RESUMEN
The design and preparation of proton-conducting metal-organic frameworks (MOFs) with superconductivity are of significance for the proton-exchange membrane fuel cell (PEMFC). Introducing functional structural defects to enhance proton conductivity is a good approach. Here, we synthesized a series of UiO-66 (first synthesized in the University of Oslo) with missing-linker defects and investigated the effect of defect numbers on the proton conductivity of the samples. Among them, 60-UiO-66-1.8 (60 represents the synthesis temperature and 1.8 the number of defects) prepared with 3-mercaptopropionic acid as a modulator has the best proton conductivity, which is 3 × 10-2 S cm-1 at 100 °C and under 98% relative humidity (RH). The acidic sites induced by missing-linker defects further promote the chemisorption of ammonia molecules, resulting in the formation of a richer hydrogen-bond network and hence boosting the proton conductivity to 1.04 × 10-1 S cm-1 at 80 °C, which is one of the highest values among the reported MOF-based proton conductor. Therefore, this work provides a new strategy for enhancing proton conduction in MOF-based materials.
RESUMEN
To understand the mechanism of the dynamic accumulation of active ingredients in Cinnamomum cassia Presl, metabolomic and transcriptomic analyses of 5~8 years old C. cassia were performed. A total of 72 phenylpropanoids, 146 flavonoids, and 130 terpenoids showed marked changes. Most phenylpropanoids and flavonoids showed markedly higher abundances in 6-year-old C. cassia than in others, which was related to the higher expression of genes that synthesize and regulate phenylpropanoids and flavonoid. We identified transcription factors (TFs) and genes involved in phenylpropanoids and flavonoids synthesis and regulation through co-expression network analyses. Furthermore, most of the terpenoids in 5-year-old C. cassia showed markedly higher abundances than in others, which was due to the differentially expressed genes upstream of the terpenoids pathway. The results of our study provide new insights into the synthesis and accumulation of phenylpropanoid, flavonoids and terpenoids in C. cassia at four growth stages.
RESUMEN
Objective: The barks, leaves, and branches of Cinnamomum cassia have been historically used as a traditional Chinese medicine, spice, and food preservative, in which phenylpropanoids are responsible compounds. However phenylpropanoid biosynthesis pathways are not clear in C. cassia. We elucidated the pathways by descriptive analyses of differentially expressed genes related to phenylpropanoid biosynthesis as well as to identify various phenylpropanoid metabolites. Methods: Chemical analysis, metabolome sequencing, and transcriptome sequencing were performed to investigate the molecular mechanisms underlying the difference of active components content in the barks, branches and leaves of C. cassia. Results: Metabolomic analysis revealed that small amounts of flavonoids, coumarine, and cinnamaldehyde accumulated in both leaves and branches. Transcriptome analysis showed that genes associated with phenylpropanoid and flavonoid biosynthesis were downregulated in the leaves and branches relative to the barks. The observed differences in essential oil content among the three tissues may be attributable to the differential expression of genes involved in the phenylpropanoid and flavonoid metabolic pathways. Conclusion: This study identified the key genes in the phenylpropanoid pathway controling the flavonoid, coumarine, and cinnamaldehyde contents in the barks, branches and leaves by comparing the transcriptome and metabolome. These findings may be valuable in assessing phenylpropanoid and flavonoid metabolites and identifying specific candidate genes that are related to the synthesis of phenylpropanoids and flavonoids in C. cassia.
RESUMEN
Different hierarchical porous In2O3 nanostructures were synthesized by regulating the hydrothermal time and combining it with a self-pore-forming method. The gas-sensing test results show that the response of the sensor based on In2O3 obtained after hydrothermal reaction for 48 h is about 10.4 to 500 ppm methane. Meanwhile, it possesses good reproducibility, stability, selectivity and moisture resistance as well as a good exponential linear relationship between the response to methane and its concentration. In particular, the sensor based on In2O3 can detect a wide range of methane (10~2000 ppm) at near-room temperature (30 °C). The excellent methane sensitivity of the In2O3 sensor is mainly due to its unique nanostructure, which has the advantages of both porous and hierarchical structures. Combined with the DFT calculation, it is considered that the sensitive mechanism is mainly controlled by the surface adsorbed oxygen model. This work provides a feasible strategy for enhancing the gas sensitivity of In2O3 toward methane at low temperatures.
RESUMEN
Ultrasensitive detection of Hg2+ in aquatic ecosystems is of great significance due to its high toxicity and ubiquity in water. Herein, using a one-step in-situ synthesis method, blue fluorescent carbon dots (CDs), red fluorescent InP/ZnS quantum dots (InPQDs), and MOFs (ZIF-8) integrated multicolor nano-sensor CDs/InPQDs@ZIF-8 was constructed for consecutive visual detection of Hg2+ and Cys. The InPQDs can act as the response unit for Hg2+ and Cys, with the limit of detection (LOD) of 8.68 and 37.96 nM, respectively. Significantly, the low detection limit combines with good specificity and accuracy of the nano-sensor meet the requirement for the safety monitoring and control of Hg2+ in drinking and environmental water. Moreover, the color recognition and processing software installed on smart phone can realize the real-time and rapid sensing of Hg2+ and Cys. A logic gate circuit was also devised, providing the possibilities for the application of the nano-sensor in the field of intelligent devices. As far as we know, this was the first example to apply InPQDs to the continuous multicolor visual detection of Hg2+ and Cys, which provided reference for the construction of environmentally-friendly dual emission fluorescent sensors for hazardous substance monitoring.
Asunto(s)
Mercurio , Puntos Cuánticos , Carbono , Cisteína , Ecosistema , Colorantes Fluorescentes , Límite de Detección , Espectrometría de Fluorescencia/métodosRESUMEN
In the title terbium coordination polymer, {[Tb(2)(C(6)H(8)O(4))(3)(H(2)O)(4)]·0.25H(2)O}(n), the Tb(III) atom is nine-coordinated, forming a TbO(9) polyhedra. Furthermore, two symmetric TbO(9) polyhedra share their edges, forming Tb(2)O(16) dimers, which are linked by adipate bridges into a layered structure. Inter-molecular O-Hâ¯O hydrogen bonds link these layers into a three-dimensional network. One of the C atoms of the adipate ligand is disordered over two positions with site-occupancy factors of 0.622â (9) and 0.378â (9). The structure also contains a disordered mol-ecule of water of hydration, lying close to a special position, with partial occupancy.
RESUMEN
Porous metal-organic frameworks (MOFs) have demonstrated a great potential in proton conduction and luminescence sensing due to functionalized nodes, ligands and channels, or pores. Herein, we prepared a hydrothermally stable Eu-MOF that also resisted acid and base using a bifunctional organic ligand containing carboxylic acid groups, which are easily coordinated to Eu ions, and Eu-phobic tetrazolyl groups as potential proton-hopping sites. The hydrogen bond network, which was constructed by the uncoordinated anionic tetrazolium and the coordinated and free water molecules, endowed this Eu-MOF with the highest proton conductivity of 4.45 × 10-2 S/cm at 373 K and 93% relative humidity. The proton conductivity of the Nafion membrane containing this Eu-MOF increased 1.74 times. More interestingly, the hybrid membrane displayed luminescence pH sensing because the changeable protonation levels of uncoordinated tetrazolium groups along with the pH tuned the emission of embedded Eu-MOFs. Such a dual-functional MOF-based hybrid membrane including proton conduction and pH sensing is reported for the first time, which could open an avenue to the more practical application for functional MOFs.