Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 3 de 3
Filtrar
Más filtros

Bases de datos
Tipo de estudio
Tipo del documento
País de afiliación
Intervalo de año de publicación
1.
Angew Chem Int Ed Engl ; 60(35): 19183-19190, 2021 Aug 23.
Artículo en Inglés | MEDLINE | ID: mdl-33928733

RESUMEN

Lithium metal anode holds great promises for next-generation battery technologies but is notoriously difficult to work with. The key to solving this challenge is believed to lie in the ability of forming stable solid-electrolyte interphase (SEI) layers. To further address potential safety issues, it is critical to achieve this goal in nonflammable electrolytes. Building upon previous successes in forming stable SEI in conventional carbonate-based electrolytes, here we report that reversible Li stripping/plating could be realized in triethyl phosphate (TEP), a known flame retardant. The critical enabling factor of our approach was the introduction of oxygen, which upon electrochemical reduction induces the initial decomposition of TEP and produces Li3 PO4 and poly-phosphates. Importantly, the reaction was self-limiting, and the resulting material regulated Li plating by limiting dendrite formation. In effect, we obtained a functional SEI on Li metal in a nonflammable electrolyte. When tested in a symmetric Li∥Li cell, more than 300 cycles of stripping/plating were measured at a current density of 0.5 mA cm-2 . Prototypical Li-O2 and Li-ion batteries were also fabricated and tested to further support the effectiveness of this strategy. The mechanism by which the SEI forms was studied by density functional theory (DFT), and the predictions were corroborated by the successful detection of the intermediates and products.

2.
Nano Lett ; 19(8): 5149-5158, 2019 08 14.
Artículo en Inglés | MEDLINE | ID: mdl-31313586

RESUMEN

Nanostructured catalysts often face an important challenge: poor stability. Many factors contribute to catalytic degradation, including parasitic chemical reactions, phase separation, agglomeration, and dissolution, leading to activity loss especially during long-term catalytic reactions. This challenge is shared by a new family of catalysts, multimetallic nanoparticles, which have emerged owing to their broad tunability and high activity. While significant synthesis-based advances have been made, the stability of these nanostructured catalysts, especially during catalytic reactions, has not been well addressed. In this study, we reveal the critical influence of a synthetic method on the stability of nanostructured catalysts through aprotic oxygen catalysis (Li-O2 battery) demonstrations. In comparison to the conventional wet impregnation (WI) method, we show that the carbothermal shock (CTS) method dramatically improves the overall structural and chemical stability of the catalyst with the same elemental compositions. For multimetallic compositions (4- and 8-elements), the overall stability of the electrocatalysts as well as the battery lifetime can be further improved by incorporating additional noncatalytically active elements into the individual nanoparticles via CTS. The results offer a new synthetic path toward the stabilization of nanostructured catalysts, where additional reaction schemes beyond oxygen electrocatalysis are foreseeable.

3.
Angew Chem Int Ed Engl ; 58(43): 15313-15317, 2019 Oct 21.
Artículo en Inglés | MEDLINE | ID: mdl-31478284

RESUMEN

The incompatibility between the anode and the cathode chemistry limits the used of Mg as an anode. This issue may be addressed by separating the anolyte and the catholyte with a membrane that only allows for Mg2+ transport. Mg-MOF-74 thin films were used as the separator for this purpose. It was shown to meet the needs of low-resistance, selective Mg2+ transport. The uniform MOF thin films supported on Au substrate with thicknesses down to ca. 202 nm showed an intrinsic resistance as low as 6.4â€…Ω cm2 , with the normalized room-temperature ionic conductivity of ca. 3.17×10-6  S cm-1 . When synthesized directly onto a porous anodized aluminum oxide (AAO) support, the resulting films were used as a standalone membrane to permit stable, low-overpotential Mg striping and plating for over 100 cycles at a current density of 0.05 mA cm-2 . The film was effective in blocking solvent molecules and counterions from crossing over for extended period of time.

SELECCIÓN DE REFERENCIAS
DETALLE DE LA BÚSQUEDA