Enhancing Electrochemical CO2 Reduction on Perovskite Oxide for Solid Oxide Electrolysis Cells through In Situ A-Site Deficiencies and Surface Carbonate Deposition Induced by Lithium Cation Doping and Exsolution.

Solid oxide electrolysis cells (SOECs) hold enormous potential for efficient conversion of CO2 to CO at low cost and high reaction kinetics. The identification of active cathodes is highly desirable to promote the SOEC's performance. This study explores a lithium-doped perovskite La0.6- x Lix Sr0.4 Co0.7 Mn0.3 O3-δ (x = 0, 0.025 0.05, and 0.10) material with in situ generated A-site deficiency and surface carbonate as SOEC cathodes  for CO2 reduction. The experimental results indicate that the SOEC with the La0.55 Li0.05 Sr0.4 Co0.7 Mn0.3 O3-δ cathode exhibits a current density of 0.991 A cm-2 at 1.5 V/800 °C, which is an improvement of ≈30% over the pristine sample. Furthermore, SOECs based on the proposed cathode demonstrate excellent stability over 300 h for pure CO2 electrolysis. The addition of lithium with high basicity, low valance, and small radius, coupled with A-site deficiency, promotes the formation of oxygen vacancy and modifies the electronic structure of active sites, thus enhancing CO2 adsorption, dissociation process, and CO desorption steps as corroborated by the experimental analysis and the density functional theory calculation. It is further confirmed that Li-ion migration to the cathode surface forms carbonate and consequently provides the perovskite cathode with an impressive anti-carbon deposition capability, as well as electrolysis activity.

Revealing the detrimental CO2 reduction effect of La0.6Sr0.4FeO3-δ-derived heterostructure in solid oxide electrolysis cells.

Solid oxide electrolysis cells hold unique Faraday efficiency and favored thermodynamic/kinetics for CO2 reduction to CO. Perovskite oxide-based composite materials are promising alternatives to Ni-based cermet electrodes in SOECs. However, contrary results of the electrocatalytic activity over single-phase perovskite oxide exist and the rationale of the negative effect is not well revealed. In this work, two-phase perovskite materials with various complementary properties and unique interfaces are self-assembled, which was realized by "subtractive" defect-driven phase separation. The obtained heterostructure electrodes showed reduced performance over that of single-phase materials although the cyclic stability was improved. The main reasons for the performance degradation are the decrease of electrical conductivity, oxygen vacancy concentration while increasing the average valence state of B-site Fe cations, and electrode surface Sr aggregation. This work highlights the self-assembly method and insight into the rational design and synthesis of active electrodes/catalysts for CO2 conversion in solid oxide cells.