Advanced X-ray imaging at beamline 07 of the SAGA Light Source.

The SAGA Light Source provides X-ray imaging resources based on high-intensity synchrotron radiation (SR) emitted from the superconducting wiggler at beamline 07 (BL07). By combining quasi-monochromatic SR obtained by the newly installed water-cooled metal filter and monochromatic SR selected by a Ge double-crystal monochromator (DCM) with high-resolution lens-coupled X-ray imagers, fast and low-dose micro-computed tomography (CT), fast phase-contrast CT using grating-based X-ray interferometry, and 2D micro-X-ray absorption fine structure analysis can be performed. In addition, by combining monochromatic SR obtained by a Si DCM with large-area fiber-coupled X-ray imagers, high-sensitivity phase-contrast CT using crystal-based X-ray interferometry can be performed. Low-temperature CT can be performed using the newly installed cryogenic system, and time-resolved analysis of the crystallinity of semiconductor devices in operation can be performed using a time-resolved topography system. The details of each instrument and imaging method, together with exemplary measurements, are presented.

Feasibility study of interferometric phase-contrast X-ray imaging using the hard-X-ray free-electron laser of the SPring-8 Angstrom Compact Free-Electron Laser.

Aiming for the fine observation of fast physical phenomena such as phonon propagation and laser ablation, phase-contrast X-ray imaging combined with a crystal X-ray interferometer and the X-ray free-electron laser (XFEL) of the SPring-8 Angstrom Compact Free-Electron Laser has been developed. An interference pattern with 70% visibility was obtained by single-shot exposure with a 15 keV monochromated XFEL. In addition, a phase map of an acrylic wedge was successfully obtained using the fringe scanning method.

Quantitative Visualization of Salt Concentration Distributions in Lithium-Ion Battery Electrolytes during Battery Operation Using X-ray Phase Imaging.

A fundamental understanding of concentrations of salts in lithium-ion battery electrolytes during battery operation is important for optimal operation and design of lithium-ion batteries. However, there are few techniques that can be used to quantitatively characterize salt concentration distributions in the electrolytes during battery operation. In this paper, we demonstrate that in operando X-ray phase imaging can quantitatively visualize the salt concentration distributions that arise in electrolytes during battery operation. From quantitative evaluation of the concentration distributions at steady states, we obtained the salt diffusivities in electrolytes with different initial salt concentrations. Because of no restriction on samples and high temporal and spatial resolutions, X-ray phase imaging will be a versatile technique for evaluating electrolytes, both aqueous and nonaqueous, of many electrochemical systems.

Correlative Analysis of Ion-Concentration Profile and Surface Nanoscale Topography Changes Using Operando Scanning Ion Conductance Microscopy.

Although various spectroscopic methods have been developed to capture ion-concentration profile changes, it is still difficult to visualize the ion-concentration profile and surface topographical changes simultaneously during the charging/discharging of lithium-ion batteries (LIBs). To tackle this issue, we have developed an operando scanning ion conductance microscopy (SICM) method that can directly visualize an ion-concentration profile and surface topography using a SICM nanopipette while controlling the sample potential or current with a potentiostat for characterizing the polarization state during charging/discharging. Using operando SICM on the negative electrode (anode) of LIBs, we have characterized ion-concentration profile changes and the reversible volume changes related to the phase transition during cyclic voltammetry (CV) and charge/discharge of the graphite anode. Operando SICM is a versatile technique that is likely to be of major value for evaluating the correlation between the electrolyte concentration profile and nanoscale surface topography changes.

Three-dimensional micro-X-ray topography using focused sheet-shaped X-ray beam.

X-ray topography is a powerful method for analyzing crystal defects and strain in crystalline materials non-destructively. However, conventional X-ray topography uses simple X-ray diffraction images, which means depth information on defects and dislocations cannot be obtained. We have therefor developed a novel three-dimensional micro-X-ray topography technique (3D µ-XRT) that combines Bragg-case section topography with focused sheet-shaped X-rays. The depth resolution of the 3D µ-XRT depends mainly on the focused X-ray beam size and enables non-destructive observation of internal defects and dislocations with an accuracy on the order of 1 µm. The demonstrative observation of SiC power device chips showed that stacking faults, threading screw, threading edge, and basal plane dislocations were clearly visualized three-dimensionally with a depth accuracy of 1.3 µm. 3D µ-XRT is a promising new approach for highly sensitive and non-destructive analysis of material crystallinity in a three-dimensional manner.

In situ two-dimensional imaging quick-scanning XAFS with pixel array detector.

Quick-scanning X-ray absorption fine structure (XAFS) measurements were performed in transmission mode using a PILATUS 100K pixel array detector (PAD). The method can display a two-dimensional image for a large area of the order of a centimetre with a spatial resolution of 0.2 mm at each energy point in the XAFS spectrum. The time resolution of the quick-scanning method ranged from 10 s to 1 min per spectrum depending on the energy range. The PAD has a wide dynamic range and low noise, so the obtained spectra have a good signal-to-noise ratio.

Photoswitching tripodal single molecular tip for noncontact AFM measurements: synthesis, immobilization, and reversible configurational change on gold surface.

Tripodal molecules consisting of a tetrasubstituted adamantane with three phenylacetylene legs and a reversibly photoswitching apex were designed as "single molecular tips" for both chemical and topographical characterization of the substrate surface. By covalent attachment onto gold-coated AFM tips through three S-Au bonds, these rigid tripodal molecules are expected to act as sharp, robust, and stationary molecular tips whose configuration can be reversibly changed upon irradiation with UV or visible light. In this report, the full account of the syntheses of two photoswitching tripodal molecular tips, their immobilization onto Au(111) surfaces, and the detection of photoinduced configurational change on Au(111) surface by SPM measurements are documented.

Nanoscale kinetic imaging of lithium ion secondary battery materials using scanning electrochemical cell microscopy.

To visualize the electrochemical reactivity and obtain the diffusion coefficient of the anode of lithium-ion batteries, we used scanning electrochemical cell microscopy (SECCM) in a glovebox. SECCM provided the facet-dependent diffusion coefficient on a Li4Ti5O12 (LTO) thin-film electrode and detected the metastable crystal phase of LixFePO4.

In operando visualization of electrolyte stratification dynamics in lead-acid battery using phase-contrast X-ray imaging.

An understanding of electrolyte stratification behaviours in lead-acid battery electrolytes during battery operation is important for optimal operation and design of lead-acid batteries for vehicle applications. In this paper, we present an in operando phase-contrast X-ray imaging technique for quantitatively visualizing electrolyte stratification dynamics that arise in electrolytes during battery operation.

Controlling oxygen coordination and valence of network forming cations.

Understanding the structure-property relationship of glass material is still challenging due to a lack of periodicity in disordered materials. Here, we report the properties and atomic structure of vanadium phosphate glasses characterized by reverse Monte Carlo modelling based on neutron/synchrotron X-ray diffraction and EXAFS data, supplemented by Raman and NMR spectroscopy. In vanadium-rich glass, the water durability, thermal stability and hardness improve as the amount of P2O5 increases, and the network former of the glass changes from VOx polyhedra to the interplay between VOx polyhedra and PO4 tetrahedra. We find for the first time that the coordination number of oxygen atoms around a V4+ is four, which is an unusually small coordination number, and plays an important role for water durability, thermal stability and hardness. Furthermore, we show that the similarity between glass and crystal beyond the nearest neighbour distance is important for glass properties. These results demonstrate that controlling the oxygen coordination and valence of the network-forming cation is necessary for designing the properties of glass.

Visualization of inhomogeneous current distribution on ZrO2-coated LiCoO2 thin-film electrodes using scanning electrochemical cell microscopy.

Cathode surface coating with metal-oxide thin layers has been intensively studied to improve the cycle durability of lithium-ion batteries. A comprehensive understanding of the metal-oxide morphology and the local electrochemical properties is essential for figuring out the metal-oxide coating effect. In this study, scanning electrochemical cell microscopy (SECCM) is used to analyze the surface morphology with high spatial resolution, together with the local electrochemical properties.

Photoswitching behavior of a novel single molecular tip for noncontact atomic force microscopy designed for chemical identification.

A tripod molecule with an azobenzene arm was designed as a single molecular tip for noncontact atomic force microscopy (NC-AFM). The azobenzene moiety showed photoisomerization that enabled measurements of the same position of the sample by different tip apexes with different interactions. Photoswitching behavior of the molecule synthesized and adsorbed on Au surfaces was examined and reversible switching between the trans- and cis forms was successfully confirmed by NC-AFM measurements.