RESUMEN
The economic advantages of H2SO4 make it the acid of choice for the hydrometallurgical treatment of waste lithium-ion batteries (LIBs). However, to facilitate the full dissolution of the higher valency metal oxides present in the cathode black mass, a suitable reducing agent is required. Herein, the application of industrial black liquor (BL) obtained from the Kraft pulping for papermaking is investigated as a renewable reducing agent for the enhanced leaching of transition metals from LIB powder with H2SO4. The addition of acidified BL to H2SO4 significantly improved the leaching efficiency for a range of LIB cathode chemistries, with the strongest effect observed for manganese-rich active material. Focusing on NMC111 (LiMnxCoyNizO2) material, a linear correlation between the BL concentration and the leaching yield of Mn was obtained, with the best overall leaching efficiencies being achieved for 2.0â mol L-1 H2SO4 and 50â vol % of BL at 353â K. A quasi-total degradation of oxygenated and aromatic groups from the BL during NMC111 dissolution was observed after leaching, suggesting that these chemical groups are essential for LIB reduction. Finally, the leached transition metals could be easily recovered by pH adjustment and oxalic acid addition, closing the resource loop and fostering resource efficiency.
RESUMEN
In this work, centrifugal partition chromatography (CPC) assisted by a polyethylene glycol (PEG)/sodium polyacrylate (NaPA) aqueous biphasic system (ABS) was applied in the separation of five lignin-derived monomers (vanillin, vanillic acid, syringaldehyde, acetovanillone, and p-hydroxybenzaldehyde). The influence of the system pH (unbuffered, pH 5, and pH 12) and added electrolytes (inorganic salts or ionic liquids (ILs)) on the compound partition was initially evaluated. The obtained data revealed that ILs induced more adequate partition coefficients (K < 5) than inorganic salts (K > 5) to enable separation performance in CPC, while alkaline conditions (pH 12) demonstrated a positive impact on the partition of vanillic acid. CPC runs, with buffered ABS at pH 12, enabled a selective separation of vanillic acid from other lignin monomers. Under these conditions, a distinct interaction between the top (PEG-rich) and bottom (NaPA-rich) phases of the ABS with the double deprotonated form of vanillic acid is expected when compared to the remaining lignin monomers (single deprotonated). This is an impactful result that shows the pH to be a crucial factor in the separation of lignin monomer compounds by CPC, while only unbuffered systems have been previously studied in the literature. Finally, the recovery of vanillic acid up to 96% purity and further recycling of ABS phase-forming components were approached as a proof of concept through the combination of ultrafiltration and solid-phase extraction steps.
RESUMEN
Currently, the ability to produce several kinds of water-soluble red natural colorants makes the genus Talaromyces particularly important to the dye industry, which can be an alternative to the use of harmful synthetic colorants. In this study, colored compounds produced by Talaromyces amestolkiae were extracted, characterized chemically and the color stability of the fermented broth without any extraction procedure was further evaluated over pH variation. Five azaphilones compounds were detected by Ultrahigh Performance Liquid Chromatography-Mass Spectrometry system, all being complexes of the fatty acid amino-hexanedioic acid and azaphilone Monascus colorants. The color of the fermented broth was stable at a wide range of pH (3-9). Furthermore, T. amestolkiae colorants precipitated through hydrolysis of key chemical groups at extremely acidic (pH 1) and lose red color in extremely basic (pH 13) medium, showing negative halochromism. Nevertheless, these findings enhance the industrial relevance of azaphilone colorants produced by biotechnological process.