Nylon Fabric/GO Based Self-Powered Humidity Sensor Based on the Galvanic Cell Principle with High Air Permeability and Rapid-Response.

Flexible humidity sensors have received more and more attention in people's lives, and the problems of gas permeability and power supply issues of the device have long been areas in need of improvement. In this work, inspired by the high air permeability of daily wear clothing and galvanic batteries, a self-powered humidity sensor with high air permeability and fast response is designed. A nylon fabric/GO net (as a humidity sensitive layer and solid electrolyte) is obtained by spraying technique. This structure enables the sensor to have fast response/recovery (0.78 s/0.93 s, calculated at 90% of the final value), ultra-high response (0.83 V) and excellent stability (over 150 cycles) at 35 °C. Such sensors are useful for health monitoring, such as non-contact monitoring of human respiratory rate before and after exercise, and monitoring a level of humidity in the palms, arms, and fingers. This research provides an idea for developing a flexible wearable humidity sensor that is both breathable and self-powered and can also be mass-produced similar to wearable clothing.

Pressure-Regulated Nanoconfined Channels for Highly Effective Mechanical-Electrical Conversion in Proton Battery-Type Self-Powered Pressure Sensor.

Battery-sensing-based all-in-one pressure sensors are generally successfully constructed by mimicking the information transfer of living organisms and the sensing behavior of human skin, possessing features such as low energy consumption and detection of low/high-frequency mechanical signals. To design high-performance all-in-one pressure sensors, a deeper understanding of the intrinsic mechanisms of such sensors is required. Here, a mechanical-electrical conversion mechanism based on pressure-modulated nanoconfined channels is proposed. Then, the mechanism of ion accelerated transport in graphene oxide (GO) nanoconfined channels under pressure is revealed by density functional theory (DFT) calculation. Based on this mechanism, a proton battery-type self-powered pressure sensor MoO3 /GO[CNF/Ca] /activated carbon (AC) is designed with an open-circuit voltage stabilization of 0.648 V, an ultrafast response/recovery time of 86.0 ms/93.0 ms, pressure detection ranges of up to 60.0 kPa, and excellent static/dynamic pressure response. In addition, the one-piece device design enables self-supply, miniaturization, and charge/discharge reuse, showing application potential in wearable electronics, health monitoring, and other fields.

A Zinc-Ion Battery-Type Self-Powered Pressure Sensor with Long Service Life.

Accurate and continuous pressure signal detection without external power supply is a key technology to realize the miniaturization of wearable electronic equipment, the internet of things, and artificial intelligence. However, it is difficult to be achieved by using current sensor technologies. Here, a new one-body strategy, i.e., zinc-ion battery pressure (ZIB-P) sensor technology, which designs the rechargeable solid-state ZIB itself as a flexible pressure sensor is reported. In the device, an isolation layer is introduced into the sandwich configuration solid-state battery to realize the change of device internal resistance by pressure during the transformation of the mechanical signal to the electrical signal. This battery pressure sensor possesses good flexibility, fast response/recovery time (76.0/88.0 ms), stable long-term response, excellent cycle stability (100 000 times), and wide pressure detection range (2.0 to 3.68 × 105  Pa). Especially, the excellent charge-discharge performance in the ZIB-P sensor endows it with the real-time detection ability of human vital signs (pulse, limb movement, etc.) and ultrahigh stability without degradation even under 100 000 times pressure stimulation. The ZIB-P sensor strategy provides a new solution for the future development of miniaturized wearable electronic devices.