Surface chemistry of thiomalic acid adsorption on planar gold and gold nanoparticles.

The self-assembly of thiomalic acid (TMA) on Au(111) and on preformed Au nanoparticles (AuNPs) protected by weak ligands has been studied by X-ray photoelectron spectroscopy (XPS) and electrochemical techniques. Results show that TMA is adsorbed on the Au(111) surface as thiolate species with a small amount of atomic sulfur (∼10%) and a surface coverage lower than that found for alkanethiols due to steric factors. The amount of atomic sulfur markedly increases when the TMA is adsorbed on AuNPs by the ligand exchange method. We propose that the atomic sulfur is produced as a consequence of C-S bond cleavage, a process that is more favorable at defective sites of the AuNPs surface. The bond scission is also assisted by the presence of the electron-withdrawing carboxy moiety in the α-position relative to the C-S bond. Moreover, the high local concentration of positively charged species increases the stability of the negatively charged leaving group, leading to a higher amount of coadsorbed atomic sulfur. Our results demonstrate that the terminal functionalities of thiols are conditioning factors in the final structure and composition of the adlayers.

New findings for the composition and structure of Ni nanoparticles protected with organomercaptan molecules.

Here we explore the synthesis of alkanethiol-coated Ni NPs following the one-phase reaction method by Brust et al. The reduction of NiCl2 with NaBH4 in the presence of dodecanethiol (C12SH) yields a complex product that is difficult to identify as illustrated in the figure of merit. We synthesized Ni(II) dodecanethiolate (C12S) (without the addition of NaBH4) for comparison and performed an exhaustive characterization with TEM, HR-TEM, AFM, MFM, XPS, XRD, UV-vis, magnetism, and FT-IR. It is found that the organic coating is not quite a well-organized self-assembled monolayer (SAM) surrounding the Ni cluster as previously reported. XPS and XRD data show slight differences between both syntheses; however, Ni(II) thiolate appears to be more stable than reduced Ni when exposed to ambient air, indicating the propensity of metallic Ni to oxidize. It has been shown that irradiating with TEM electrons over various metal thiolates leads to nanoparticle formation. We irradiated over Ni(II) thiolate and observed no evidence of NP formation whereas irradiating a reduced Ni sample exhibited an ~3.0 nm nanoparticle diameter. Magnetism studies showed a difference between both samples, indicating ferromagnetic character for the reduced Ni sample. According to our results, the product of the synthesis is comprised of ultrasmall metallic clusters embedded in some form of Ni(II) C12S. In this work, we open a discussion of the chemical nature of the core and the shell in the synthesis of Ni NPs protected with organomercaptan molecules.

Photothermal therapy with silver nanoplates in HeLa cells studied by in situ fluorescence microscopy.

Photothermal therapy (PTT) is a noninvasive treatment for cancer relying on the incorporation of NIR-light absorbing nanomaterials into cells, which upon illumination release heat causing thermally induced cell death. We prove that irradiation of aqueous suspensions of poly(vinylpyrrolidone)-coated silver nanoplates (PVPAgNP) or PVPAgNP in HeLa cells with red or NIR lasers causes a sizeable photothermal effect, which in cells can be visualized with the temperature sensing fluorophore Rhodamine B (RhB) using spinning disk confocal fluorescence microscopy or fluorescence lifetime imaging. Upon red-light irradiation of cells that were incubated with both, RhB and PVPAgNP at concentrations with no adverse effects on cell viability, a substantial heat release is detected. Initiation of cell death by photothermal effect is observed by positive signals of fluorescent markers for early and late apoptosis. Surprisingly, a new nanomaterial-assisted cell killing mode is operating when PVPAgNP-loaded HeLa cells are excited with moderate powers of fs-pulsed NIR light. Small roundish areas are generated with bright and fast (<1 ns) decaying emission, which expand fast and destroy the whole cell in seconds. This characteristic emission is assigned to efficient optical breakdown initiation around the strongly absorbing PVPAgNP leading to plasma formation that spreads fast through the cell.

Supramacromolecular organization of gold nanocrystals capped with amphiphilic hyperbranched polyethyleneimine.

The supramolecular structural aspects of hetero-assemblies constituted of gold nanoparticles capped with amphiphilic unimolecular micelles were studied using synchrotron-based small angle X-ray scattering (SAXS). Experimental results revealed that straightforward transfer of citrate-capped Au nanoparticles from an aqueous environment to a toluenic solution of amphiphilic hyperbranched polymers results in the spontaneous integration of the nanocrystals into the extended hydrophilic domains of self-assembled supramolecular structures. In this way, we were able to self-organize metal-polymer nanoarchitectures in solution displaying interesting thermoactive functions, i.e.: hybrid assemblies exhibiting negative thermal expansion coefficients. We consider that this strategy has potentiality to realize self-organized supramolecular hetero-assemblies as it provides an alternative methodology to spontaneously integrate nanoscale building blocks into preformed supramolecular objects.

Reducing the formation of FIB-induced FCC layers on Cu-Zn-Al austenite.

The irradiation effects of thinning a sample of a Cu-Zn-Al shape memory alloy to electron transparency by a Ga(+) focused ion beam were investigated. This thinning method was compared with conventional electropolishing and Ar(+) ion milling. No implanted Ga was detected but surface FCC precipitation was found as a result of the focused ion beam sample preparation. Decreasing the irradiation dose by lowering the energy and current of the Ga(+) ions did not lead to a complete disappearance of the FCC structure. The latter could only be removed after gentle Ar(+) ion milling of the sample. It was further concluded that the precipitation of the FCC is independent of the crystallographic orientation of the surface.

Synthesis and characterization of gold at gold(i)-thiomalate core at shell nanoparticles.

In this paper, the synthesis of gold at gold(I)-thiolate core at shell nanoparticles is described for the first time. The chemical nature and structure of these nanoparticles were characterized by a multi-technique approach. The prepared particles consist of gold metallic cores, about 1 nm in size, surrounded by stable gold(I)-thiomalate shells (Au at Au(I)-TM). These nanoparticles could be useful in medicine due to the interesting properties that gold(I)-thiomalate has against rheumatoid arthritis. Furthermore, the described results give new insights in the synthesis and characterization of metallic and core at shell nanoparticles.