Tibiofemoral Cartilage Contact Pressures in Athletes During Landing: A Dynamic Finite Element Study.

Cartilage defects are common in the knee joint of active athletes and remain a problem as a strong risk factor for osteoarthritis. We hypothesized that landing during sport activities, implication for subfailure ACL loading, would generate greater contact pressures (CP) at the lateral knee compartment. The purpose of this study is to investigate tibiofemoral cartilage CP of athletes during landing. Tibiofemoral cartilage contact pressures (TCCP) under clinically relevant anterior cruciate ligament subfailure external loadings were predicted using four dynamic explicit finite element (FE) models (2 males and 2 females) of the knee. Bipedal landing from a jump for five cases of varying magnitudes of external loadings (knee abduction moment, internal tibial torque, and anterior tibial shear) followed by an impact load were simulated. Lateral TCCP from meniscus (area under meniscus) and from femur (area under femur) increased by up to 94% and %30 respectively when external loads were incorporated with impact load in all the models compared to impact-only case. In addition, FE model predicted higher CP in lateral compartment by up to 37% (11.87 MPa versus 8.67 MPa) and 52% (20.19 MPa versus 13.29 MPa) for 90% and 50% percentile models, respectively. For the same percentile populations, CPs were higher by up to 25% and 82% in smaller size models than larger size models. We showed that subfailure ACL loadings obtained from previously conducted in vivo study led to high pressures on the tibiofemoral cartilage. This knowledge is helpful in enhancing neuromuscular training for athletes to prevent cartilage damage.

The effect of extra-osseous talotarsal stabilization (EOTTS) to reduce medial knee compartment forces - An in vivo study.

BACKGROUND: Excessive hindfoot pronation, talotarsal joint (TTJ) instability, has been attributed to an increase in medial knee compartment pathology. Advocacy for hindfoot realignment has been the subject of research. An internal solution for TTJ instability, extra-osseous talotarsal stabilization (EOTTS), exists but its effect on knee forces is unknown. This is the first study to measure the in vivo forces acting within the medial knee compartment before and after EOTTS. We hypothesized that following EOTTS there should be a reduction of force acting on the medial knee compartment. METHODS: 10 fresh frozen cadaver lower extremities exhibiting clinical and radiographic evidence of TTJ instability were evaluated. The proximal femur segment was mounted to a mechanical testing unit. Pressure sensors were placed within the medial knee compartment. A force of 1000 newtons was then applied, and the femur was internally rotated 10 degrees. Measurements were recorded before and after the insertion of a type II EOTTS stent. RESULTS: Pre-EOTTS resulted in an average of 842 ± 247N acting within the medial knee joint compartment. These forces then decreased to an average of 565 ± 260N (<0.05) following EOTTS, representing an average reduction of force by 32.8%. CONCLUSION: EOTTS has been shown to decrease the in vivo forces action within the medial knee compartment. This helps to further illustrate the importance of realigning and stabilizing the hindfoot for the prevention and treatment of chronic knee pain.

Automated Measurement of Patient-Specific Tibial Slopes from MRI.

BACKGROUND: Multi-planar proximal tibial slopes may be associated with increased likelihood of osteoarthritis and anterior cruciate ligament injury, due in part to their role in checking the anterior-posterior stability of the knee. Established methods suffer repeatability limitations and lack computational efficiency for intuitive clinical adoption. The aims of this study were to develop a novel automated approach and to compare the repeatability and computational efficiency of the approach against previously established methods. METHODS: Tibial slope geometries were obtained via MRI and measured using an automated Matlab-based approach. Data were compared for repeatability and evaluated for computational efficiency. RESULTS: Mean lateral tibial slope (LTS) for females (7.2°) was greater than for males (1.66°). Mean LTS in the lateral concavity zone was greater for females (7.8° for females, 4.2° for males). Mean medial tibial slope (MTS) for females was greater (9.3° vs. 4.6°). Along the medial concavity zone, female subjects demonstrated greater MTS. CONCLUSION: The automated method was more repeatable and computationally efficient than previously identified methods and may aid in the clinical assessment of knee injury risk, inform surgical planning, and implant design efforts.

A novel 3D approach for determination of frontal and coronal plane tibial slopes from MR imaging.

BACKGROUND: The proximal tibia is geometrically complex, asymmetrical, and variable, is heavily implicated in arthrokinematics of the knee joint, and thus a contributor to knee pathologies such as non-contact anterior cruciate ligament injury. Medial, lateral, and coronal tibial slopes are anatomic parameters that may increase predisposition to knee injuries, but the extent to which each contributes has yet to be fully realized. Previously, two-dimensional methods have quantified tibial slopes, but more reliable 3D methods may prove advantageous. AIMS: (1) to explore the reliability of two-dimensional methods, (2) to introduce a novel three-dimensional measurement approach, and (3) to compare data derived from traditional and novel methods. METHODS: Medial, lateral, and coronal tibial slope geometry from both knees (left and right) of one subject were obtained via magnetic resonance images and measured by four trained observers from two-dimensional views. The process was repeated via three-dimensional approaches and data evaluated for intra- and inter-rater reliability. RESULTS: The conventional method presented a weaker Intraclass Correlation Coefficient (ICC) for the measured slopes (ranging from 0.43 to 0.81) while the resultant ICC for the proposed method indicated greater reliability (ranging from 0.84 to 0.97). Statistical analysis supported the novel approach for production of more reliable and repeatable results for tibial slopes. CONCLUSIONS: The novel three-dimensional method for calculating tibial plateau slope may be more reliable than previously established methods and may be applicable in assessment of susceptibility to osteoarthritis, as part of anterior cruciate ligament injury risk assessment, and in total knee implant design.