RESUMEN
The processing of an immiscible polymer blend using melt blending (i.e., extrusion) often results in a polymer material with inferior mechanical performance compared with its virgin counterparts. Here, we report and compare the properties of immiscible polymer blends produced from industrial mixed plastic waste from shredder residue comprising at least four different polymers (acrylonitrile butadiene styrene, polystyrene, polypropylene, and polyethylene) with and without a prior melt-blending step employed. As anticipated, mixed plastic blend produced with a prior melt-blending step exhibited a more homogeneous microstructure, resulting in brittleness, poor work of fracture, and single-edge notched fracture toughness with a flat R-curve. Without the intimate polymers mixing arising from melt blending, the resulting mixed plastic blend was found to possess a more heterogeneous concentric ellipsoid microstructure with large single polymer domains. This mixed plastic blend demonstrated progressive failure under uniaxial tensile loading, along with a more ductile single-edge notched fracture toughness response accompanied by a growing R-curve. Digital image correlation and fractographic analysis revealed that melt blending created a large number of incompatible polymer boundaries that acted as stress concentration points, leading to brittleness and earlier onset catastrophic failure. The more heterogeneous mixed plastic blend produced without using a prior melt-blending step contains a smaller number of incompatible polymer boundaries. Additionally, the presence of larger single polymer domains also implies that the mechanical characteristics of the single polymer can be exploited in the immiscible mixed plastic blend. Our work opens up a simple pathway to add value to mixed plastic waste from shredder residue for use in engineering applications, diverting them away from landfill or incineration.
RESUMEN
An exciting challenge is to create unduloid-reinforcing fibers with tailored dimensions to produce synthetic composites with improved toughness and increased ductility. Continuous carbon fibers, the state-of-the-art reinforcement for structural composites, were modified via controlled laser irradiation to result in expanded outwardly tapered regions, as well as fibers with Q-tip (cotton-bud) end shapes. A pulsed laser treatment was used to introduce damage at the single carbon fiber level, creating expanded regions at predetermined points along the lengths of continuous carbon fibers, while maintaining much of their stiffness. The range of produced shapes was quantified and correlated to single fiber tensile properties. Mapped Raman spectroscopy was used to elucidate the local compositional and structural changes. Irradiation conditions were adjusted to create a swollen weakened region, such that fiber failure occurred in the laser treated region producing two fiber ends with outwardly tapered ends. Loading the tapered fibers allows for viscoelastic energy dissipation during fiber pull-out by enhanced friction as the fibers plough through a matrix. In these tapered fibers, diameters were locally increased up to 53%, forming outward taper angles of up to 1.8°. The tensile strength and strain to failure of the modified fibers were significantly reduced, by 75% and 55%, respectively, ensuring localization of the break in the expanded region; however, the fiber stiffness was only reduced by 17%. Using harsher irradiation conditions, carbon fibers were completely cut, resulting in cotton-bud fiber end shapes. Single fiber pull-out tests performed using these fibers revealed a 6.75-fold increase in work of pull-out compared to pristine carbon fibers. Controlled laser irradiation is a route to modify the shape of continuous carbon fibers along their lengths, as well as to cut them into controlled lengths leaving tapered or cotton-bud shapes.