TcPO2 Value Can Predict Wound Healing Time in Clinical Practice of CLTI Patients.

BACKGROUND: Transcutaneous oxygen pressure (TcPO2) is a noninvasive, nonradiological test to measure local oxygen released from capillaries through the skin. Since it reflects the metabolic state of the lower limb, it can predict wound healing in patients with critical limb threatening ischemia (CLTI). The purpose of this study was to determine the effectiveness of TcPO2 test in evaluating wound healing potential of patients with CLTI. METHODS: This was a retrospective, single-center, nonrandomized, and observational study. A prospectively registered database of patients who visited Vascular Surgery Department of St. Mary's Hospital for CLTI and underwent TcPO2 tests from October 1, 2015 to July 1, 2021 was reviewed. Patients were divided into 2 groups: (1) those who had amputation only; and (2) those who underwent revascularization procedures. Patients whose wound healing status could not be determined were excluded. The clinical characteristics of patients, patient characteristics related to lower TcPO2 value, treatment success rate, and time for the wound to be healed were analyzed. RESULTS: A total of 84 patients were included in this study. There was no difference in background patient characteristics between the 2 groups despite better survival within 12 months and shorter healing time in the revascularization group. A total of 76 patients survived 12 months after surgery, and 63 patients were healed. Higher HbA1c, higher serum creatinine, history of stroke, and history of coronary artery disease were related to lower TcPO2 value on multiple linear regression. The cutoff value of TcPO2 was determined to be 40 mm Hg for predicting wound healing. This value was similar to those of previous studies. In addition, there was a negative correlation between TcPO2 and wound healing time. Correlations among the anklebrachial index (ABI), toe-brachial index (TBI), and TcPO2 were not determined because ABI and TBI for some patients could not be obtained due to wound condition. CONCLUSIONS: The TcPO2 value can predict the wound healing process of ischemic lower extremity injury.

Types and doses of anti-adhesive agents injected into subacromial space do not have an effect on the clinical and anatomical outcomes after arthroscopic rotator cuff repair.

PURPOSE: Joint stiffness after arthroscopic rotator cuff repair is a major concern for orthopaedic surgeons. Various antiadhesive agents are commonly administered after rotator cuff repair for its prevention. This study aimed to compare the outcomes among patients injected with different types and amounts of anti-adhesive agents after rotator cuff repair. It was hypothesized that the outcomes might differ depending on the use of the anti-adhesive agent and its type and dose. METHODS: A total of 267 patients who underwent arthroscopic rotator cuff repair with or without subacromial injection of anti-adhesive agents were enrolled. The first group (group A; 51 patients) were injected with 3 mL of poloxamer/sodium alginate-based anti-adhesive agent. The second group (group B; 93 patients) were injected with 3 mL of sodium hyaluronate-based anti-adhesive agent. The third group (group C; 82 patients) were injected with 1.5 mL of sodium hyaluronate-based anti-adhesive agent. Finally, the last group (group D; 41 patients) who did not use anti-adhesive agents served as the control. The range of motion (ROM) and pain VAS scores were measured preoperatively and at 5 weeks, 3 months, 6 months, and 1 year postoperatively. Functional outcomes were evaluated using American Shoulder and Elbow Surgeons and Constant scores, whereas cuff integrity was assessed via MRI or ultrasonography at least 6 months postoperatively. RESULTS: All ROM measurements, pain VAS scores, and functional scores were significantly improved regardless of the use, type, and dose of the anti-adhesive agents. In addition shoulder ROM and rotator cuff healing did not significantly differ among the groups (all n.s.). CONCLUSIONS: No significant differences were found in the clinical and anatomical outcomes according to the type and dose of the anti-adhesive agents subacromially injected after rotator cuff repair. LEVEL OF EVIDENCE: III.

Femoral Tunnel Geometry and Graft Inclination Angles in Anterior Cruciate Ligament Reconstruction Using a Flexible Reamer System.

Background and Objectives: The aim of this study is to investigate the femoral tunnel geometry (femoral tunsnel location, femoral graft bending angle, and femoral tunnel length) on three-dimensional (3D) computed tomography (CT) and graft inclination on magnetic resonance imaging (MRI) after anatomic anterior cruciate ligament (ACL) reconstruction using a flexible reamer system. Materials and Methods: A total of 60 patients who underwent anatomical ACL reconstruction (ACLR) using a flexible reamer system were retrospectively reviewed. One day after the ACLR procedure was performed, all patients underwent three-dimensional computed tomography (3D-CT) and magnetic resonance imaging (MRI). The femoral tunnel location, femoral graft bending angle, femoral tunnel length, and graft inclination were assessed. Results: In the 3D-CTs, the femoral tunnel was located at 29.7 ± 4.4% in the posterior to anterior (deep to shallow) direction and at 24.1 ± 5.9% in the proximal to distal (high to low) direction. The mean femoral graft bending angle was 113.9 ± 5.7°, and the mean femoral tunnel length was 35.2 ± 3.1 mm. Posterior wall breakage was observed in five patients (8.3%). In the MRIs, the mean coronal graft inclination was 69.2 ± 4.7°, and the mean sagittal graft inclination was 52.4 ± 4.6°. The results of this study demonstrated that a comparable femoral graft bending angle and longer femoral tunnel length were observed compared with the reported outcomes from previous studies that used the rigid reamer system. Conclusions: ACLR using a flexible reamer system allowed for an anatomic femoral tunnel location and a comparable graft inclination to that of the native ACL. In addition, it achieved a tolerable femoral graft bending angle and femoral tunnel length.

Effects of a good posture belt on buttock pressure during cross-legged sitting.

[Purpose] The purpose of the present study was to examine the effects of wearing a good posture belt on buttock pressure during cross-legged sitting. [Subjects] The study subjects were 34 adults who were divided into a good posture belt group (7 men, and 10 women) and a control group (7 men, and 10 women), with 17 subjects each. [Methods] Sensor mats were used to measure buttock pressure and changes in the total travel distance of the center of pressure, maximum pressure, and mean pressure. [Results] The good posture belt group showed smaller increments in center of pressure, maximum pressure, and mean pressure than the control group. [Conclusion] The use of the good posture belt during cross-legged sitting is considered to control the increment of buttock pressure, thereby greatly helping the maintenance of efficient postures.

Improvement of Valgus Deviation of the Lesser Toes of Moderate to Severe Hallux Valgus After Proximal Chevron Metatarsal Osteotomy and Akin Osteotomy.

BACKGROUND: This study examines the correction of lesser toe valgus deviation following proximal chevron metatarsal osteotomy (PCMO) and Akin osteotomy in moderate to severe hallux valgus patients, while identifying influencing factors. METHOD: Among 89 patients (116 feet), those with moderate to severe hallux valgus underwent PCMO and Akin osteotomy. Radiologic assessments included preoperative metatarsus adductus angle (MAA), hallux valgus angle (HVA), intermetatarsal angle (IMA), valgus angles of the second to fourth metatarsophalangeal joints, and hallux valgus recurrence. Assessments included visual analog scale (VAS) pain scores, American Orthopaedic Foot & Ankle Society (AOFAS) scores, and patient satisfaction over an average follow-up of 30.6 ± 21.2 (range, 12-99) months. RESULTS: The mean preoperative HVA of 34.4 degrees decreased to 8.7 degrees at final follow-up. The valgus angles of the second, third, and fourth toes improved by 37.1%, 27%, and 44.5%, respectively. In metatarsus adductus patients, lesser toe valgus angles were significantly higher both preoperatively and at final follow-up. Hallux valgus recurrence patients had higher preoperative and final follow-up IMA and valgus angles in the second and third toes. Nonrecurrence patients showed greater decreases in these angles. A larger HVA correction corresponded to a greater decrease in lesser toe valgus deviation. VAS and AOFAS scores improved significantly at the last follow-up. CONCLUSION: The study found a significant reduction in the valgus angle of the second, third, and fourth toes after PCMO and Akin osteotomy in moderate to severe hallux valgus cases, without additional surgeries on lesser toes. The lesser toe angular reductions were less pronounced in patients with metatarsus adductus or with hallux valgus recurrence. LEVEL OF EVIDENCE: Level IV, case series.

Fundamental Study on the Development of Structural Lightweight Concrete by Using Normal Coarse Aggregate and Foaming Agent.

Structural lightweight concrete (SLWC) has superior properties that allow the optimization of super tall structure systems for the process of design. Because of the limited supply of lightweight aggregates in Korea, the development of structural lightweight concrete without lightweight aggregates is needed. The physical and mechanical properties of specimens that were cast using normal coarse aggregates and different mixing ratios of foaming agent to evaluate the possibility of creating structural lightweight concrete were investigated. The results show that the density of SLWC decreases as the dosage of foaming agent increases up to a dosage of 0.6%, as observed by SEM. It was also observed that the foaming agent induced well separated pores, and that the size of the pores ranged from 50 to 100 µm. Based on the porosity of concrete specimens with foaming agent, compressive strength values of structural lightweight foam concrete (SLWFC) were obtained. It was also found that the estimated values from proposed equations for compressive strength and modulus of elasticity of SLWFC, and values obtained by actual measurements were in good agreement. Thus, this study confirms that new structural lightweight concrete using normal coarse aggregates and foaming agent can be developed successfully.