Purification and characterization of a new bioscouring pectate lyase from Bacillus pumilus BK2.

An alkalophilic bacterium was isolated based on the potential of extra-cellular enzymes for bioscouring. The bacterium was identified as a new strain of Bacillus pumilus BK2 producing an extra-cellular endo-pectate lyase PL (EC 4.2.2.2). PL was purified to homogeneity in three steps and has a molecular mass of 37.3+/-4.8 kDa as determined by SDS-PAGE and an isoelectric point of pH 8.5. Peptide mass mapping by nano-LC-MS of PL revealed 15% homology with a pectate lyase from Bacillus sp. The pectate lyase exhibited optimum activity at pH 8.5 and around 70 degrees C in Tris/HCl buffer. It showed a half-life at 30 degrees C of more than 75 h. Stability decreased with increasing temperature, extremely over 60 degrees C. The enzyme did not require Ca2+ ions for activity, and was strongly inhibited by EDTA and Co2+. PL was active on polygalacturonic acid and esterified pectin, but the affinity showed a maximum for intermediate esterified pectins and decreased over a value of 50% of esterification. The best substrate was 29.5% methylated pectin. PL cleaved polygalacturonic acid via a beta-elimination mechanism as shown by NMR analysis. PL released unsaturated tetragalacturonic acid from citrus pectin and polygalacturonic acid, but did not show any side activities on other hemicelluloses. On polygalacturonic acid PL showed a Km of 0.24 gl(-1) and a vmax of 0.72 gl(-1)min(-1). The applicability of pectate lyase for the bioscouring process was tested on a cotton fabric. Removal of up to 80% of pectin was proven by means of ruthenium red dyeing and HPAEC (65%). Structural contact angle measurements clearly indicated the increased hydrophilicity of enzyme treated fabrics.

Wax removal for accelerated cotton scouring with alkaline pectinase.

A rational approach has been applied to design a new environmentally acceptable and industrially viable enzymatic scouring process. Owing to the substrate specificity, the selection of enzymes depends on the structure and composition of the substrate, i.e. cotton fibre. The structure and composition of the outer layers of cotton fibre has been established on the basis of thorough literature study, which identifies wax and pectin removal to be the key steps for successful scouring process. Three main issues are discussed here, i.e. benchmarking of the existing alkaline scouring process, an evaluation of several selected acidic and alkaline pectinases for scouring, and the effect of wax removal treatment on pectinase performance. It has been found that the pectinolytic capability of alkaline pectinases on cotton pectin is nearly 75% higher than that of acidic pectinases. It is concluded that an efficient wax removal prior to pectinase treatment indeed results in improved performance in terms of hydrophilicity and pectin removal. To evaluate the hydrophilicity, the structural contact angle (theta) was measured using an auto-porosimeter.