RESUMEN
This study describes the performance of a Marel conveyer vision scanner, across beef carcases (n = 102) from a wide visual marbling score range, in its ability to predict chemical intramuscular fat (IMF%), Meat Standards Australia (MSA) and AUS-MEAT marbling scores of portion steaks. Vision scanner marbling scores were acquired on fresh-cut steaks, with its predictions tested using a leave-one-out cross validation method, which demonstrated precise and accurate predictions of IMF% (R2 = 0.87; RMSEP = 1.16; slope = 0.09; bias = 0.22), MSA (R2 = 0.82; RMSEP = 70.11; slope = 0.09; bias = 17.08) and AUS-MEAT marbling (R2 = 0.79; RMSEP = 0.75; slope = 0.16; bias = 0.08). Care must be taken when calibrating devices on non-fresh-cut steak, as fresh-cut steaks produced different vision scanner marbling values suggesting different prediction equations are warranted. The Marel vision scanner prediction of visual grader scores was relatively less precise and accurate than its prediction of IMF%, however in this case it may have been due to error in the grader scores.
Asunto(s)
Carne Roja , Animales , Bovinos , Carne , Australia , Músculo EsqueléticoRESUMEN
The current Meat Standards Australia (MSA) and AUS-MEAT grading system assumes that marbling through the M. longissmus thoracis et lumborum (loin) is represented by the score of the grading site. However, studies have indicated marbling varies within the beef loin, but commercially individual portion steaks are not graded for marbling. Cube rolls from a wide phenotypic marbling range (n = 102) were collected and sliced into 15 mm portion steaks, which were imaged with a Marel vision scanner to obtain objective marbling scores. Additionally, three locations (grading site, middle, cranial) across each cube roll were tested for intramuscular fat percentage (IMF%). The effect of steak location demonstrated marked variation across the length of the cube roll for both vision scanner marbling scores and IMF%. This variation in vision scanner marbling scores, expressed in units of MSA marbling score, equated to 316 MSA units. This work suggests an opportunity for individual portion marbling measurements and segregation of individual portion cut steaks based upon their marbling levels.