RESUMEN
The comprehensive understanding of the orientation of antibodies on a solid surface is crucial for affinity-based sensing mechanisms. In this study, we demonstrated that the orientation of primary antibodies modified on carboxy-functionalized polystyrene (PS) particles can be analyzed using zeta potential behavior at different pH based on the combined Gouy-Chapman-Stern model and the acid dissociation of carboxy groups and antibodies. We observed that at low surface concentrations of the primary antibody, a side-on orientation was predominant. However, at higher concentrations (approximately 30000 antibodies per PS particle), the orientation shifted to an end-on type due to steric hindrance. Furthermore, the reaction mechanism of the secondary antibody exhibited pH-dependent behavior. At pH > 7, the zeta potential changes were attributed to the antibody-antibody reaction, whereas at pH < 7, adsorption of secondary antibody onto the PS particle was observed, leading to a change in the orientation of the primary antibody modified on the PS particle to an end-on type. The change in zeta potential due to secondary antibody binding indicated a detection limit of 37000 antibodies per PS particle. As a result, we revealed that the analysis of zeta potential behavior enables the evaluation of antibody orientation and the detection of zeptomole order antibodies. This study represents the first demonstration of this capability. We anticipate that the present concept and results will broaden the quantitative application of zeta potential measurements and have significant implications for research areas, including physical chemistry and analytical chemistry.
RESUMEN
We demonstrated for the first time that interfacial tension measurements can be used to evaluate the kinetics of the solvent extraction of metal ions. The Eu(III) extraction mechanism in the nitrate ion/tributyl phosphate (TBP) system was investigated on the basis of dynamic interfacial tension. Interestingly, the interfacial tension of the TBP droplet (γ) increased with Eu(III) extraction. This behavior can be explained by the electrocapillary effect. The time dependence of γ was kinetically analyzed, and we demonstrated that the rate-determining process was the interfacial reaction of Eu(III). Furthermore, the dependence of the mass transfer rate constant upon the concentration of the nitrate ions revealed that two nitrate ions were involved in the interfacial reaction during Eu(III) extraction. However, no change in the rate constant upon TBP concentration was observed, because the change in the TBP concentration did not affect the electrocapillary effect. We determined the forward and backward reaction rates to be k1 = (1.5 ± 0.7) × 10-6 m M-2 s-1 and k-MT = (6.9 ± 3.9) × 10-7 m s-1. Therefore, for the first time, we demonstrated that dynamic interfacial tension, which is involved in the electrocapillary effect, can be used to elucidate the kinetics of Eu(III) extraction. We expect that this study will attract the attention of researchers in several fields, including physical and analytical chemistry.
RESUMEN
Understanding mass transfer kinetics within individual porous particles is crucial for theoretically explaining the retention and elution behaviors in chromatography and drug delivery. Using laser trapping and fluorescence microspectroscopy, we investigated the diffusion mechanism of coumarin 102 (C102) into single octadecylsilyl particle in acetonitrile (ACN)/water, N,N-dimethylformamide (DMF)/water, and 1-butanol (BuOH)/water solutions. The intraparticle diffusion behavior of C102 was evaluated using the spherical diffusion equation, allowing us to determine the intraparticle diffusion coefficients (Dintra): (8-10) × 10-9 cm2 s-1 for ACN, (10-16) × 10-9 cm2 s-1 for DMF, and (4-6) × 10-9 cm2 s-1 for BuOH. The obtained Dintra values were further analyzed using a pore and surface diffusion model. Thus, we revealed that the diffusion mechanism of C102 differed depending on the organic solvent: surface diffusion for ACN and DMF and pore and surface diffusions for BuOH were observed. This difference is attributed to the formation of a concentrated liquid phase of ACN and DMF at the interface of the alkyl chain and the bulk solution in the pore.
RESUMEN
This study elucidates the mass transfer mechanism of myoglobin (Mb) within a single silica particle with a 50 nm pore size at various pH levels (6.0, 6.5, 6.8, and 7.0). Investigation of Mb distribution ratio (R) and distribution kinetics was conducted using absorption microspectroscopy. The highest R was observed at pH 6.8, near the isoelectric point of Mb, as the electrostatic repulsion between Mb molecules on the silica surface decreased. The time-course absorbance of Mb in the silica particle was rigorously analyzed based on a first-order reaction, yielding the intraparticle diffusion coefficient of Mb (Dp). Dp-(1 + R)-1 plots at different pH values were evaluated using the pore and surface diffusion model. Consequently, we found that at pH 6.0, Mb diffused in the silica particle exclusively through surface diffusion, whereas pore diffusion made a more substantial contribution at higher pH. Furthermore, we demonstrated that Mb diffusion was hindered by slow desorption, associated with the electrostatic charge of Mb. This comprehensive analysis provides insights into the diffusion mechanisms of Mb at acidic, neutral, and basic pH conditions.
RESUMEN
We investigated the diffusion behavior of rhodamine 6G (Rh6G) within single octadecylsilyl-functionalized (ODS) silica particle in an acetonitrile (ACN)/water system using fluorescence correlation spectroscopy (FCS). FCS measurements were conducted at the center of the particle to exclusively determine the intraparticle diffusion coefficient (D). The obtained D values were analyzed based on a pore and surface diffusion model, the results of which indicate that surface diffusion primarily governs the intraparticle diffusion of Rh6G. Furthermore, an increase in the concentration of ACN (CACN) resulted in a corresponding increase in the surface diffusion coefficient (Ds), whereas the addition of NaCl did not significantly affect the Ds values. We attributed this dependence of Ds to the dielectric constant change in the interfacial liquid phase formed on the ODS layer. Specially, Ds values of (4.0 ± 0.5) × 10-7, (7.7 ± 1.1) × 10-7, (1.0 ± 0.3) × 10-6, and (1.1 ± 0.2) × 10-6 cm2 s-1 were obtained for CACN = 20, 30, 40, and 50 vol%, respectively. We anticipate that this approach will contribute to advancing research on intraparticle mass transfer mechanisms.
RESUMEN
BACKGROUND: The aggregation of isotropic particles through interparticle reactions poses a challenge in control due to the ability of all surfaces to bind to each other, rendering the quantitative detection of such interparticle reactions based on particle size difficult. Here, we proposed a novel detection scheme for DNA utilizing an assembly of Janus particles (JPs) employing dynamic light scattering (DLS). DNA molecules are tethered on one hemisphere of the JP, while the other hemisphere retains its hydrophobic properties. RESULTS: Aggregation of JPs was induced by the sandwich hybridization of target DNA between them. The assembly of JPs was effectively monitored by the changes in hydrodynamic diameter detected by DLS, revealing that aggregation peaks at 2-3 particles and further reaction was hindered due to the inability of one hemisphere of the JP to interact with another JP. The target DNA demonstrated detectability at concentrations as low as several tens of pM to several nM using a digital sensing method. The two types of target DNA, such as simple (14 base pairs) and HIV-2 specific sequences (20 base pairs) were detectable at nM and pM levels, respectively. Moreover, we substantiated the robustness of our detection scheme through stoichiometric calculations based on an equilibrium model. The present detection mechanism was well explained based on the binding affinity of DNA hybridization. SIGNIFICANCE: This detection method harnesses the anisotropic nature of JPs and represents the first detection approach based on aggregation. By altering the modification molecules on JPs to match target molecules, such as proteins and organic compounds, a wide range of versatile molecules can be detected using this scheme with high sensitivity. This underscores the broad applicability of the present method.