RESUMEN
The magnetic spectrometer AMS-100, which includes a superconducting coil, is designed to measure cosmic rays and detect cosmic antimatter in space. This extreme environment requires a suitable sensing solution to monitor critical changes in the structure such as the beginning of a quench in the superconducting coil. Rayleigh-scattering-based distributed optical fibre sensors (DOFS) fulfil the high requirements for these extreme conditions but require precise calibration of the temperature and strain coefficients of the optical fibre. Therefore, the fibre-dependent strain and temperature coefficients KT and Kϵ for the temperature range from 77 K to 353 K were investigated in this study. The fibre was integrated into an aluminium tensile test sample with well-calibrated strain gauges to determine the fibre's Kϵ independently of its Young's modulus. Simulations were used to validate that the strain caused by changes in temperature or mechanical conditions was the same in the optical fibre as in the aluminium test sample. The results indicated a linear temperature dependence of Kϵ and a non-linear temperature dependence of KT. With the parameters presented in this work, it was possible to accurately determine the strain or temperature of an aluminium structure over the entire temperature range from 77 K to 353 K using the DOFS.
RESUMEN
For orthopaedic applications, additive manufactured (AM) porous scaffolds made of absorbable metals such as magnesium, zinc or iron are of particular interest. They do not only offer the potential to design and fabricate bio-mimetic or rather bone-equivalent mechanical properties, they also do not need to be removed in further surgery. Located in a physiological environment, scaffolds made of absorbable metals show a decreasing Young's modulus over time, due to product dissolution. For magnesium-based scaffolds during the first days an increase of the smeared Young's modulus can be observed, which is mainly attributed to a forming substrate layer of degradation products on the strut surfaces. In this study, the influence of degradation products on the stiffness properties of metallic scaffolds is investigated. For this, analytical calculations and finite-element simulations are performed to study the influence of the substrate layer thickness and Young's modulus for single struts and for a new scaffold geometry with adapted polar cubic face-centered unit cells with vertical struts (f2cc,z). The finite-element model is further validated by compression tests on AM scaffolds made from Zn1Mg (1 wt% Mg). The results show that even low thicknesses and Young's moduli of the substrate layer significantly increases the smeared Young's modulus under axial compression.
RESUMEN
The objective of this work is to investigate the use of metallurgical gradients (MG) in the design of structural components made of ductile cast iron (DCI). MG have been realized in this study by locally varying the pearlite fraction of the matrix. Exemplarily, the allowable cyclic load for a drive shaft as well as the allowable static displacement are calculated. The performed calculations are based on static and cyclic strength data of four different DCI with amounts of pearlite ranging from 0% to 96.8%. To show the advantage of the purposeful usage of local MG, ten different configurations are examined by numerical simulation studies of a generic drive shaft comprising a circumferential notch. Four configurations are calculated assuming homogenous material throughout the entire component. In the other six configurations the surface region of the notch root has an increased amount of pearlite. For each configuration the allowable multiaxial cyclic load by combinations of torsion and bending was calculated and subsequently the allowable static bending displacement. The results show that the targeted realization of MG results in a significant increase in the multiaxial fatigue strength of the shaft as well as in a slight improvement of the allowable static bending displacement.