Does footprint preparation influence tendon-to-bone healing after rotator cuff repair in an animal model?

PURPOSE: The aim of this study was to investigate the influence of footprint spongialization and radiofrequency ablation on rotator cuff repair outcomes compared with an untreated group in a rat model. METHODS: We randomly assigned 189 Sprague-Dawley rats to either a spongialization, radiofrequency ablation, or untreated group. After separation of the supraspinatus tendon from the greater tubercle, the footprint was prepared by removing the cortical bone with a burr (spongialization), was prepared by ablating soft tissue with a radiofrequency ablation device, or was left unaltered (untreated). Biomechanical testing (after 7 weeks, n = 165) and histologic analysis after 1 and 7 weeks (n = 24) followed reinsertion. RESULTS: The mean load to failure was 17.51 ± 4.46 N/mm(2) in the spongialization group, 15.56 ± 4.85 N/mm(2) in the radiofrequency ablation group, and 19.21 ± 5.19 N/mm(2) in the untreated group. A significant difference was found between the spongialization and radiofrequency ablation groups (P = .0409), as well as between the untreated and radiofrequency ablation groups (P = .0014). There was no significant difference between the spongialization and untreated groups (P = .2456). The mean area of fibrocartilage transition, characterized by the presence of type II collagen, was larger after 1 and 7 weeks in the spongialization group (0.57 ± 0.1 mm(2) and 0.58 ± 0.1 mm(2), respectively) and untreated group (0.51 ± 0.1 mm(2) and 0.51 ± 0.2 mm(2), respectively) than in the radiofrequency ablation group (0.11 ± 0.1 mm(2) and 0.4 ± 0.1 mm(2), respectively) with P < .05 and P < .01. CONCLUSIONS: The results of this study show that radiofrequency ablation of the footprint results in a poor biomechanical and histologic outcome in an animal model. No preparation of the footprint has the same effect as spongialization. CLINICAL RELEVANCE: Different techniques of footprint preparation in rotator cuff repair may influence tendon-to-bone healing.

The influence of different footprint preparation techniques on tissue regeneration in rotator cuff repair in an animal model.

INTRODUCTION: Rotator cuff tears are common diseases of the upper extremity. There are no recommendations to the surgeon on how to prepare the footprint to ensure optimal tendon-to-bone healing. However, biologic augmentation using stem cells and growth factors is considered to encourage the healing process of the tendon. The aim of the study was to investigate the biomechanical and histological outcome of different footprint preparations in rotator cuff repair. MATERIAL AND METHODS: One hundred and eighty-nine Sprague-Dawley rats were randomly assigned to either spongialization, radiofrequency ablation or an untreated control group. Rats were killed after 1 or 7 weeks for histological evaluation or after 7 weeks for biomechanical testing. RESULTS: Histological evaluation showed better tissue organization in the control and spongialization group compared to the radiofrequency ablation group. The highest collagen I to collagen III quotient was found in the control group, followed closely by the spongialization group. Measured quotients showed a decrease in the values after 1 week compared to the values after 7 weeks, except in the radiofrequency ablation group, where an increase was detected. A significant difference was found in the load to failure test comparing the radiofrequency ablation group to the spongialization group (p = 0.0409) and control group (p = 0.014), but not comparing the spongialization group to the control group (p = 0.2456). CONCLUSIONS: The results of this study suggest that spongialization of the footprint before attaching the torn supraspinatus tendon can lead to better structural properties and higher quality of tendon-to-bone restoration at the insertion area when compared with radiofrequency ablation.