Estimation of Cadmium uptake by tobacco plants from laboratory leaching tests.

The objective of the present study was to determine the impact of cadmium (Cd) concentration in the soil on its uptake by tobacco plants, and to compare the ability of diverse extraction procedures for determining Cd bioavailability and predicting soil-to-plant transfer and Cd plant concentrations. The pseudo-total digestion procedure, modified Tessier sequential extraction and six standard single-extraction tests for estimation of metal mobility and bioavailability were used for the leaching of Cd from a native soil, as well as samples artificially contaminated over a wide range of Cd concentrations. The results of various leaching tests were compared between each other, as well as with the amounts of Cd taken up by tobacco plants in pot experiments. In the native soil sample, most of the Cd was found in fractions not readily available under natural conditions, but with increasing pollution level, Cd amounts in readily available forms increased. With increasing concentrations of Cd in the soil, the quantity of pollutant taken up in tobacco also increased, while the transfer factor (TF) decreased. Linear and non-linear empirical models were developed for predicting the uptake of Cd by tobacco plants based on the results of selected leaching tests. The non-linear equations for ISO 14870 (diethylenetriaminepentaacetic acid extraction - DTPA), ISO/TS 21268-2 (CaCl2 leaching procedure), US EPA 1311 (toxicity characteristic leaching procedure - TCLP) single step extractions, and the sum of the first two fractions of the sequential extraction, exhibited the best correlation with the experimentally determined concentrations of Cd in plants over the entire range of pollutant concentrations. This approach can improve and facilitate the assessment of human exposure to Cd by tobacco smoking, but may also have wider applicability in predicting soil-to-plant transfer.

Efficient separation of strontium radionuclides from high-salinity wastewater by zeolite 4A synthesized from Bayer process liquids.

The efficient, selective, and economical sorbents for the removal of Sr radionuclides are largely needed for the decontamination of effluents with high salinity. In this study, the removal of Sr was investigated using the zeolite produced from the Bayer process liquids. Based on the XRD, SEM/EDS analysis, the product was pure and highly crystalline zeolite 4A (Z4A). Removal of Sr was fast (5 min for 100% removal at 8.80 mg/L), with high maximum sorption capacity (252.5 mg/L), and independent on the initial pH in the range 3.5-9.0. Specific sorption of Sr by protonated groups on the Z4A surface was operating in addition to ion-exchange with Na ions. The selectivity of Z4A decreased in the order Sr > Ca > K > Mg > Na. 84% of Sr was separated from seawater within 5 min, at the Z4A dose of 5 g/L, while efficiency increased to 99% using the dose of 20 g/L. Desorption of radioisotope 89Sr from seawater/Z4A solid residue was very low in deionized water (0.1-0.2%) and groundwater (0.7%) during 60 days of leaching. Z4A is a cost-effective, selective, and high-capacity medium for Sr removal, which provides high stability of retained radionuclides.