Tunable single- and dual-wavelength SHG from diode-pumped PPKTP waveguides.

A compact, all-room-temperature, widely tunable, continuous wave laser source in the green spectral region (502.1-544.2 nm) with a maximum output power of 14.7 mW is demonstrated. This was made possible by utilizing second-harmonic generation (SHG) in a periodically poled potassium titanyl phosphate (PPKTP) crystal waveguide pumped by a quantum-well external-cavity fiber-coupled diode laser and exploiting the multimode-matching approach in nonlinear crystal waveguides. The dual-wavelength SHG in the wavelength region between 505.4 and 537.7 nm (with a wavelength difference ranging from 1.8 to 32.3 nm) and sum-frequency generation in a PPKTP waveguide is also demonstrated.

A comb laser-driven DWDM silicon photonic transmitter based on microring modulators.

We demonstrate concurrent multi-channel transmission at 10 Gbps per channel of a DWDM silicon photonic transmitter. The DWDM transmitter is based on a single quantum dot comb laser and an array of microring resonator-based modulators. The resonant wavelengths of microrings are thermally tuned to align with the wavelengths provided by the comb laser. No obvious crosstalk is observed at 240 GHz channel spacing.

Picosecond pulse amplification up to a peak power of 42 W by a quantum-dot tapered optical amplifier and a mode-locked laser emitting at 1.26 µm.

We experimentally study the generation and amplification of stable picosecond-short optical pulses by a master oscillator power-amplifier configuration consisting of a monolithic quantum-dot-based gain-guided tapered laser and amplifier emitting at 1.26 µm without pulse compression, external cavity, gain- or Q-switched operation. We report a peak power of 42 W and a figure-of-merit for second-order nonlinear imaging of 38.5 W2 at a repetition rate of 16 GHz and an associated pulse width of 1.37 ps.

Two-state semiconductor laser self-mixing velocimetry exploiting coupled quantum-dot emission-states: experiment, simulation and theory.

We exploit the coupled emission-states of a single-chip semiconductor InAs/GaAs quantum-dot laser emitting simultaneously on ground-state (λ(GS) = 1245 nm) and excited-state (λ(ES) = 1175 nm) to demonstrate coupled-two-state self-mixing velocimetry for a moving diffuse reflector. A 13 Hz-narrow Doppler beat frequency signal at 317 Hz is obtained for a reflector velocity of 3 mm/s, which exemplifies a 66-fold improvement in width as compared to single-wavelength self-mixing velocimetry. Simulation results reveal the physical origin of this signal, the coupling of excited-state and ground-state photons via the carriers, which is unique for quantum-dot lasers and reproduce the experimental results with excellent agreement.

Efficient yellow-green light generation at 561 nm by frequency-doubling of a QD-FBG laser diode in a PPLN waveguide.

A compact high-power yellow-green continuous wave (CW) laser source based on second-harmonic generation (SHG) in a 5% MgO doped periodically poled congruent lithium niobate (PPLN) waveguide crystal pumped by a quantum-dot fiber Bragg grating (QD-FBG) laser diode is demonstrated. A frequency-doubled power of 90.11 mW at the wavelength of 560.68 nm with a conversion efficiency of 52.4% is reported. To the best of our knowledge, this represents the highest output power and conversion efficiency achieved to date in this spectral region from a diode-pumped PPLN waveguide crystal, which could prove extremely valuable for the deployment of such a source in a wide range of biomedical applications.

VECSEL gain characterization.

We present the first full gain characterization of two vertical external cavity surface emitting laser (VECSEL) gain chips with similar designs operating in the 960-nm wavelength regime. We optically pump the structures with continuous-wave (cw) 808-nm radiation and measure the nonlinear reflectivity for 130-fs and 1.4-ps probe pulses as function of probe pulse fluence, pump power, and heat sink temperature. With this technique we are able to measure the saturation behavior for VECSEL gain chips for the first time. The characterization with 1.4-ps pulses resulted in saturation fluences of 40-80 µJ/cm2, while probing with 130-fs pulses yields reduced saturation fluences of 30-50 µJ/cm2 for both structures. For both pulse durations this is lower than previously assumed. A small-signal gain of up to 5% is obtained with this technique. Furthermore, in a second measurement setup, we characterize the spectral dependence of the gain using a tunable cw probe beam. We measure a gain bandwidth of over 26 nm for both structures, full width at half maximum.

P-i-n junction quantum dot saturable absorber mirror: electrical control of ultrafast dynamics.

We report on nonlinear optical properties of a p-i-n junction quantum dot saturable absorber based on InGaAs/GaAs. Absorption recovery dynamics and nonlinear reflectivity are investigated for different reverse bias and pump power conditions. A decrease in absorption recovery time of nearly two orders of magnitude is demonstrated by applying a voltage between 0 and -20 V. The saturable absorber modulation depth and saturation fluence are found to be independent from the applied reverse bias.

Femtosecond high-power quantum dot vertical external cavity surface emitting laser.

We report on the first femtosecond vertical external cavity surface emitting laser (VECSEL) exceeding 1 W of average output power. The VECSEL is optically pumped, based on self-assembled InAs quantum dot (QD) gain layers, cooled efficiently using a thin disk geometry and passively modelocked with a fast quantum dot semiconductor saturable absorber mirror (SESAM). We developed a novel gain structure with a flat group delay dispersion (GDD) of ± 10 fs2 over a range of 30 nm around the designed operation wavelength of 960 nm. This amount of GDD is several orders of magnitude lower compared to standard designs. Furthermore, we used an optimized positioning scheme of 63 QD gain layers to broaden and flatten the spectral gain. For stable and self-starting pulse formation, we have employed a QD-SESAM with a fast absorption recovery time of around 500 fs. We have achieved 1 W of average output power with 784-fs pulse duration at a repetition rate of 5.4 GHz. The QD-SESAM and the QD-VECSEL are operated with similar cavity mode areas, which is beneficial for higher repetition rates and the integration of both elements into a modelocked integrated external-cavity surface emitting laser (MIXSEL).

Broadly tunable high-power InAs/GaAs quantum-dot external cavity diode lasers.

A record broadly tunable high-power external cavity InAs/GaAs quantum-dot diode laser with a tuning range of 202 nm (1122 nm-1324 nm) is demonstrated. A maximum output power of 480 mW and a side-mode suppression ratio greater than 45 dB are achieved in the central part of the tuning range. We exploit a number of strategies for enhancing the tuning range of external cavity quantum-dot lasers. Different waveguide designs, laser configurations and operation conditions (pump current and temperature) are investigated for optimization of output power and tunability.

Dual-wavelength mode-locked quantum-dot laser, via ground and excited state transitions: experimental and theoretical investigation.

We report a dual-wavelength passive mode locking regime where picosecond pulses are generated from both ground (lambda = 1263 nm) and excited state transitions (lambda = 1180 nm), in a GaAs-based monolithic two-section quantum-dot laser. Moreover, these results are reproduced by numerical simulations which provide a better insight on the dual-wavelength mode-locked operation.