Evaluation of the Possible Contribution of Various Regulatory Genes to Determination of Carpel Number as a Potential Mechanism for Optimal Agricultural Yield.

Various regulatory genes encoding transcription factors and miRNAs regulate carpel number. Multicarpelly is normally associated with increased size of the floral meristem, and several genetic factors have been discovered that influence this characteristic. A fundamental understanding of the regulatory genes affecting carpel number can facilitate strategies for agricultural yield improvement, which is crucial, given that the global population is growing rapidly. A multicarpellate plant may provide a significantly higher yield than a plant bearing fewer carpels. Higher yields can be achieved via various means; in this review, we provide an overview of the current knowledge of the various regulatory factors that contribute to multicarpelly and the potential of increasing carpel number to achieve an increased yield.

Identification of Stipules reduced, a leaf morphology gene in pea (Pisum sativum).

Pea (Pisum sativum) is one of relatively few genetically amenable plant species with compound leaves. Pea leaves have a variety of specialized organs: leaflets, tendrils, pulvini and stipules, which enable the identification of mutations that transform or affect distinct parts of the leaf. Characterization of these mutations offers insights into the development and evolution of novel leaf traits. The previously characterized morphological gene Cochleata, conferring stipule identity, was known to interact with Stipules reduced (St), which conditions stipule size in pea, but the St gene remained unknown. Here we analysed Fast Neutron irradiated pea mutants by restriction site associated DNA sequencing. We identified St as a gene encoding a C2H2 zinc finger transcription factor that is regulated by Cochleata. St regulates both cell division and cell expansion in the stipule. Our approach shows how systematic genome-wide screens can be used successfully for the analysis of traits in species for which whole genome sequences are not available.

Characterization and mapping of Dt1 locus which co-segregates with CcTFL1 for growth habit in pigeonpea.

KEY MESSAGE: We report growth habit profiling following SEM, genetic mapping and QTL analysis. Highlighted CcTFL1 , a candidate for determinacy in pigeonpea, since an Indel marker derived from this gene co-segregated with Dt1 locus. Pigeonpea (Cajanus cajan) is one of the most important legume crops grown in arid and semi-arid regions of the world. It is characterized with few unique features compared with other legume species, such as Lotus, Medicago, and Glycine. One of them is growth habit, an important agronomic trait. In the present study, identification of mutations affecting growth habit accompanied by a precise analysis of phenotype has been done which will shed more light upon developmental regulation in pigeonpea. A genetic study was conducted to examine the inheritance of growth habit and a genotyping by sequencing (GBS)-based genetic map constructed using F2 mapping population derived from crossing parents ICP 5529 and ICP 11605. Inheritance studies clearly demonstrated the dominance of indeterminate (IDT) growth habit over determinate (DT) growth habit in F2 and F2:3 progenies. A total of 787 SNP markers were mapped in the genetic map of 1454 cM map length. Growth habit locus (Dt1) was mapped on the CcLG03 contributing more than 61% of total phenotypic variations. Subsequently, QTL analysis highlighted one gene, CcTFL1, as a candidate for determinacy in pigeonpea, since an Indel marker derived from this gene co-segregated with the Dt1 locus. Ability of this Indel-derived marker to differentiate DT/IDT lines was also validated on 262 pigeonpea lines. This study clearly demonstrated that CcTFL1 is a candidate gene for growth habit in pigeonpea and a user-friendly marker was developed in the present study which will allow low-cost genotyping without need of automation.

Reproductive Morphology and Success in Annual versus Perennial Legumes: Evidence from Astragalus and the Fabeae (Papilionoideae).

The third largest angiosperm family, Leguminosae, displays a broad range of reproductive strategies and has an exceptional practical value. Whereas annual legume species are mostly planted as crops, there is a significant interest in breeding and cultivating perennials. It is therefore of importance to compare reproductive traits, their interactions and the resulting productivity between related annual and perennial species. Two highly variable taxa were chosen for this purpose, the Fabeae tribe, including numerous temperate crops, and the largest angiosperm 'megagenus' Astragalus. A dataset of quantitative reproductive traits was composed of both originally obtained and previously published data. As a result of statistical analysis, we found that perennials in both groups tend to produce more flowers per axillary racemose inflorescence as well as more ovules per carpel. Perennial Astragalus also have larger flowers. Only a part of the developing flowers and ovules gives rise to mature pods and seeds. This difference is especially pronounced in small populations of rare and threatened perennials. Numerous reasons underlie the gap between potential and real productivity, which may be potentially bridged in optimal growing conditions.

Phenotypes of Floral Nectaries in Developmental Mutants of Legumes and What They May Tell about Genetic Control of Nectary Formation.

The vast majority of angiosperms attracts animal pollinators with the nectar secreted through specialized floral nectaries (FNs). Although there is evidence that principal patterns of regulation of FN development are conserved in large angiosperm clades, these structures are very diverse considering their morphology and position within a flower. Most data on genetic control of FN formation were obtained in surveys of a model plant species, Arabidopsis thaliana (Brassicaceae). There are almost no data on genetic factors affecting FN development in Leguminosae, the plant family of a high agricultural value and possessing outstandingly diverse flowers. In this work, the morphology of FNs was examined in a set of leguminous species, both wild-type and developmental mutants, by the means of a scanning electron microscopy. Unlike Brassicaceae, FNs in legumes are localized between stamens and a carpel instead of being associated with a certain floral organ. FNs were found stable in most cases of mutants when perianth and/or androecium morphology was affected. However, regulation of FN development by BLADE-ON-PETIOLE-like genes seems to be a shared feature between legumes (at least Pisum) and Arabidopsis. In some legumes, the adaxial developmental program (most probably CYCLOIDEA-mediated) suppresses the FN development. The obtained results neither confirm the role of orthologues of UNUSUAL FLORAL ORGANS and LEAFY in FN development in legumes nor reject it, as two studied pea mutants were homozygous at the weakest alleles of the corresponding loci and possessed FNs similar to those of wild-type.

Variations in Structure among Androecia and Floral Nectaries in the Inverted Repeat-Lacking Clade (Leguminosae: Papilionoideae).

The vast majority of highly valuable species of the Leguminosae in temperate latitudes belong to the Inverted Repeat-Lacking Clade (IRLC). Despite having a generally conserved monosymmetric floral morphology, members of this group are remarkable with a pronounced diversity of floral sizes, modes of staminal fusion, and pollination strategies. This paper examined androecia and floral nectaries (FNs) in selected genera of the IRLC. External morphology was investigated using stereomicroscopy and scanning electron microscopy. In some cases, the pattern of staminal fusion was additionally examined in transverse sections using light microscopy. Androecia of all selected genera fell into one of four types, viz., monadelphous, pseudomonadelphous, diadelphous or diadelphous reduced (with inner stamens converted into sterile staminodes). However, there was significant variation in the stamens' mode of contact, as well as the shape and size of the fenestrae providing access to FNs. Some types seemed to arise independently in different genera, thus providing a high level of homoplasy. FNs were more conserved and comprised areas of secretory stomata in the abaxial part of the receptacle and/or hypanthium. Nectariferous stomata could be found in very miniaturized flowers (Medicago lupulina) and could even accompany monadelphy (Galega). This indicates that preferential self-pollination may nevertheless require visitation by insects.

Evaluation of phytotoxicity and cytotoxicity of industrial catalyst components (Fe, Cu, Ni, Rh and Pd): A case of lethal toxicity of a rhodium salt in terrestrial plants.

Until recently, chemical derivatives of platinum group metals have not been in a systematic direct contact with living organisms. The situation has changed dramatically due to anthropogenic activity, which has led to significant redistribution of these metals in the biosphere. Millions of modern cars are equipped with automotive catalytic converters, which contain rhodium, palladium and platinum as active elements. Everyday usage of catalytic technologies promotes the propagation of catalyst components in the environment. Nevertheless, we still have not accumulated profound information on possible ecotoxic effects of these metal pollutants. In this study, we report a case of an extraordinarily rapid development of lethal toxicity of a rhodium (III) salt in the terrestrial plants Pisum sativum, Lupinus angustifolius and Cucumis sativus. The growth stage, at which the exposure occurred, had a crucial impact on the toxicity manifestation: at earlier stages, RhCl3 killed the plants within 24 h. In contrast, the salt was relatively low-toxic in human fibroblasts. We also address phytotoxicity of other common metal pollutants, such as palladium, iron, nickel and copper, together with their cytotoxicity. None of the tested compounds exhibited phytotoxic effects comparable with that of RhCl3. These results evidence the crucial deficiency in our knowledge on environmental dangers of newly widespread metal pollutants.