Tunable nanomechanical performance regimes in ceramic nanowires.

At the macroscopic size regime, ceramic materials exhibit brittle fracture and catastrophic failure when they are subjected to mechanical loads that exceed their characteristic strength. In this report, we present recoverable plasticity in alpha-phase, potassium stabilized manganese dioxide nanowire (α-K0.13MnO2 NW) crystals when they are subjected to atomic force microscopy (AFM) based three-point bending tests at very low loading rates. The force-deflection curves and AFM scans obtained from these measurements reveal yielding and extended plasticity in the NWs during the loading process, while the large plastic deformation is recovered spontaneously during the unloading process. However, the same material system exhibits failure via fracture at substantially higher strengths when it is subjected to bending tests at nearly an order of magnitude higher loading rates. These results highlight an important new pathway to controllably tune the nanomechanical performance of these technologically important nanoceramics for application-specific needs: either achieve self-reversible and ultra-large plasticity, or achieve substantially higher fracture strengths that approach the intrinsic limits of the material system.

Plastic recovery and self-healing in longitudinally twinned SiGe nanowires.

This paper reports on plastic recovery and self-healing behavior in longitudinally-twinned and [112] orientated SiGe nanowire (NW) beams when they are subjected to large bending strains. The NW alloys are comprised of lamellar nanotwin platelet(s) sandwiched between two semi-cylindrical twins. The loading curves, which are acquired from atomic force microscope (AFM) based three-point bending tests, reveal the onset of plastic deformation at a characteristic stress threshold, followed by further straining of the NWs. This ductility is attributed to dislocation activity within the semi-cylindrical crystal portions of the NW, which are hypothesized to undergo a combination of elastic and plastic straining. On the other hand, the lamellar nanoplatelets undergo purely elastic stretching. During the unloading process, the release of internal elastic stresses enables dislocation backflow and escape at the surface. As a result, the dislocations are predominantly annihilated and the NW samples evidenced self-healing via plastic recovery even at ultra-large strains, which are estimated using finite-element models at 16.3% in one of the tested devices. Finite element analysis also establishes the independence of the observed nanomechanical behavior on the relative orientation of the load with respect to the nanoplatelet. This first observation of reversible plasticity in the SiGe material system, which is aided by a concurrent evolution of segmented elastic and plastic deformation within its grains during the loading process, presents an important new pathway for mechanical stabilization of technologically important group-IV semiconductor nanomaterials.

Brittle fracture to recoverable plasticity: polytypism-dependent nanomechanics in todorokite-like nanobelts.

Atomic force microscopy (AFM) based nanomechanics experiments involving polytypic todorokite-like manganese dioxide nanobelts reveal varied nanomechanical performance regimes such as brittle fracture, near-brittle fracture, and plastic recovery within the same material system. These nanobelts are synthesized through a layer-to-tunnel material transformation pathway and contain one-dimensional tunnels, which run along their longitudinal axis and are enveloped by m × 3 MnO6 octahedral units along their walls. Depending on the extent of material transformation towards a tunneled microstructure, the nanobelts exhibit stacking disorders or polytypism where the value for m ranges from 3 to up to ∼20 within different cross-sectional regions of the same nanobelt. The observation of multiple nanomechanical performance regimes within a single material system is attributed to a combination of two factors: (a) the extent of stacking disorder or polytypism within the nanobelts, and (b) the loading (or strain) rate of the AFM nanomechanics experiment. Controllable engineering of recoverable plasticity is a particularly beneficial attribute for advancing the mechanical stability of these ceramic materials, which hold promise for insertion in multiple next-generation technological applications that range from electrical energy storage solutions to catalysis.