Measurement of a time dependent spatial beam profile of an RF-driven H- ion source.

The AC component of a beam current extracted from a negative hydrogen (H-) ion source was detected through a 0.1 mm wide, 66.5 mm long entrance slit to observe the spatial distribution. An internal antenna type multicusp source driven by a 2 MHz radio frequency (RF) power delivered beams to an electrostatic accelerator coupled to a pair of magnetic lenses. The local beam intensity measured by a Faraday cup after the entrance slit exhibited an oscillation showing two main frequency components: the RF power supply frequency and the frequency two times the driving RF. The frequency spectrum of the detected signal showed sharp peaks at 2 MHz, 4 MHz, and 6 MHz as well as at 3 MHz and 5 MHz. A 1 mm displacement of the Faraday cup slit position from the center of the beam axis increased the oscillation amplitude, corresponding to a larger amplitude of the AC component at the beam edge.

Importance of electric field for H(-) extraction in a volume-type hydrogen negative ion source.

The effect upon extraction of negative hydrogen ions (H(-)) due to electric field near the extractor hole of a H(-) source is studied experimentally and theoretically. Probe measurements show that the extraction electric field penetrates into the plasma in the region near the extractor hole. Based on this observation a three-dimensional H(-) trajectory calculation that takes into account the local electric field distribution near the plasma electrode has been carried out. The validity of the trajectory calculation was examined by comparing the results with experimentally measured changes in H(-) current detected by a Faraday cup due to irradiation of a pulse laser beam in the region close to the extractor hole. The calculation results qualitatively explain the changes in H(-) current observed in the experiment. The calculation results also predict that the amount of H(-) current passing through the extractor hole changes with the electric field: the penetration of the electric field substantially enhances the H(-) extraction current, because it produces an electric field to attract H(-) toward the extraction hole.

Diagnostics of a He(+) beam extracted from a compact magnetic bucket-type ion source.

Performance of a compact He(+) ion source was investigated before installing it to the experiment system developed for studying the efficiency of autodetachment neutralization from He(-) to He(0). Dependence of the extracted ion current upon the plasma parameters and that upon the extraction voltage indicated that the source performance was limited by space charge effect. The beam emittance was measured with a multislit system for various operation conditions. The experimentally determined emittance agreed well with the emittance obtained from ion trajectories calculated with input plasma parameters measured by a Langmuir probe. The beam current density of 60 mA/cm(2) and the emittance of less than 25pi mm mrad are expected to deliver enough current to the downstream of the He(-) neutralizer system to clarify factors affecting the final He(0) intensity.

Energy straggling of low-energy ion beam in a charge exchange cell for negative ion production.

Energy straggling in a charge exchange cell, which is frequently used for negative ion production, was studied experimentally and compared with the results of theoretical evaluation. The change of the energy spectrum of a He(+) beam due to charge exchange processes in argon gas was measured in the energy range of 2-6 keV. Energy straggling by multiple collisions is expressed by the energy loss formula due to inelastic and elastic processes. The impact parameter is related to the elastic scattering angle, and the geometry of the charge exchange cell and other components of the beam transportation system determines the maximum acceptable scattering angle. The energy spread was evaluated taking the integral limit over the impact parameter into consideration. The theoretical results showed good agreement with those of actual measurement.

A beam transport system for an intense He(-) beam source.

We have been developing a test stand for fast He(0) beam production. One of the major issues is how to transport effectively the He(+) and He(-) beams from which the He(0) beam is produced. The beam should be focused in two transverse focal points, the center of the charge exchange cell and the electrostatic accelerator. We studied the beam transport system and effect of space charge neutralization in the test stand by experiments and calculation.

Development of a strongly focusing high-intensity He(+) ion source for a confined alpha particle measurement at ITER.

A strongly focusing high-intensity He(+) ion source has been designed and constructed as a beam source for a high-energy He(0) beam probe system for diagnosis of fusion produced alpha particles in the thermonuclear fusion plasmas. The He(+) beam was extracted from the ion source at an acceleration voltage of 18-35 kV. Temperature distributions of the beam target were observed with an IR camera. The 1/e-holding beam profile half-width was about 15 mm at optimum perveance (Perv) of 0.03 (I(beam)=2.4 A). A beam current about 3 A was achieved at an acceleration voltage of 26.7 kV with an arc power of 10 kW (Perv=0.023).

Time-of-flight analyzer system to detect reflected particles from a solid surface following low-energy particle injection.

We have developed a time-of-flight analyzer to measure energy distributions of reflected particles from solid surfaces bombarded by low-energy (1-2 keV) ions. The analyzer yields energy distributions of neutrals which can be compared with the energy distributions of charged particles measured by a magnetic deflection-type momentum analyzer. We have tested the system to measure the angular dependence of energy and intensity for neutrals reflected from a polycrystalline W target. The energies of the reflected neutrals are much smaller than the incident ion energies, suggesting multiple scattering in the target. No angular dependence is observed under the condition that the sum of the incident and reflected angles is constant. The intensity of the reflected neutrals takes the maximum around the mirror angle. We compare these characteristics of neutral particle reflections with those of reflected ions.

Ion heating and high-energy-particle production by ion-cyclotron heating in the large helical device

Ion-cyclotron heating was applied to the Large Helical Device. When the proton-cyclotron resonance was near the saddle point of the magnetic field-strength plane, strong ion-cyclotron damping occurred. Under these conditions efficient plasma heating was achieved for more than one minute. A high-energy ion tail was observed, and the effective tail temperature was determined by a balance between the wave acceleration and the electron-drag relaxation. There was no apparent sign of particle orbit loss effect in the investigated density range of 0.8-1.3x10(19) m(-3).

Plasma perturbation induced by laser photodetachment.

The plasma dynamics arising from laser photodetachment is discussed herein theoretically and experimentally. The hybrid fluid-kinetic model, where the positive ions and electrons are treated by the fluid theory and the negative ions are treated within the ballistic approximation, is extended and applied to the analysis of densities perturbed by laser photodetachment. The agreement between the theory and measured data confirms the validity of the considered plasma dynamics model. This model, including the positive ion perturbation, shows a good agreement with the time evolution and the spatial distribution of perturbed electron densities which are measured by a Langmuir probe inside and outside the laser beam. From the overshoot in the time evolution of perturbed electron current in the center of the laser beam, the positive ion temperature was found to be in the range 0.1-0.25 eV, while the electron temperature changes from 0.3 to 3.2 eV.

A case of intestinal myiasis in Japan.

A case of intestinal myiasis caused by larvae of Sarcophaga peregrina (Japanese name: senchi-nikubae) is reported. The patient passed stools containing live fly larvae for 2 days, but was otherwise asymptomatic. The patient seems to have been infested accidentally as a result of having eaten "yakitori" in which the fly had deposited its larvae. This paper is the first report of intestinal myiasis caused by the 3rd instar of this species.

[General anesthesia in a patient with Cornelia de Lange syndrome with restricted opening of the mouth].

Patients with Cornelia de Lange syndrome have many anomalies including micrognathia with a small mouth, a high arched palate, and a short neck, which might make laryngoscopy for tracheal intubation difficult during induction of general anesthesia. General anesthesia was performed in a patient with Cornelia de Lange syndrome, and restricted opening of the mouth, which had not been reported previously, was found during laryngoscopy. The possible causes were thought to be temporo-mandibular joint disorders, contracture of the masseter muscle due to injury by self-destructive tendencies, or elogated coronoid process. The potential difficulty with laryngoscopy should be considered for tracheal intubation in a patient with Cornelia de Lange syndrome.

Angular distributions of surface produced H(-) ions for reflection and desorption processes.

A numerical simulation code, Atomic Collision in Amorphous Target, has been run to clarify the effects due to the incident angle of hydrogen flux onto surface collision cascade in the subsurface region of a Cs covered Mo plasma grid. The code has taken into account the threshold energy for negative hydrogen (H(-)) ions to leave the surface. This modification has caused the shift of energy distribution functions of H(-) from that of hydrogen atoms leaving the surface. The results have shown that large incident angle of hydrogen particle tilt the angular distribution of reflection component, while it caused a small effect onto the angular distribution of desorption component. The reflection coefficient has increased, while the desorption yield has decreased for increased angle of incidence measured from the surface normal.

Influence of electric field penetration by a three-electrode beam extraction system on hydrogen negative ion source plasma.

We study influence of electric field penetration into H(-) ion source plasma with three-electrode beam extraction system. Clear change in the plasma potential due to the field penetration is observed in case of low gap voltage between a plasma electrode and an extraction electrode. Influence of lens voltage on the second electrode, which is normally utilized to focus the extracted beam, on ion source plasma is evaluated separating contributions of H(-) density in the plasma and extraction probability of H(-) ions from the plasma by two kinds of photodetachment techniques. In our operation condition, we found that the lens voltage is also useful to enhance the H(-) density in the plasma, though it negatively affects the extraction probability.

Evaluation of two-stage system for neutron measurement aiming at increase in count rate at Japan Atomic Energy Agency-Fusion Neutronics Source.

In order to increase the count rate capability of a neutron detection system as a whole, we propose a multi-stage neutron detection system. Experiments to test the effectiveness of this concept were carried out on Fusion Neutronics Source. Comparing four configurations of alignment, it was found that the influence of an anterior stage on a posterior stage was negligible for the pulse height distribution. The two-stage system using 25 mm thickness scintillator was about 1.65 times the count rate capability of a single detector system for d-D neutrons and was about 1.8 times the count rate capability for d-T neutrons. The results suggested that the concept of a multi-stage detection system will work in practice.

Effects of roughness and temperature on low-energy hydrogen positive and negative ion reflection from silicon and carbon surfaces.

Angle-resolved energy distribution functions of positive and negative hydrogen ions produced from a rough-finished Si surface under 1 keV proton irradiation have been measured. The corresponding distribution from a crystalline surface and a carbon surface are also measured for comparison. Intensities of positive and negative ions from the rough-finished Si are substantially smaller than those from crystalline Si. The angular distributions of these species are broader for rough surface than the crystalline surface. No significant temperature dependence for positive and negative ion intensities is observed for all samples in the temperature range from 300 to 400 K.

Development of a He- and He0 beam source for alpha particle measurement in a burning plasma.

Proof of principle experiments of neutral helium beam production for alpha particle diagnostics was carried out on a test stand. Negative helium ions were produced in the Li charge exchange cell, in which stable and long time operation was possible. He(-) beam was accelerated to 157 keV. Finally, He(0) beam was successfully produced after the flight in the drift-tube through the auto-electron-detachment process from He(-) to He(0). A neutral beam detector using a pyroelectric device was also developed to measure He(0) beam intensity. The metastable component in the neutral helium beam was found to be less than 2%.

Extraction of a strongly focusing He+ beam from three-stage concave electrodes for alpha particle measurement system in ITER.

A strongly focusing He(+) ion beam source equipped with concave multi-aperture electrodes was developed for production of He(-) through a charge exchange cell. The beam was extracted at a voltage less than 20 kV from 301 apertures distributed in an area of 100 mm φ, and focused at 750 mm distance. The beam current and the beam size of 2 A and 20 mm in diameter, respectively, were achieved with an arc power less than 10 kW. The optimum perveance was obtained at 0.02 A∕kV(1.5) at the beam energy less than 20 keV which is suitable for the conversion to He(-) in an alkali vapor cell.

An alpha particle measurement system using an energetic neutral helium beam in ITER (invited).

An energetic helium neutral beam is involved in the beam neutralization measurement system of alpha particles confined in a DT fusion plasma. A full size strong-focusing He(+) ion source (2 A, the beam radius of 11.3 mm, the beam energy less than 20 keV). Present strong-focusing He(+) ion source shows an emittance diagram separated for each beamlet of multiple apertures without phase space mixing, despite the space charge of a beamlet is asymmetric and the beam flow is non-laminar. The emittance of beamlets in the peripheral region was larger than that of center. The heat load to the plasma electrode was studied to estimate the duty factor for the ITER application.

Detection of lost alpha particle by concealed lost ion probe.

Full orbit-following calculation is performed for the final orbit of the lost alpha particles, showing some orbits escaping from the last closed flux surface could be detected by a concealed lost ion probe (CLIP) installed under the shadow of the original first wall surface. While both passing and trapped orbits hit the same wall panel, detecting a trapped orbit by the CLIP is easier than detecting passing orbits. Whether the final orbit is detected or not is determined by the position of the reflection point. The CLIP successfully detects the trapped orbits, which are reflected before they hit to a first wall. Then the pitch angles of the orbits at the CLIP are close to and smaller than 90°. Optimization of the position of the CLIP in terms of broader detection window is investigated.

Strategy for the absolute neutron emission measurement on ITER.

Accuracy of 10% is demanded to the absolute fusion measurement on ITER. To achieve this accuracy, a functional combination of several types of neutron measurement subsystem, cross calibration among them, and in situ calibration are needed. Neutron transport calculation shows the suitable calibration source is a DT/DD neutron generator of source strength higher than 10(10) n/s (neutron/second) for DT and 10(8) n/s for DD. It will take eight weeks at the minimum with this source to calibrate flux monitors, profile monitors, and the activation system.