Influence of extraction methodologies on the analysis of five major volatile aromatic compounds of citronella grass (Cymbopogon nardus) and lemongrass (Cymbopogon citratus) grown in Thailand.

This paper deals with the systematic comparison of extraction of major volatile aromatic compounds (VACs) of citronella grass and lemongrass by classical microhydrodistillation (MHD), as well as modern accelerated solvent extraction (ASE). Sixteen VACs were identified by GC/MS. GC-flame ionization detection was used for the quantification of five VACs (citronellal, citronellol, geraniol, citral, and eugenol) to compare the extraction efficiency of the two different methods. Linear range, LOD, and LOQ were calculated for the five VACs. Intraday and interday precisions for the analysis of VACs were determined for each sample. The extraction recovery, as calculated by a spiking experiment with known standards of VACs, by ASE and MHD ranged from 64.9 to 91.2% and 74.3 to 95.2%, respectively. The extraction efficiency of the VACs was compared for three solvents of varying polarities (hexane, dichloromethane, and methanol), seven different temperatures (ranging from 40 to 160 degrees C, with a gradual increment of 20 degrees C), five time periods (from 1 to 10 min), and three cycles (1, 2, and 3 repeated extractions). Optimum extraction yields of VACs were obtained when extractions were carried out for 7 min with dichloromethane and two extraction cycles at 120 degrees C. The results showed that the ASE technique is more efficient than MHD, as it results in improved yields and significant reduction in extraction time with automated extraction capabilities.

Optimised separation procedures for the simultaneous assay of three plant hormones in liquid biofertilisers.

INTRODUCTION: The overuse of petrochemical-based synthetic fertilisers has caused detrimental effects to soil, water supplies, foods and animal health. This, in addition to increased awareness of organic farming, has generated considerable interest in the evaluation of renewable biofertilisers. OBJECTIVE: The three objectives of the current research were: (1) to evaluate and optimise a solid phase extraction procedure for extraction of three plant hormones, IAA, GA(3) and ABA from two model biofertilisers produced from coconut shells and pineapple peels; (2) to develop an HPLC analysis procedure for the simultaneous separation and quantification of three plant hormones (IAA, GA(3) and ABA); and (3) to evaluate the changes in three plant hormones levels at four different fermentation time periods and varying number of general bacteria, lactic acid bacteria and yeast. RESULT: An optimised procedure for sample preparation, separation and simultaneous analysis of three plant hormones [indole-3-acetic acid (IAA), gibberellic acid (GA(3)) and abscisic acid (ABA)] produced in liquid biofertilisers was developed. This method involves sample cleanup using a Sep-pack OasisMAX cartridge containing mixed-mode anion-exchange and reverse-phase sorbents that provided optimum recovery of 85.6, 91.9 and 94.3%, respectively, for the three hormones, IAA, GA(3), and ABA. Baseline separation of three hormones was achieved using mobile phase consisting of 1% acetic acid and acetonitrile (75:25, v/v) at pH 4.0. The amounts of hormones produced in liquid biofertilisers were influenced by fruit types, fermentation time and total number of general bacteria, lactic acid bacteria and yeasts. The quantities of three plant hormones produced during fermentation correlated well with the total number of microorganisms present in the liquid biofertilisers. CONCLUSION: A simple and rapid sample preparation procedure followed by RP-HPLC with UV detection was optimised and developed for simultaneous quantification and identification of three plant hormones namely, IAA, GA(3) and ABA in the liquid biofertilisers. This procedure allows quantification of the three plant hormones in their natural states without any prior derivatisation step. The results presented illustrate that the contents of the three plant hormones depended on the type of fruit wastes, fermentation time and the number of microorganisms found in liquid biofertilisers. This method can be extended to determine the quantity of three hormones in other matrices. This assay procedure will aid in the development of liquid biofertilisers, a valuable alternative fertilisers to promote plant growth. This process will help farmers to reduce production cost and pollution problems.

Removal of heavy metals from artificial metals contaminated water samples based on micelle-templated silica modified with pyoverdin I.

The micelle-templated silica (MTS) was firstly chemically modified with 3-glycidoxypropyl-trimethoxysilane (GPTMS) before immobilized with pyoverdin I. The characteristics of pyoverdin I-anchored onto the modified MTS were investigated using fluorescence, infrared spectra and scanning electron microscopy. The specific surface area of all materials was calculated by Brunauer, Emmett and Teller (BET) method using nitrogen isotherm adsorption data. As the results, the surface area of commercial silica gel decreased from 609.2 to 405.4 m2/g, it indicated that the pyoverdin I could be immobilized onto the surface of silica solid support. This adsorbent was used for extraction of Fe(III), Cu(II), Zn(II), and Pb(II) in artificial metals contaminated water. Experimental conditions for effective adsorption of trace levels of metal ions were optimized with respect to different experimental parameters using batch procedure. The optimum pH value for the removal of metal ions simultaneously on this adsorbent was 4.0. Complete desorption of the adsorbed metal ions from the adsorbent was carried out using 0.25 mol/L of EDTA. The effect of different cations and anions on the adsorption of these metals on adsorbent was studied and the results showed that the proposed adsorbent could be applied to the highly saline samples and the sample which contains some transition metals.