Numerical Analysis for Light Absorption Spectra of the Base of DNA-Wrapped Single-Walled Carbon Nanotubes.

This study numerically demonstrates the light absorption spectra of each base of DNA-wrapped single-walled carbon nanotubes (SWCNTs). Previous experimental and theoretical studies show that the optical properties of these composites are different from the bare SWCNTs. In this work, we investigated the bases of DNA that influence optical properties. To obtain stable molecular states for studying optical properties, molecular dynamics calculations were performed. Additionally, light absorption spectra in the ultraviolet-to-near-infrared region of one type of base-wrapped (e.g., adenine-, thymine-, cytosine-, or guanine-wrapped) SWCNTs were investigated by utilizing the semi-empirical molecular orbital theory using SCIGRESS commercial software. This method can significantly reduce the calculation time compared to the ab initio molecular orbital method, making the handling of composites of bases and SWCNTs possible. We found that the largest peaks appear at a wavelength of around 300 nm for all the composites. Furthermore, we found that the light absorption spectra above 570 nm are strongly influenced by adenine and cytosine. Thus, our computational results provide insight into the optical properties and the effects of base-SWCNTs that are difficult to investigate experimentally under the influence of solvents and various molecules.

An Efficient Method of Observing Diatom Frustules via Digital Holographic Microscopy.

Herein, we propose a convenient method to enable pretreatment of target objects using digital holographic microscopy (DHM). As a test sample, we used diatom frustules (Nitzschia sp.) as the target objects. In the generally used sample preparation method, the frustule suspension is added dropwise onto a glass substrate or into a glass chamber. While our work confirms good observation of purified frustules using the typical sample preparation method, we also demonstrate a new procedure to observe unseparated structures of frustules prepared by baking them on a mica surface. The baked frustules on the mica surface were transferred to a glass chamber with 1% sodium dodecyl sulfate solution. In this manner, the unseparated structures of the diatom frustules were clearly observed. Furthermore, metal-coated frustules prepared by sputtering onto them on a mica surface were also clearly observed using the same procedure. Our method can be applied for the observation of any target object that is pretreated on a solid surface. We expect our proposed method to be a basis for establishing DHM techniques for microscopic observations of biomaterials.

Glycolysis plays an important role in energy transfer from the base to the distal end of the flagellum in mouse sperm.

Many studies have been conducted to elucidate the relationship between energy metabolic pathways (glycolysis and respiration) and flagellar motility in mammalian sperm, but the contribution of glycolysis to sperm motility has not yet been fully elucidated. In the present study, we performed detailed analysis of mouse sperm flagellar motility for further understanding of the contribution of glycolysis to mammalian sperm motility. Mouse sperm maintained vigorous motility in the presence of substrates either for glycolysis or for respiration. By contrast, inhibition of glycolysis by alpha-chlorohydrine caused a significant decrease in the bend angle of the flagellar bending wave, sliding velocity of outer doublet microtubules and ATP content even in the presence of respiratory substrates (pyruvate or ß-hydroxybutyrate). The decrease of flagellar bend angle and sliding velocity are prominent in the distal part of the flagellum, indicating that glycolysis inhibition caused the decrease in ATP concentration threrein. These results suggest that glycolysis potentially acts as a spatial ATP buffering system, transferring energy (ATP) synthesized by respiration at the mitochondria located in the basal part of the flagellum to the distal part. In order to validate that glycolytic enzymes can transfer high energy phosphoryls, we calculated intraflagellar concentration profiles of adenine nucleotides along the flagellum by computer simulation analysis. The result demonstrated the involvement of glycolysis for maintaining the ATP concentration at the tip of the flagellum. It is likely that glycolysis plays a key role in energy homeostasis in mouse sperm not only through ATP production but also through energy transfer.

Super-Resolution Live Imaging of Cargo Traffic Through the Golgi Apparatus in Mammalian Cells.

Super-resolution confocal live imaging microscopy (SCLIM) we developed provides high-speed, high-resolution, three- and four-dimensional, and multicolor simultaneous imaging. Using this technology, we are now able to observe the fine details of various dynamic events going on in living cells, such as membrane traffic and organelle dynamics. The retention using selective hooks (RUSH) system is a powerful tool to control synchronous release of natural cargo proteins of interest from the endoplasmic reticulum in mammalian cells. In this chapter, we describe a method for visualizing secretory cargo traffic within and around the Golgi apparatus in HeLa cells using SCLIM in combination with the RUSH assay.

X-ray diffraction recording from single axonemes of eukaryotic flagella.

We report the first X-ray diffraction patterns recorded from single axonemes of eukaryotic flagella with a diameter of only <0.2 µm, by using the technique of cryomicrodiffraction. A spermatozoon isolated from the testis of a fruit fly, Drosophila melanogaster, either intact or demembranated, was mounted straight in a glass capillary, quickly frozen and its 800-µm segment was irradiated end-on with intense synchrotron radiation X-ray microbeams (diameter, ~2 µm) at 74 K. Well-defined diffraction patterns were recorded, consisting of a large number of isolated reflection spots, extending up to 1/5 nm(-1). These reflections showed a tendency to peak every 20°, i.e., the patterns had features of an 18-fold rotational symmetry as expected from the 9-fold rotational symmetry of axonemal structure. This means that the axonemes remain untwisted, even after the manual mounting procedure. The diffraction patterns were compared with the results of model calculations based on a published electron micrograph of the Drosophila axoneme. The comparison provided information about the native state of axoneme, including estimates of axonemal diameter, interdoublet spacing, and masses of axonemal components relative to those of microtubules (e.g., radial spokes, dynein arms, and proteins associated with accessory singlet microtubules). When combined with the genetic resource of Drosophila, the technique presented here will serve as a powerful tool for studying the structure-function relationship of eukaryotic flagella in general.

A Review of Applications Using Mixed Materials of Cellulose, Nanocellulose and Carbon Nanotubes.

Carbon nanotubes (CNTs) have been extensively studied as one of the most interesting nanomaterials for over 25 years because they exhibit excellent mechanical, electrical, thermal, optical, and electrical properties. In the past decade, the number of publications and patents on cellulose and nanocellulose (NC) increased tenfold. Research on NC with excellent mechanical properties, flexibility, and transparency is accelerating due to the growing environmental problems surrounding us such as CO2 emissions, the accumulation of large amounts of plastic, and the depletion of energy resources such as oil. Research on mixed materials of cellulose, NC, and CNTs has been expanding because these materials exhibit various characteristics that can be controlled by varying the combination of cellulose, NC to CNTs while also being biodegradable and recyclable. An understanding of these mixed materials is required because these characteristics are diverse and are expected to solve various environmental problems. Thus far, many review papers on cellulose, NC or CNTs have been published. Although guidance for the suitable application of these mixed materials is necessary, there are few reviews summarizing them. Therefore, this review introduces the application and feature on mixed materials of cellulose, NC and CNTs.

Unique observation method of temperature dependence of diatom floating by direct microscope.

Diatoms are one of the earth's major oxygen producers. For that reason, studying the floating phenomena of living diatom cells in water is an important research subject. Efficiency of photosynthesis of diatom cells may be heavily affected by their floating behavior. In our previous research, we devised a 'tumbled' microscope, a device created by tilting an inverted microscope (CKX53, OLYMPUS) by 90 degrees, due to which allowed observation with a sample stage perpendicular to the ground. When we observed a Petri dish filled with diatom cell suspension, the floating behavior of diatom cells were well visualized. Cyclotella meneghiniana was isolated and subcultured in bold modified basal freshwater nutrient solution liquid medium (B5282-500ML, Sigma-Aldrich) at 18 °C. Before the microscopic observation, cell suspension was cultured for two weeks after the final subculture. Observation was performed at room temperature, 30 °C, and 40 °C with a temperature sensor in the center of the chamber (inside). Observations were started as soon as the sample was installed. In a typical image obtained using the tumbled microscope, the diatom cells were found to move from the top to the bottom. In order to analyze floating velocity and trajectory, observation was continued for 35 min at room temperature, 30 °C, and 40 °C. Tracking analysis was carried out using the two-dimensional motion image measurement software Move-tr/2D. The average speed of 100 cells was 7.0 ± 4.3 µm/s at room temperature, 85.6 ± 31.9 µm/s at 30 °C and 470.1 ± 279.8 µm/s at 40 °C. In this study, we devised the unique observation to visualize the temperature dependence of diatom cells.

Quick shear-flow alignment of biological filaments for X-ray fiber diffraction facilitated by methylcellulose.

X-ray fiber diffraction is one of the most useful methods for examining the structural details of live biological filaments under physiological conditions. To investigate biologically active or labile materials, it is crucial to finish fiber alignment within seconds before diffraction analysis. However, the conventional methods, e.g., magnetic field alignment and low-speed centrifugations, are time-consuming and not very useful for such purposes. Here, we introduce a new alignment method using a rheometer with two parallel disks, which was applied to observe fiber diffractions of axonemes, tobacco mosaic tobamovirus, and microtubules. We found that fibers were aligned within 5 s by giving high shear flow (1000-5000 s(-1)) to the medium and that methylcellulose contained in the medium (approximately 1%) was essential to the accomplishment of uniform orientation with a small angular deviation (<5 degrees). The new alignment method enabled us to execute structure analyses of axonemes by small-angle x-ray diffraction. Since this method was also useful for the quick alignment of purified microtubules, as well as tobacco mosaic tobamovirus, we expect that we can apply it to the structural analysis of many other biological filaments.

Radial stiffness characteristics of the overlap regions of sarcomeres in isolated skeletal myofibrils in pre-force generating state.

We have studied the stiffness of myofilament lattice in sarcomeres in the pre-force generating state, which was realized by a relaxing reagent, BDM (butane dione monoxime). First, the radial stiffness for the overlap regions of sarcomeres of isolated single myofibrils was estimated from the resulting decreases in diameter by osmotic pressure applied with the addition of Dextran. Then, the radial stiffness was also estimated from force-distance curve measurements with AFM technology. The radial stiffness for the overlap regions thus obtained was composed of a soft and a rigid component. The soft component visco-elastically changed in a characteristic fashion depending on the physiological conditions of myofibrils, suggesting that it comes from cross-bridge structures. BDM treatments significantly affected the soft radial component of contracting myofibrils depending on the approach velocity of cantilever: It was nearly equal to that in the contracting state at high approach velocity, whereas as low as that in the relaxing state at low approach velocity. However, comparable BDM treatments greatly suppressed the force production and the axial stiffness in contracting glycerinated muscle fibers and also the sliding velocity of actin filaments in the in vitro motility assay. Considering that BDM shifts the cross-bridge population from force generating to pre-force generating states in contracting muscle, the obtained results strongly suggest that cross-bridges in the pre-force generating state are visco-elastically attached to the thin filaments in such a binding manner that the axial stiffness is low but the radial stiffness significantly high similar to that in force generating state.

Chemotactic response with a constant delay-time mechanism in Ciona spermatozoa revealed by a high time resolution analysis of flagellar motility.

During their chemotactic swimming toward eggs, sperm cells detect their species-specific chemoattractant and sense concentration gradients by unknown mechanisms. After sensing the attractant, sperm cells commonly demonstrate a series of responses involving different swimming patterns by changing flagellar beats, gradually approaching a swimming path toward the eggs, which is the source of chemoattractants. Shiba et al. observed a rapid increase in intracellular Ca(2+) concentrations in Ciona spermatozoa after sensing chemoattractants; however, the biochemical processes occurring inside the sperm cells are unclear. In the present study, we focused on the timing and sensing mechanism of chemical signal detection in Ciona. One of the most crucial problems to be solved is defining the initial epoch of chemotactic responses. We adopted a high rate of video recording (600 Hz) for detailed analysis of sperm motion and a novel method for detecting subtle signs of beat forms and moving paths of sperm heads. From these analyses, we estimated a virtual sensing point of the attractant before initiation of motility responses and found that the time delay from sensing to motility responses was almost constant. To evaluate the efficiency of this constant delay model, we performed computer simulation of chemotactic behaviors of Ciona spermatozoa.

Radial stability of the actomyosin filament lattice in isolated skeletal myofibrils studied using atomic force microscopy.

The radial stability of the actomyosin filament lattice in skeletal myofibrils was examined by using atomic force microscopy. The diameter and the radial stiffness of the A-band region were examined based on force-distance curves obtained for single myofibrils adsorbed onto cover slips and compressed with the tip of a cantilever and with the Dextran treatment. The results obtained indicated that the A-band is composed of a couple of stiffness components having a rigid core-like component. It was further clarified that these radial components changed the thickness as well as the stiffness depending on the physiological condition of myofibrils. Notably, by decreasing the ionic strength, the diameter of the A-band region became greatly shrunken, but the rigid core-like component thickened, indicating that the electrostatic force distinctly affects the radial structure of actomyosin filament components. The results obtained were analyzed based on the elementary structures of the filament lattice composed of cross-bridges, thin filaments and thick filament backbones. It was clarified that the actomyosin filament lattice is radially deformable greatly and that (1), under mild compression, the filament lattice is stabilized primarily by the interactions of myosin heads with thin filaments and thick filament backbones, and (2), under severe compression, the electrostatic repulsive interactions between thin filaments and thick filament backbones became predominant.