Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 4 de 4
Filtrar
Más filtros

Bases de datos
Tipo del documento
País de afiliación
Intervalo de año de publicación
1.
J Acoust Soc Am ; 134(6): EL499, 2013 Dec.
Artículo en Inglés | MEDLINE | ID: mdl-25669295

RESUMEN

Electret microphones with stiff plates instead of flexible diaphragms are described. The stiff plate and a backplate, separated by a soft cellular polymer spacer ring, yield a capacitance that is varied by the incoming sound wave; thus a voltage change in the plates is induced. Various such plate microphones were built and characterized. Sensitivities of more than 10 mV/Pa and equivalent noise levels of 23 dB(A) are obtained. An analytical model for the sensitivity of plate microphones was developed. Advantages of the plate microphones are high mechanical robustness, low harmonic distortion, and no risk of membrane collapse.

2.
J Acoust Soc Am ; 129(6): 3682-9, 2011 Jun.
Artículo en Inglés | MEDLINE | ID: mdl-21682393

RESUMEN

Electret microphones are produced in numbers that significantly exceed those for all other microphone types. This is due to the fact that air-borne electret sensors are of simple and low-cost design but have very good acoustical properties. In contrast, most of the discrete structure-borne sound sensors (or accelerometers) are based on the piezoelectric effect. In the present work, capacitive accelerometers utilizing the electret principle were constructed, built, and characterized. These electret accelerometers comprise a metallic seismic mass, covered by an electret film, a ring of a soft cellular polymer supplying the restoring force, and a metallic backplate. These components replace membrane, spacer, and back electrode, respectively, of the electret microphone. An adjustable static pressure to the seismic mass is generated by two metal springs. The dynamic characterization of the accelerometers was carried out by using an electrodynamic shaker and an external charge or voltage amplifier. Sensors with various seismic masses, air gap distances, and electret voltages were investigated. Charge sensitivities from 10 to 40 pC/g, voltage sensitivities from 600 to 2000 mV/g, and resonance frequencies from 3 to 1.5 kHz were measured. A model describing both the charge and the voltage sensitivity is presented. Good agreement of experimental and calculated values is found. The experimental results show that sensitive, lightweight, and inexpensive electret accelerometers can be built.


Asunto(s)
Acústica/instrumentación , Sonido , Transductores de Presión , Amplificadores Electrónicos , Simulación por Computador , Electricidad , Diseño de Equipo , Metales , Modelos Teóricos , Movimiento (Física) , Polímeros , Presión , Procesamiento de Señales Asistido por Computador , Factores de Tiempo , Vibración
3.
Ultrasound Med Biol ; 18(6-7): 625-35, 1992.
Artículo en Inglés | MEDLINE | ID: mdl-1413274

RESUMEN

The influence of spatial polarization distribution on spot poled PVDF membrane hydrophone performance was calculated and then experimentally verified using a one-dimensional model based on acoustic wave propagation through a layered medium. It is shown that the sensitivity of the hydrophone is markedly dependent on the spatial polarization distribution. It is also shown that there can be a significant difference between the voltage sensitivities measured in the same hydrophone probe depending on which electrode is actually facing the acoustic source. The measurements carried out in the frequency range 1-20 MHz indicate that this difference, while negligible below 2 MHz, may exceed 1.6 dB at higher frequencies. The model developed can also be used to determine the "effective" piezoelectric constant d33 of the PVDF material as a continuous function of frequency. Moreover, the model predicts the existence of a negative slope in the frequency response of the spot poled membrane hydrophone. The experimental confirmation of this prediction underscores the importance of using swept frequency methods during calibration measurements.


Asunto(s)
Membranas Artificiales , Polivinilos , Ultrasonido , Electricidad
4.
Med Eng Phys ; 24(5): 361-4, 2002 Jun.
Artículo en Inglés | MEDLINE | ID: mdl-12052363

RESUMEN

The thermally stimulated discharge (TSD) method, intended for the analysis of charged dielectrics, was used for human blood research. Above-room-temperature TSD spectra of blood consist of three peaks. There are indications that the low-temperature peak (40-50 degrees C) corresponds to the thermally stimulated destruction of hydrate shells surrounding blood components while the mid-temperature peak (70-90 degrees C) is related to thermal denaturation of blood proteins. The intensive high-temperature peak (105-120 degrees C) is observed when a phase transition of blood, accompanied by the formation of a firm dry film of blood, occurs. The position of the high-temperature peak depends on the blood group. Data is discussed which suggests that the spontaneous "quasi-electret effect" of blood relates to the character of the biochemical processes taking place in human organisms. The TSD method might be used as simple and informative means of diagnostics in cooperation with medical and physical investigations.


Asunto(s)
Análisis Químico de la Sangre/instrumentación , Análisis Químico de la Sangre/métodos , Antígenos de Grupos Sanguíneos/clasificación , Capacidad Eléctrica , Adulto , Aluminio , Antígenos de Grupos Sanguíneos/química , Femenino , Calor , Humanos , Electrodos de Iones Selectos , Masculino , Politetrafluoroetileno , Sensibilidad y Especificidad
SELECCIÓN DE REFERENCIAS
DETALLE DE LA BÚSQUEDA