Electrically conductive nanocomposites made from cellulose nanofibrils and polyaniline.

Electrically conductive nanocomposites from cellulose nanofibrils (CNF) were successfully produced by in situ polymerization of aniline onto CNF, and studied by open circuit potential (Voc), four probe direct current (dc) electrical conductivity, ultraviolet-visible (UV-Vis) spectroscopy and scanning electron microscopy (SEM). The oxidative polymerization of aniline using ammonium peroxydisulfate in hydrochloric acid aqueous solutions was realized by the addition of nanofibrils leading to an aqueous suspension of CNF coated with polyaniline (PANI). This procedure lead to stable, green suspensions of CNF coated with PANI in the emeraldine oxidation state as demonstrated by Voc and UV-Vis analyses. Electrically conductive films of this cellulose nanocomposite could be cast from aqueous solutions with conductivity close to the conducting polymer, yet with the potential for more useful flexible films.

Synthetic- and bio-polymer use for runoff water quality management in irrigated agriculture.

Low concentrations of synthetic- or bio-polymers in irrigation water can nearly eliminate sediment, N, ortho- and total-P, DOM, pesticides, micro-organisms, and weed seed from runoff. These environmentally safe polymers are employed in various sensitive uses including food processing, animal feeds, and potable water purification. The most common synthetic polymer is anionic, high purity polyacrylamide (PAM), which typically provides 70-90% contaminant elimination. Excellent results are achieved adding only 10 ppm PAM to irrigation water, applying 1-2 kg ha(-1) per irrigation, costing 4 dollars - 12 dollars kg(-1). Biopolymers are less effective. Using twice or higher concentrations, existing biopolymers are approximately 60% effective as PAM, at 2-3 times the cost. A half million ha of US irrigated land use PAM for erosion control and runoff protection. The practice is spreading rapidly in the US and worldwide. Interest in development of biopolymer surrogates for PAM is high. If the supply of cheap natural gas (raw material for PAM synthesis) diminishes, industries may seek alternative polymers. Also "green" perceptions and preferences favor biopolymers for certain applications.

Volatile flavor components of rice cakes.

Volatiles were obtained from commercially prepared and laboratory-prepared rice cakes using high-flow dynamic headspace isolation with Tenax trapping. Analysis was carried out by capillary GC/MS. More than 60 compounds were identified. Major volatiles included 1-hydroxy-2-propanone, furfuryl alcohol, 2, 5-dimethylpyrazine, 2-methylpyrazine, pyrazine, hexanal, furfural, pentanol, 3-hydroxy-2-butanone (acetoin), and ethyl-3, 6-dimethylpyrazine. Although not ideally applicable to a dry product, concentration/threshold ratios indicated that the compounds with a high probability of contributing to the aroma and flavor included 3-methylbutanal, dimethyl trisulfide, 2-ethyl-3,5-dimethylpyrazine, 4-vinylguaiacol, hexanal, (E,E)-2,4-decadienal, 2-methylbutanal, 2-acetyl-1-pyrroline, 1-octen-3-ol, and 1-octen-3-one.

A simple method for studying whole sections of rice grain.

We developed a new and simple method to collect sections of a whole brown rice kernel for investigation of histological properties. A single kernel of rice was dehydrated through a graded ethanol series, transferred to xylene, and embedded in paraffin. During sectioning of the blocks using a rotary microtome, we used a special adhesive tape to collect and place the sections on slides so they remained flat. The use of the adhesive tape technique combined with autofluorescence characteristics allowed us to visualize cell walls throughout an entire longitudinal or transverse section of a whole rice kernel. We obtained scanning electron microscopy images of the sections to determine section quality.

Neutron reflectivity studies of single lipid bilayers supported on planar substrates.

Neutron reflectivity was used to probe the structure of single phosphatidylcholine (PC) lipid bilayers adsorbed onto a planar silicon surface in an aqueous environment. Fluctuations in the neutron scattering length density profiles perpendicular to the silicon/water interface were determined for different lipids as a function of the hydrocarbon chain length. The lipids were studied in both the gel and liquid crystalline phases by monitoring changes in the specularly-reflected neutron intensity as a function of temperature. Contrast variation of the neutron scattering length density was applied to both the lipid and the solvent. Scattering length density profiles were determined using both model-independent and model-dependent fitting methods. During the reflectivity measurements, a novel experimental set-up was implemented to decrease the incoherent background scattering due to the solvent. Thus, the reflectivity was measured to Q approximately 0.3 A-1, covering up to seven orders of magnitude in reflected intensity, for PC bilayers in D2O and silicon-matched (38% D2O/62% H2O) water. The kinetics of lipid adsorption at the silicon/water interface were also explored by observing changes in the reflectivity at low Q values under silicon-matched water conditions.