Optimizing the enzymatic production of biolubricants by the Taguchi method: Esterification of the free fatty acids from castor oil with 2-ethyl-1-hexanol catalyzed by Eversa Transform 2.0.

The solvent-free esterification of the free fatty acids (FFAs) obtained by the hydrolysis of castor oil (a non-edible vegetable oil) with 2-ethyl-1-hexanol (a branched fatty alcohol) was catalyzed by different free lipases. Eversa Transform 2.0 (ETL) features surpassed most commercial lipases. Some process parameters were optimized by the Taguchi method (L16'). As a result, a conversion over 95% of the FFAs of castor oil into esters with lubricants properties was achieved under optimized reaction conditions (15 wt% of biocatalyst content, 1:4 molar ratio (FFAs/alcohol), 30 °C, 180 rpm, 96 h). The substrates molar ratio had the highest influence on the dependent variable (conversion at 24 h). FFAs/2-ethyl-1-hexanol esters were characterized regarding the physicochemical and tribological properties. Interestingly, the modification of the FFAs with 2-ethyl-1-hexanol by ETL increased the oxidative stability of the FFAs feedstock from 0.18 h to 16.83 h. The biolubricants presented a lower friction coefficient than the reference commercial mineral lubricant (0.052 ± 0.07 against 0.078 ± 0.04). Under these conditions, ETL catalyzed the oligomerization of ricinoleic acid (a hydroxyl fatty acid) into estolides, reaching a conversion of 25.15% of the initial FFAs (for the first time).

Biocatalytic production of biolubricants: Strategies, problems and future trends.

The increasing worries by the inadequate use of energy and the preservation of nature are promoting an increasing interest in the production of biolubricants. After discussing the necessity of producing biolubricants, this review focuses on the production of these interesting molecules through the use of lipases, discussing the different possibilities (esterification of free fatty acids, hydroesterification or transesterification of oils and fats, transesterification of biodiesel with more adequate alcohols, estolides production, modification of fatty acids). The utilization of discarded substrates has special interest due to the double positive ecological impact (e.g., oil distillated, overused oils). Pros and cons of all these possibilities, together with general considerations to optimize the different processes will be outlined. Some possibilities to overcome some of the problems detected in the production of these interesting compounds will be also discussed.

Biosynthesis of alkanes/alkenes from fatty acids or derivatives (triacylglycerols or fatty aldehydes).

This review summarizes the most relevant advances in the biological transformation of fatty acids (or derivatives) into hydrocarbons to be used as biofuels (biogasoline, green diesel and jet biofuel). Among the used enzymes, the fatty acid decarboxylase from Jeotgalicoccus sp. ATCC 8456 (OleTJE) stands out as a promising enzyme. OleTJE may be coupled in cascade reactions with metalloenzymes or reductases from the Old Yellow Enzymes (OYE) family to perform the hydrogenation of α-olefins into paraffins. The photodecarboxylase from Chlorella variabilis NC64A (CvFAP) is an example of coupling biocatalysis and photocatalysis to produce alkanes. Besides the (photo)decarboxylation of free fatty acids and/or triacyclglycerols to produce alkanes/alkenes, by enzymes has also been employed. The cyanobacterial aldehyde decarbonylase (cAD) from Nostoc punctiforme is an outstanding example of this kind of enzymes used to produce alkanes. Overall, these kinds of enzymes open up new possibilities to the production of biofuels from renewable sources, even if they have many limitations on the current situation. The possibilities of improving enzymes features via immobilization or coimmobilization, as well as the utilization of whole cells haves been also reviewed.

Production and characterization of alginate bilayer membranes for releasing simvastatin to treat wounds.

This study aims to produce and characterize alginate bilayer membranes composed of single membranes with varying cross-linking degrees to modulate simvastatin release, with potential to be used for wound-dressing. The single-layer and bilayer membranes were characterized by weight, thickness, surface pH, equilibrium-humidity, swelling degree, solubility, infrared spectroscopy (attenuated total reflectance Fourier-transform infrared), scanning electron microscopy, and water vapor transmission. Simvastatin diffusion and release rates were analyzed using Franz's cells; its indirect cytotoxicity was analyzed using human keratinocyte cells. The difference in the cross-linking degree (bottom and top layers) influenced the morphology of the membrane, and consequently its physical barrier properties. An in vitro release study demonstrated that the bilayer membrane could sustain drug-release for longer time as compared to the single-layer membrane, which could be potentially beneficial for long-term treatment of chronic wounds. A cell viability assay showed that simvastatin-loaded alginate membranes could be characterized as noncytotoxic, demonstrating their potential for use in wound-dressing applications.

Impact of Early Passive Exercise With Cycle Ergometer on Ventilator Interaction.

BACKGROUND: Early exercise has been recommended in critically ill patients, but its impact on subject-ventilator interaction is still unclear. Therefore, the aim of this study was to evaluate the occurrence of subject-ventilator asynchrony during passive exercise in mechanically ventilated subjects. METHODS: This study included deeply sedated subjects who were under mechanical ventilation for < 72 h. Subjects were coupled to a cycle ergometer and maintained at rest for 5 min (baseline period). After this period, they started 20 min of passive exercise, followed by 10 min of rest (recovery period). The occurrence of asynchrony was monitored by the analysis of flow and airway pressure waveforms, registered throughout the protocol during the baseline, exercise, and recovery periods. Hemodynamic and respiratory parameters were registered at the end of each period. Finally, arterial blood gas analysis was performed twice, at the end of the baseline period and at the end of the recovery period. RESULTS: 8 subjects were enrolled (63.3 ± 16.7 y old, 50% male). The asynchrony index increased during exercise (median 32.1% [interquartile range (IQR) 18.6-47.6%]), compared to baseline (median 6.6% [IQR 3.9-10.4%]), returning to initial levels during the recovery period (median 2.7% [IQR 0-12.2%]). The most frequent types of asynchrony were ineffective triggering (index of 11.8% [IQR 1.2-22.5%] during exercise, compared to 2.0% [IQR 1.4-4.4%] at baseline), and insufficient flow (index of 11.7% [IQR 4.7-19.3%] during exercise, compared to 2.0% [IQR 1.1 to 3.3%] at baseline). There were no significant changes in the hemodynamic and respiratory variables. CONCLUSIONS: Early cycle ergometer passive exercise in deeply sedated subjects can worsen subject-ventilator interaction, due to ineffective triggering and insufficient flow. Adjustments in the ventilatory parameters may be necessary to avoid asynchrony during exercise.

Sulfonated chitosan and dopamine based coatings for metallic implants in contact with blood.

Thrombosis and calcification constitute the main clinical problems when blood-interacting devices are implanted in the body. Coatings with thin polymer layers represent an acknowledged strategy to modulate interactions between the material surface and the blood environment. To ensure the implant success, at short-term the coating should limit platelets adhesion and delay the clot formation, and at long-term it should delay the calcification process. Sulfonated chitosan, if compared to native chitosan, shows the unique ability to reduce proteins adsorption, decrease thrombogenic properties and limit calcification. In this work, stainless steel surfaces, commonly used for cardiovascular applications, were coated with sulfonated chitosan, by using dopamine and PEG as anchors, and the effect of these grafted surfaces on platelet adhesion, clot formation as well as on calcification were investigated. Surface characterization techniques evidenced that the coating formation was successful, and the sulfonated chitosan grafted sample exhibited a higher roughness and hydrophilicity, if compared to native chitosan one. Moreover, sulfonated surface limited platelet activation and the process of clot formation, thus confirming its high biological performances in blood. Calcium deposits were also lower on the sulfonated chitosan sample compared to the chitosan one, thus showing that calcification was minimal in presence of sulfonate groups. In conclusion, this sulfonated-modified surface has potential to be as blood-interacting material.

Dynamic and static adsorption and desorption of Hg(II) ions on chitosan membranes and spheres.

The adsorption and desorption of Hg(II) ions was studied using static and dynamic methods, employing membranes and spheres of chitosan as the adsorbent. The quantity of adsorption was influenced by chitosan crosslinking and by the adsorbent shape. The Langmuir model was applied to fit the experimental equilibrium data. Glutaraldehyde-crosslinked membranes presented a lower desorption capacity, when compared to natural membranes, but could be regenerated for use in successive cycles. Dynamic adsorption experiments suggested that the adsorption capacity depended mainly on adsorbent geometry, due to differences between surface area to mass ratio and initial concentration of Hg(II) ions. The adsorption capacity determined by the dynamic method was 65% and 77% for membranes and spheres, respectively of the value obtained static method results. A process combining dynamic adsorption and static desorption can be used to concentrate the Hg(II) ions by a factor of nearly seven (7x), when compared to the initially treated volume.

BSA and fibrinogen adsorption on chitosan/κ-carrageenan polyelectrolyte complexes.

PECs of chitosan/κ-carrageenan are prepared in three different volumetric rations. The complex formation is characterized in order to evaluate the blending formation. Blood compatibility is evaluated by protein adsorption (BSA and fibrinogen) and PEC toxicities are determined with fibroblast cell viability and proliferation. The swelling degree of PECs decreases when the amount of chitosan increases. Due to the linked film formation, PECs decrease BSA adsorption and increase fibrinogen adsorption when compared to the pristine chitosan and κ-carrageenan films. Although pristine chitosan and κ-carrageenan films produced similar cell expansion and viability, the PEC 50:50 vol% chitosan/κ-carrageenan PEC may be acceptable as a new scaffold for cell therapies, due to their effect on cell survival.

Blood protein adsorption on sulfonated chitosan and κ-carrageenan films.

Many strategies have been reported to improve compatibility of biopolymers using chemical and physical modifications. One possibility is the introduction of sulfonate groups (R-SO3(-)) in the chitosan chain. Another biopolymer with similar characteristics to those of heparin is κ-carrageenan. This study proposed to investigate the application of these two polymers, based on their potential for globular protein adsorption (BSA and fibrinogen). Polymeric films of chitosan and κ-carrageenan were prepared; all films were characterized by elemental analyses, FTIR, XPS and SEM. Characterization techniques showed that the chitosan chain was modified and confirmed the existence of sulfonate groups, as well as in the κ-carrageenan chain, indicating surfaces with similar chemical properties to those of heparin. The effect of charge density was observed for each adsorption condition (BSA at pH 5.0 and 7.4). A more pronounced adsorption rate was observed at pH 5.0 than at pH 7.4 and equilibrium adsorption was achieved, in both cases, after approximately 20 min. The equilibrium data indicate a lower adsorption rate for the sulfonated chitosan film, in comparison to the other films. These results confirm the potential of modified chitosan for use in applications in which globular protein adsorption should be avoided.