was chosen as target gas to investigate the performance of the MP-QEPAS sensor. Compared to a conventional QEPAS measurement, the MP-QEPAS technique provided an enhancement of signal level of ∼3.2 times.

Ultra-Highly Sensitive Hydrogen Chloride Detection Based on Quartz-Enhanced Photothermal Spectroscopy.

Combining the merits of non-contact measurement and high sensitivity, the quartz-enhanced photothermal spectroscopy (QEPTS) technique is suitable for measuring acid gases such as hydrogen chloride (HCl). In this invited paper, we report, for the first time, on an ultra-highly sensitive HCl sensor based on the QEPTS technique. A continuous wave, distributed feedback (CW-DFB) fiber-coupled diode laser with emission wavelength of 1.74 µm was used as the excitation source. A certified mixture of 500 ppm HCl:N2 was adapted as the analyte. Wavelength modulation spectroscopy was used to simplify the data processing. The wavelength modulation depth was optimized. The relationships between the second harmonic (2f) amplitude of HCl-QEPTS signal and the laser power as well as HCl concentration were investigated. An Allan variance analysis was performed to prove that this sensor had good stability and high sensitivity. The proposed HCl-QEPTS sensor can achieve a minimum detection limit (MDL) of ~17 parts per billion (ppb) with an integration time of 130 s. Further improvement of such an HCl-QEPTS sensor performance was proposed.

Quartz tuning forks resonance frequency matching for laser spectroscopy sensing.

In this paper, we report on the performance of quartz tuning fork (QTF) based laser spectroscopy sensing employing multiple QTFs. To avoid that resonance frequency mismatching of the QTFs degrades the sensor performance, two types of resonance frequency matching method are here proposed. A system based on the coupling of two sensing modules, one based on quartz-enhanced photoacoustic spectroscopy (QEPAS) and one on light-induced thermoelastic spectroscopy (LITES) technique, was realized to validate the proposed methods. Each module employed a different QTF (QTF1 and QTF2, respectively). Operating temperature or pressure of QTF2 were regulated to match the resonance frequency of QTF1, which operated at 25.0 °C and atmospheric pressure. Without regulation, the difference between QTF1 and QTF2 resonance frequencies was 2.42 Hz and the superposition coefficient η was only 54.7%. When the temperature regulation was carried out, at a QTF2 operating temperature of 67.5 °C, an optimal η value of 95.0% was obtained. For the pressure regulation approach, if operating QTF2 at pressure of 500 Torr, η reached a value of 97.2%. The obtained results show that the proposed two methods are effective in resonance frequency matching of QTFs for gas sensing systems.

Quartz tuning fork-based demodulation of an acoustic signal induced by photo-thermo-elastic energy conversion.

A gas sensing method based on quartz-enhanced photothermal spectroscopy (QEPTS) demodulated by quartz tuning fork (QTF) sensing acoustic wave is reported for the first time. Different from traditional QEPTS, the method proposed in this paper utilizes the second QTF to sense acoustic wave produced by the first QTF owing to the vibration resulted from photo-thermo-elastic effect. This indirect demodulation by acoustic wave sensing can avoid QTF being irradiated by laser beam and therefore get less noise and realize better detection sensitivity. Four different sensing configurations are designed and verified. Acetylene (C2H2) with a volume concentration of 1.95 % is selected as the target gas. A model of sound field produced by the first QTF vibrating is established by finite element method to explain the variation trend of signal and noise in the second QTF. The measured results indicate that this technique had an enhanced signal-to-noise ratio (SNR) of 1.36 times when compared to the traditional QEPTS. Further improvement methods for such technique is proposed.